Éditeur(s) : HAL CCSD Elsevier
Résumé : International audience
I use GPS interseismic velocities and classic 2D elastic half-space models with a screw dislocation to estimate the long-term fault slip rate, locking depth, and the offset between the surface fault trace and the location of the dislocation below the seismogenic zone for 13 segments along 8 major strike-slip faults. Using deduced strike-slip rates and the position of the dislocation to normalize the interseismic velocities to facilitate comparison of spatial patterns of deformation, I show that no substantial differences can be detected, ruling out a large asymmetry in interseismic velocities across the 8 faults used in this study. Only the Carrizo Plain segment of the San Andreas Fault shows a significant asymmetry that cannot be explained by shifting the position of the dislocation at depth relative to the fault trace. However, the resulting perturbation is less than 10% of total strike-slip rate. Fault traces are usually curved, defining a concave side. When the dislocation at depth is significantly offset from the fault trace, the shift is always toward the block on the concave side of the fault trace. This suggests that the fault zone in the lower crust may develop a simpler geometry more consistent with relative motion across the fault than its upper seismogenic part constrained by the structural complexity of the brittle crust. Since the faults used in this study are at different times in their interseismic period, comparing the interseismic velocity fields across them allows identification of possible variations of the interseismic velocities with time. When normalized by slip rate and dislocation location, all the faults show the same interseismic strain with no significant differences between deduced locking depths. These comparisons suggest that if temporal variations occur as suggested by some dynamic earthquake cycle models, they are small and below the accuracy of the available geodetic measurements.
ISSN: 0040-1951

hal-01171753
https://hal.archives-ouvertes.fr/hal-01171753
DOI : 10.1016/j.tecto.2015.01.013

Éditeur(s) : HAL CCSD Oxford University Press (OUP)
Résumé : International audience
Sensitive instruments like strainmeters and tiltmeters are necessary for measuring slowly varying low amplitude Earth deformations. Nonetheless, laser and fibre interferometers are particularly suitable for interrogating such instruments due to their extreme precision and accuracy. In this paper, a practical design of a simple pendulum borehole tiltmeter based on laser fibre interferometric displacement sensors is presented. A prototype instrument has been constructed using welded borosilicate with a pendulum length of 0.85 m resulting in a main resonance frequency of 0.6 Hz. By implementing three coplanar extrinsic fibre Fabry-Perot in-terferometric probes and appropriate signal filtering, our instrument provides tilt measurements that are insensitive to parasitic deformations caused by temperature and pressure variations. This prototype has been installed in an underground facility (Rustrel, France) where results show accurate measurements of Earth strains derived from Earth and ocean tides, local hydro-logic effects, as well as local and remote earthquakes. The large dynamic range and the high sensitivity of this tiltmeter render it an invaluable tool for numerous geophysical applications such as transient fault motion, volcanic strain and reservoir monitoring.
ISSN: 0956-540X

hal-01265967
https://hal.archives-ouvertes.fr/hal-01265967
https://hal.archives-ouvertes.fr/hal-01265967/document
https://hal.archives-ouvertes.fr/hal-01265967/file/HCS1.pdf
DOI : 10.1093/gji/ggv358

Éditeur(s) : HAL CCSD Elsevier
Résumé : International audience
The island of Taiwan is located on the convergent boundary between the Philippine Sea plate and the Chinese continental margin. It offers very active mountain building and collapsing processes well illustrated by the rugged topography, rapid uplift and denudation, young tectonic landforms, active faulting and numerous earthquakes. In this paper, using simple models, we have estimated vertical movements and associated absolute gravity variations which can be expected along a profile crossing the southern part of the island and probably suffering the highest rates of rising. The two different tectonic styles proposed for the island, thin-skinned and thick-skinned, were taken into account. Horizontal and vertical movements were modeled by an elastic deformation code. Gravity variations due to these deformations are then modeled at a second step. They are dominated by plate and free-air effects, i.e. elevation of the topography, with several mu Gal yr(-1). By comparison, gravity changes generated by mass transfers are weak: maximum 0.1 mu Gal yr(-1) with the thin-skinned tectonic and 0.3 mu Gal yr(-1) with the thick-skinned tectonic. Though elastic rheology has limitations, this modeling offers interesting results on what gravity signal can be expected from the AGTO project (Absolute Gravity in the Taiwanese Orogen), which proposes to study the dynamic of these mountain ranges using absolute gravimetry (AG) and also including relative gravimetry (RG) and GPS measurements.
ISSN: 0264-3707

hal-00456035
https://hal.archives-ouvertes.fr/hal-00456035
DOI : 10.1016/j.jog.2009.09.004

Éditeur(s) : HAL CCSD Springer-Verlag
Résumé : The seismology is the most effective method to explore the Structure of subduction zones to great depth. The distinguishing feature of the mantle in the subduction regions is the presence of hydrated phases, which transport water into the Earth's interior and release it with dramatic local consequences, triggering earthquakes and melting. The seismological detection of these hydrous phases and geo-dynamic interpretation of flow in the hydrous mantle depend on knowledge of the anisotropic elastic properties and the characteristics of the wave propagation in anisotropic media. In this paper we briefly recall the distinguishing features of anisotropic wave propagation and the observable parameters. We suggest the Vp/Vs ratio is a physically sound parameter than can be observed by seismology in anisotropic regions of the Earth, whereas the Poisson's ratio, which is often quoted, is not directly observable and does not correspond to the characteristics of wave propagation in an anisotropic or isotropic medium. We report for the first time the ratios of Vp/Vs1 and Vp/Vs2, where Vs1 is the fastest and Vs2 slowest S-wave velocities of an anisotropic media. We present the current knowledge of the anisotropic seismic properties of hydrous minerals in the upper mantle, transition zone, and lower mantle that are stable along low temperature geotherms associated with subduction, and identify which minerals are likely to influence seismological observations because they have very high volume fractions, or very high anisotropies, or both of these.;In the upper mantle antigorite and talc are exceptionally anisotropic (Vp 71% Vs 68% and Vp 65%, Vs 68%, respectively) and chlorite is also very anisotropic for S-waves (Vp 35%, Vs 76%). Comparatively less anisotropic are hornblende (Vp 27%, Vs 31%), used as proxy for tremolite in subduction zones, and clinohumite (21.8%, Vs 15.9%). Brucite at 4 GPa (Vp 26.5%, Vs 30.9%) and the dense hydrogen magnesium silicate (DHMS) phase A at 9GPa (Vp 9.3%, Vs 17.6%) are the only hydrous minerals stable in the upper mantle that have had their elastic properties measured at in situ mantle pressures. Except for the phase A, all these minerals are more anisotropic than olivine for at least one parameter (Vp, Vs, Vp/Vs1, or Vp/Vs2). In the transition zone the major phases hydrous wadsleyite and ringwoodite C have moderate to weak anisotropies (Vp 16.3%, Vs 16.5%, and Vp 1.9%, Vs 4.4%, respectively). The DHMS Superhydrous B has a moderate anisotropy (Vp 6.9%, Vs 11.6%). At greater depth the DHMS phase D Lit 24 GPa (Vp 10.8%, Vs 18.0%) is the only hydrous phase that can transport hydrogen from the transition zone into the lower mantle. The phase D is more anisotropic for S than P waves like many of the hydrous phases. From these data it is clear that hydrous phases are in general very anisotropic. However, pressure can play a strong role in reducing anisotropy. It is the case for brucite and talc, in which increasing pressure from ambient to 4 GPa reduces the anisotropy by about 50% for both P and S waves. In contrast, the anisotropy of the DHMS phase A does not change significantly with pressure.;Our picture of the seismic anisotropy of hydrated minerals remains incomplete; the elastic properties of many have not been measured even at ambient conditions (e.g., 10 angstrom phase and phase E) or not measured in their true elastic symmetry (e.g., clinochlore). The majority of hydrous minerals have not been measured at high pressure. and none related to hydrated mantle have been measured at elevated temperature. We have shown in the few cases where hydrous minerals have been measured as a function of pressure, that this variable has an important effect oil the velocity distribution and in most cases reduces the degree of anisotropy, hence we Would expect seismic anisotropy to play a key role in the determination of the shallow structure of subduction zones in the upper mantle.
Subduction zone geodynamics

hal-00420893
https://hal.archives-ouvertes.fr/hal-00420893