Éditeur(s) : HAL CCSD Elsevier
Résumé : International audience
During the early years of the Iceland Deep Drilling Project (IDDP), development of three distinctive technological and scientific approaches were formalised and then carried out until 2010 within a European funded project called HiTI (high temperature instruments for supercritical geothermal reservoir characterisation and exploitation). These approaches were: (1) development of several downhole instruments allowing them to function up to 300 ◦C and 400 ◦C, (2) identification of two new Na/Li cation ratio geothermometric relationships valid at very high temperature, (3) tracer testing with high temperature tolerant organic isomers and finally and (4) basalt rock deformation and petrophysical properties laboratory investigations at high temperature and pressure conditions.
ISSN: 0375-6505

hal-00921127
https://hal-brgm.archives-ouvertes.fr/hal-00921127
DOI : 10.1016/j.geothermics.2013.07.008

Éditeur(s) : HAL CCSD Elsevier Masson
Résumé : On the basis of an existing multiparameter borehole fluid sensor(p, T Cw, pH, Eh), a new downhole tool designed for 200 bars and 75 degrees C was developed to measure the spontaneous electrical potential in situ with great precision (better than a mu V). To this end, the new sensor is based on the use of unpolarizable Pb/PbCl2 electrodes either at the surface or downhole. In situ testing has demonstrated a capacity to identify several subsurface sources of natural electrical potential such as diffusion ones (membrane potential in the presence of clays, Fickian processes due to pore fluid salinity gradients), or else the electrokinetic mechanisms with gradients in pore fluid pressure. As a consequence, Multi-Sensors Electrical Tool (MuSET) might be used as an "electrical flow meter" sensitive to both horizontal and vertical fluid flow in a vertical borehole.
ISSN: 1631-0713

hal-00445251
https://hal.archives-ouvertes.fr/hal-00445251
DOI : 10.1016/j.crte.2009.07.009