Éditeur(s) : HAL CCSD Elsevier
Résumé : International audience
Paleostress orientations were calculated from fault populations at 24 sites along the SW-NE segment and five sites along the E-W. Yasin segment of the Karakoram-Kohistan Suture Zone in NW Pakistan They demonstrate the importance of combined thrusting and strike-slip faulting. However, several paleostress tensor directions are distinguished, a dominant NW-SE compression and a minor E-W compression are compatible with the recent evolution of this part of the Hindu Kush. From the lack of both systematic overprinting-relationships and spatial trend (the two tensors were obtained at different locations) we conclude that in each location any of these two shortening directions can dominate Heterogeneously distributed extension is found in some places and is likely due to local conditions These paleostress tensors substantiate a transpressional regime due to far-field Himalayan compression and document the long-term background of the seismogenic deformation in this region.
ISSN: 0743-9547

hal-00496459
https://hal.archives-ouvertes.fr/hal-00496459
DOI : 10.1016/j.jseaes.2010.01.004

Éditeur(s) : HAL CCSD American Geophysical Union
Résumé : International audience
Strain and strain rate partitioning in partially molten rocks are two of the important mechanisms that govern the process of coupling and/or decoupling of the partially molten lithosphere. Consequently, the proportion of partial melt and crystals and their network in partially molten rocks influence the degree of the partitioning along with the bulk rheology of the system. This study explores the possible role of finite strain and strain rate on the rate and volume of partial melting and crystallization in a metapelitic system undergoing deformation. Cylinders of synthetic quartz-muscovite aggregate (7: 3 volume ratio) were deformed in torsion at 750 C, 300 MPa and constant shear strain rate ((gamma) over dot = 3 x 10(-4) s(-1)) for finite shear strains (gamma) 1-15. The deformed samples were studied along the longitudinal tangential ( LT) and axial ( LA) sections to obtain the data along a range of strain rates for a given finite strain and vice versa. The results showed that deformation plays an important role on the kinetics of partial melting and crystallization. With increasing strain rate, amount and rate of crystallization comprise the volumetrically dominant process compared to partial melting at a given finite strain. In contrast, when the strain rate is constant, partial melting is the dominant process over crystallization up to moderate strain (gamma < 5). The dominant process reverses at higher strain, and the system shows more crystallization than partial melting. Application of the experimental data to geological systems implies that for metapelites a significant amount (similar to 20%) of partial melt can generate at high strain rate and moderate strain (gamma similar to 7), but at high strain (gamma = 15) the system is melt depleted. Under such conditions, decoupling should take place in brittle-ductile mode. On the other hand, rocks undergoing deformation with low strain rates and strain (gamma < 3) contain more than 25% partial melt, which can act as a major decoupling agent by localizing ductile shear zones.
ISSN: 0148-0227

hal-00617714
https://hal.archives-ouvertes.fr/hal-00617714
DOI : 10.1029/2010JB007865

Éditeur(s) : HAL CCSD American Geophysical Union
Résumé : International audience
Torsion experiments (inline image =3 × 10−4 s−1) were performed to investigate the large strain (γmax = 15) rheology on quartz-muscovite aggregate as analogue to pelitic rocks undergoing melting and crystallization during deformation at 300 MPa confining pressure and 750°C temperature. Microstructures reveal four distinct but gradational stages of crystal-melt interactions during deformation--(a) solid state deformation, (b) initiation and domination of partial melting, (c) simultaneous partial melting and crystallization, and (d) domination of crystallization. The microstructural stages are linked to the rheology of the deforming samples. Partial melting starts at relatively low finite shear strains (γ = 1-3) showing approximately 60% strain softening. At γ = 4-10 the partially molten bulk material shows a steady state flow at low stress. Further crystallization of new crystals at the expense of melt between γ = 10 and 15 causes weak strain hardening until the material fails by developing brittle fractures. The stress exponent (n), calculated at γ = 1, 5, and 10, increases from ∼ 3 to ∼ 43, indicating a transition from power to power law breakdown or exponential flow of the bulk system. Hydrostatic experiments for equivalent times and conditions of the torsion experiments were also conducted to evaluate the reaction kinetics and microstructures under static conditions. The new experimental data establish that partially molten rock does not flow according to a constant strain rate-dependent power law (steady state) rheology. The rheological transition from strain rate sensitive to strain rate insensitive flow is interpreted as a function of melt-crystal ratio, their mutual interactions, and the evolution of microstructures in the partially molten rock.
ISSN: 0148-0227

hal-01053709
https://hal.archives-ouvertes.fr/hal-01053709
DOI : 10.1002/2013JB010777

Éditeur(s) : HAL CCSD American Geophysical Union (AGU) American Geophysical Union
Résumé : International audience
The brittle to ductile transition may strongly influence hydraulic properties of rocks at the depth and temperature ranges that hydrothermal fluids circulate. To examine this transition in the context of the oceanic crust, we conducted a series of deformation experiments on a natural basalt sample at in situ oceanic crust conditions. Dilatancy was measured during deformation. The method consisted in monitoring the volume of pore fluid that flows into or out of the sample at constant pore pressure. Mechanical and microstructural observations at experimental constant strain rate of 10−5 s−1 indicated that the basalt was brittle and dilatant up to 800°C. At higher temperature, the deformation mode became macroscopically ductile and samples compacted. These observations have important implications on heat transfer and fluid migration in oceanic crust.
ISSN: 0094-8276

hal-01172352
https://hal.archives-ouvertes.fr/hal-01172352
DOI : 10.1002/2015GL063437