Éditeur(s) : HAL CCSD Oxford University Press (OUP)
Résumé : International audience
Sensitive instruments like strainmeters and tiltmeters are necessary for measuring slowly varying low amplitude Earth deformations. Nonetheless, laser and fibre interferometers are particularly suitable for interrogating such instruments due to their extreme precision and accuracy. In this paper, a practical design of a simple pendulum borehole tiltmeter based on laser fibre interferometric displacement sensors is presented. A prototype instrument has been constructed using welded borosilicate with a pendulum length of 0.85 m resulting in a main resonance frequency of 0.6 Hz. By implementing three coplanar extrinsic fibre Fabry-Perot in-terferometric probes and appropriate signal filtering, our instrument provides tilt measurements that are insensitive to parasitic deformations caused by temperature and pressure variations. This prototype has been installed in an underground facility (Rustrel, France) where results show accurate measurements of Earth strains derived from Earth and ocean tides, local hydro-logic effects, as well as local and remote earthquakes. The large dynamic range and the high sensitivity of this tiltmeter render it an invaluable tool for numerous geophysical applications such as transient fault motion, volcanic strain and reservoir monitoring.
ISSN: 0956-540X

hal-01265967
https://hal.archives-ouvertes.fr/hal-01265967
https://hal.archives-ouvertes.fr/hal-01265967/document
https://hal.archives-ouvertes.fr/hal-01265967/file/HCS1.pdf
DOI : 10.1093/gji/ggv358

Éditeur(s) : HAL CCSD
Résumé : International audience
A fiber interferometer interfaced to 3 geo-mechanical elements is presented for applications in geophysics. The fiber sensor is based on an extrinsic fiber Fabry-Perot interferometer (EFFPI) which incorporates a modulation scheme to lock the interferometer at quadrature and to enable displacement measurements below a quarter of the interrogating wavelength. It operates over a relatively large frequency dynamic of ~500000 with a precision better than 2 nm. The fiber interferometer is next interfaced to a differential hydrostatic long baseline inclinometer, a 3-axis borehole tiltmeter and a single-axis seismometer, respectively. Results obtained demonstrate that the fiber interferometrically-interrogated instruments exhibit performances equivalent to or even surpassing those of the reference instruments employed for comparison during their deployment to an underground test site since March 2012. Keywords—modulation-based extrinsic fiber Fabry-Perot interferometer; fiber optique hydrostatic inclinometer; fiber optique borehole tiltmeter; fiber optique seismometer
IEEE SENSORS 2015
Busan, South Korea

hal-01265963
https://hal.archives-ouvertes.fr/hal-01265963
https://hal.archives-ouvertes.fr/hal-01265963/document
https://hal.archives-ouvertes.fr/hal-01265963/file/HCS3.pdf
DOI : 10.1109/ICSENS.2015.7370316

Éditeur(s) : HAL CCSD Oxford University Press (OUP)
Résumé : International audience
Tilt fluctuations can potentially reflect the response of hydrosystems to important rainfall. In this context, long baseline tiltmeters have been installed in an underground tunnel penetrating the Fontaine de Vaucluse karst to study the medium deformation related to solicitations exerted by water infiltrating the hydrosystem. The instruments monitor the tilt as well as its spatial variation. Northward tilts reaching a 1 μrad amplitude are observed consecutively to rainfalls. The tilt amplitude is highly correlated with the Fontaine de Vaucluse outlet flow fluctuations. The measured tilt signal is also relatively homogeneous over a 150 m length. Different types of structure likely to produce such observations are tested in order to identify their location with respect to the tiltmeters, their dimension as well as the amount of water level variation in the structure. Following rainfalls, the infiltration of water modifies the pore pressure, inducing a medium deformation. The hypothesis of an homogeneous surface loading on the Vaucluse plateau is first refuted since the related tilt is much lower than the one measured. The water supplied by rainfalls has to accumulate in discontinuities in order to generate a higher tilt. So, the deformation related to a pressure exerted on a fracture filled by water is assessed. A first study reveals the interest of the tilt homogeneity information that constrains strongly the fracture properties. Thus, the fracture must be located at a distance more than a few hundreds metres from the tiltmeters in order to produce a tilt homogeneous in space. If the fracture is initially dry, it must also be filled on a height higher than 150 m consecutive to a rainfall in order to generate a tilt amplitude in the same magnitude as the one measured. Then, we explore the influence of water level variations on the tilt produced by a fracture located at the interface between the saturated and unsaturated zones, which are thereby permanently flooded. Since several parameters of that model satisfactorily explain the field observations, we discuss how simultaneous geodetical observations could provide complementary information that would further constrain the geometry of the structure at the origin of the medium deformation.
ISSN: 0956-540X

insu-01408482
https://hal-insu.archives-ouvertes.fr/insu-01408482
https://hal-insu.archives-ouvertes.fr/insu-01408482/document
https://hal-insu.archives-ouvertes.fr/insu-01408482/file/Lesparre-2017.pdf
DOI : 10.1093/gji/ggw446

Éditeur(s) : HAL CCSD
Résumé : International audience
The deformation of natural systems in response to subsurface water storage and redistribution provides insightsinto the main water flow path within heterogeneous systems, including the role of faults or fractures. A longbaseline tiltmeter was installed in the low-noise underground laboratory of Rustrel (LSBB) to study the responseof the Fontaine de Vaucluse (FDV) karst hydrosystem to water cycle. Tilt data and piezometric levels recorded in aborehole close to the LSBB show a strong correlation with the discharge of the system observed at the FDV spring30 km away. Over several months, tilt data were recorded on three base lines, thus allowing, for the first time,to study the tilt gradient variation that appears homogeneous. Such information provides a significant constrainton hydrological processes leading to the measured deformation. Several deformation models were tested usingthe ADELI code to estimate the type of hydro-mechanical structure that could reproduce the measured tilt andits gradient. On one hand, models show that uniform loading at the surface produces a much smaller signal thanobserved on measured data. On the other hand, the deformation related to the filling of a fracture following aprecipitation event requires unrealistic fracture size. Finally, we found that a suitable hydro-mechanical modelcorresponds to the loading of numerous fractures at the interface between the saturated and unsaturated zones. Sucha configuration predicts a tilt distribution in agreement with observations. This study suggests that tilt networksinto a karst system should provide key observation for deciphering hydrological processes
Geophysical Research Abstracts
Vienne, Austria

insu-01308594
https://hal-insu.archives-ouvertes.fr/insu-01308594