Éditeur(s) : HAL CCSD American Geophysical Union
Résumé : International audience
Torsion experiments (inline image =3 × 10−4 s−1) were performed to investigate the large strain (γmax = 15) rheology on quartz-muscovite aggregate as analogue to pelitic rocks undergoing melting and crystallization during deformation at 300 MPa confining pressure and 750°C temperature. Microstructures reveal four distinct but gradational stages of crystal-melt interactions during deformation--(a) solid state deformation, (b) initiation and domination of partial melting, (c) simultaneous partial melting and crystallization, and (d) domination of crystallization. The microstructural stages are linked to the rheology of the deforming samples. Partial melting starts at relatively low finite shear strains (γ = 1-3) showing approximately 60% strain softening. At γ = 4-10 the partially molten bulk material shows a steady state flow at low stress. Further crystallization of new crystals at the expense of melt between γ = 10 and 15 causes weak strain hardening until the material fails by developing brittle fractures. The stress exponent (n), calculated at γ = 1, 5, and 10, increases from ∼ 3 to ∼ 43, indicating a transition from power to power law breakdown or exponential flow of the bulk system. Hydrostatic experiments for equivalent times and conditions of the torsion experiments were also conducted to evaluate the reaction kinetics and microstructures under static conditions. The new experimental data establish that partially molten rock does not flow according to a constant strain rate-dependent power law (steady state) rheology. The rheological transition from strain rate sensitive to strain rate insensitive flow is interpreted as a function of melt-crystal ratio, their mutual interactions, and the evolution of microstructures in the partially molten rock.
ISSN: 0148-0227

hal-01053709
https://hal.archives-ouvertes.fr/hal-01053709
DOI : 10.1002/2013JB010777

Éditeur(s) : HAL CCSD Springer Verlag
Résumé : International audience
In the Tifnoute Valley, three plutonic units have been defined: the Askaoun intrusion, the Imourkhssen intrusion and the Ougougane group of small intrusions. They are made of quartz diorite, granodiorite and granite and all contain abundant mafic microgranular enclaves (MME). The Askaoun granodiorite and the Imourkhssen granite have been dated by LA-ICP-MS on zircon at 558 ± 2 Ma and 561 ± 3 Ma, respectively. These granitic intrusions are subcontemporaneous to the widespread volcanic and volcano-detrital rocks from the Ouarzazate Group (580-545 Ma), marking the post-collisional transtensional period in the Anti-Atlas and which evolved towards alkaline and tholeiitic lavas in minor volume at the beginning of the Cambrian anorogenic intraplate extensional period. Geochemically, the Tifnoute Valley granitoids belong to an alkali-calcic series (high-K calc-alkaline) with typical Nb-Ta negative anomalies and no alkaline affinities. Granitoids and enclaves display positive εNd-560Ma (+0.8 to +3.5) with young Nd-TDM between 800 and 1200 Ma and relatively low 87Sr/86Sr initial ratios (Sri: 0.7034 and 0.7065). These values indicate a mainly juvenile source corresponding to a Pan-African metasomatized lithospheric mantle partly mixed with an old crustal component from the underlying West African Craton (WAC). Preservation in the Anti-Atlas of pre-Pan-African lithologies (c. 2.03 Ga basement, c. 800 Ma passive margin greenschist-facies sediments, allochthonous 750-700 Ma ophiolitic sequences) indicates that the Anti-Atlas lithosphere has not been thickened and was never an active margin during the Neoproterozoic. After a transpressive period, the late Ediacaran period (580-545 Ma) is marked by movement on near vertical transtensional faults, synchronous with the emplacement of the huge Ouarzazate Group and the Tifnoute Valley granitoids. We propose here a geodynamical model where the Tifnoute Valley granitoids as well as the Ouarzazate Group were generated during the post-collisional metacratonic evolution of the northern boundary of the West African craton. The convergence with the peri-Gondwanan active margin produced brittle fracturing of the cratonic boundary without thickening, allowing rising of magmas. The Tifnoute Valley granitoids display a metasomatized lithospheric mantle source mixed with a minor ancient (2 Ga) continental crust component from the underlying WAC.
ISSN: 0930-0708

halsde-00782152
https://hal.archives-ouvertes.fr/halsde-00782152
DOI : 10.1007/s00710-012-0245-3

Éditeur(s) : HAL CCSD Elsevier
Résumé : International audience
Synkinematic phyllosilicates in fault zones can be used to deduce the deformation mechanisms and the conditions of fault activity, as their chemical composition, crystal structure and texture can record the different stages of deformation and fluid-rock interactions. The Pic de Port Vieux, a second-order thrust related to the major Gavarnie thrust in the southern central part of the Pyrenees Axial Zone, juxtaposes Triassic pelites of the hanging wall and Cretaceous limestones of the footwall. In order to investigate the mineralogical and geochemical changes and constrain the deformation conditions of thrusting, characterization of phyllosilicates was performed along a transect in the fault hanging wall pelites. The Triassic pelites are mainly composed of quartz, calcite, phyllosilicates (chlorite and K-white mica) and ± hematite. The core fault zone thickness is estimated to be about one meter of intensively foliated green pelites, whereas the damage zone is composed of several meters of red pelites. XRD data demonstrated that the difference in color is related to hematite which is only present in the damage zone. Phyllosilicates of the damage zone are mainly inherited/diagenetic K-white mica and chlorite. In the core zone, newly formed chlorite is abundant and preferentially located in veins. It is enriched in Fe compared to the chlorite of the red pelites. The well-defined foliation in the core zone is overlaid by preferentially oriented muscovite grains which have homogeneous compositions, with less Na and relatively more Fe than mica from the red pelites. Newly formed chlorite and muscovite in the core zone are synkinematic to the fault activity. They are both related to deformation processes and fluid rock interactions. Kübler index measurements and chlorite thermometry show that synkinematic phyllosilicates have registered a temperature of 270°C ± 23°C for the damage zone and 285°C ± 28°C for the core zone which are corresponding to lower-anchizone/epizone grade conditions. Numerical modelling with the geochemical modelling program PhreeqC was performed to determine the favorable conditions for the mineralogical change between red and green pelites. It suggests that the main critical parameter favoring hematite dissolution and chlorite precipitation in the core zone, is the redox conditions. According to the model, the chemical changes in the core zone occurred due to interactions with highly reductive fluids. In addition, the hematite dissolution maybe the source of iron for newly formed phyllosilicates in the core zone that are more iron rich compared to those from the red pelites.
ISSN: 0169-1317

hal-01536006
https://hal.archives-ouvertes.fr/hal-01536006
DOI : 10.1016/j.clay.2017.05.008