Éditeur(s) : University of Birmingham University of Birmingham ( Birmingham )
Résumé : Electronic version is available through the British Library Electronic Theses Online Services (ETHOS)

Droits : All rights reserved by the source institution.

Éditeur(s) : Imprimerie Typographique F. Guy Imprimerie Typographique F. Guy ( Alençon )
Résumé : (Thesis) Undergraduate thesis for a bachelor’s degree in theology from the Université de France
(Bibliography) Bibliography: p. 43-44.
Haiti
Haiti
Haiti
Haiti

01452726

Éditeur(s) : Imagen Contemporánea Imagen Contemporánea ( La Habana )
Résumé : (Bibliography) Includes bibliographical references (p. 519-526) and index.
(Statement of Responsibility) José Agustin Caballero ; ensayo introductorio, compilación y notas, Edelberto Leyva Lajara.
Cuba

47752029
2001388340
9597078090
ocm47752029

Éditeur(s) : HAL CCSD Elsevier
Résumé : International audience
We conducted triaxial compression experiments to investigate the effects of pressure, temperature and strain rate on the rheology of talc rocks. The tests were carried out at T from 25 to 860 degrees C, P from 0.1 to 300 MPa, and <(epsilon) over dot> from 0.3 to 30 x 10-5 s(-1). In addition to being very weak, there are other important differences between the mechanical behavior of talc and that of most other silicates. Deformation at all temperatures up to dehydration was accommodated by a combination of crystal plasticity, frictional sliding, and cataclasis. A transition from localized to distributed deformation occurred at P = 300 MPa and T = 400 degrees C, but this transition is ill-defined as both distributed and localized deformation were observed at P = 300 MPa and T = 600 degrees C. Unlike most silicates, both the coefficient of internal friction and the coefficient of (sliding) friction are very low and nearly equal to each other. Temperature enhances plastic deformation (kinking), and inter- and intra-granular microcracks are observed parallel to the (001) planes at all conditions. Voids are created by delamination along (001) planes at kink-band boundaries. Full crystal plasticity was not achieved under any of the conditions tested, i.e., the von Mises criterion was never satisfied. However, the strength of the aggregates remained much less than the confining pressure. These unusual properties are likely a manifestation of the pronounced mechanical anisotropy of talc at the grain scale. At T >= 750 degrees C dehydration is observed, but only along shear zones. These results suggest that feedbacks between deformation and reaction kinetics could control fluid flow in fault zones. The presence of talc can promote significant weakening and strain localization in the oceanic lithosphere, the subducting plate and the overlying mantle wedge. (c) 2008 Elsevier B.V. All rights reserved.
ISSN: 0012-821X

hal-00492706
https://hal.archives-ouvertes.fr/hal-00492706
DOI : 10.1016/j.epsl.2008.02.004

Éditeur(s) : HAL CCSD Elsevier
Résumé : International audience
We use 3-D mechanical modeling representing faults as planar surfaces with frictional properties that obey Coulomb-failure process to explore the long-term slip rates of the Altyn Tagh fault and Kunlun faults in the north Tibetan plateau. Crustal theology is simplified as an elastoplastic upper crust and a viscoelastic lower crust. Far-field GPS velocities and late Quaternary fault slip rates are used to constrain the model results. Rheological tests show that effective fault friction lower than 0.1-0.08 leads to high slip rates that fit with geologically and geodetically determined slip rates of the Kunlun fault (10-11.7 +/- 1.5 mm/yr). Meanwhile, the modeled Altyn Tagh fault reaches slip rates similar to 13.7 mm/yr to similar to 7.8 mm/yr in its central portion, between ranges of the geological slip rates. Associated with high slip rates, our model predicts that central Tibet (similar to 84 degrees E-95 degrees E) from the Altyn Tagh fault to the north of the Himalayan arc accommodates north-south shortening and east-west extension rates of similar to 10-12 mm/yr and similar to 8-10 mm/yr, respectively. We also question the widely accepted idea that interseismic strain is driven at the base of the seismogenic zone by a screw dislocation. If this assumption fails, the presented model implies that interseismic strain around large strike-slip faults could be distributed in a much broader way if the lithosphere deforms as a thin elastic plate rather than an elastic half-space with an embedded dislocation. If this distributed deformation is ignored, and the instantaneous surface deformation field modeled as that resulting from slip on a dislocation below a specified depth embedded in an elastic half-space, the estimated slip rate will inevitably be lower than the true long-term slip rate. This appears to explain why geodetic slip rates proposed for the Altyn Tagh fault (510 mm/yr) are lower than some of the geological slip rates. (C) 2008 Elsevier B.V. All rights reserved.
ISSN: 0012-821X

hal-00411926
https://hal.archives-ouvertes.fr/hal-00411926
DOI : 10.1016/j.epsl.2008.06.049