Éditeur(s) : HAL CCSD American Geophysical Union
Résumé : International audience
Rheological properties of mantle minerals and rocks at temperatures (T) appropriate to much of Earth's lithosphere have remained poorly constrained, even though past experimental studies on olivine single crystals and polycrystalline aggregates have quantified the high-temperature creep mechanisms (T > 1200 degrees C). Consequently, we have performed deformation experiments on crystals of San Carlos olivine at lower temperatures, from 900 degrees to 1200 degrees C, in triaxial compression along the [101](c) direction. The experiments were carried out at a confining pressure of 300 MPa in a high-resolution gas-medium mechanical testing apparatus at differential stresses of 100 to 500 MPa. Several samples were deformed at constant displacement rate and others at constant load, in order to provide insight into possible effects of work-hardening. Under the deformation conditions investigated, little evidence of work-hardening was observed. The data follow a power-law dependence on stress, as in previous high-temperature deformation studies. The samples were, however, considerably weaker than predicted by the experimentally determined high-temperature constitutive equation for olivine crystals of this orientation from the study of Bai et al. (1991). The mechanical behavior correlates instead with the weaker of the two mechanisms (flow laws) that contribute to the high-temperature constitutive equation. Thus, our experiments demonstrate that published high-temperature constitutive equations overestimate the strength of lithospheric mantle and that the transition to low-temperature creep occurs at lower temperatures than previously inferred. Citation: Demouchy, S., S. E. Schneider, S. J. Mackwell, M. E. Zimmerman, and D. L. Kohlstedt (2009), Experimental deformation of olivine single crystals at lithospheric temperatures, Geophys. Res. Lett., 36, L04304, doi: 10.1029/2008GL036611.
ISSN: 0094-8276

hal-00420070
https://hal.archives-ouvertes.fr/hal-00420070
DOI : 10.1029/2008GL036611

Éditeur(s) : HAL CCSD Elsevier
Résumé : International audience
The continental South Armenian Block – part of the Anatolide–Tauride South Armenian microplate – of Gondwana origin rifted from the African margin after the Triassic and collided with the Eurasian margin after the Late Cretaceous. During the Late Cretaceous, two northward dipping subduction zones were simultaneously active in the northern Neo-Tethys between the South Armenian Block in the south and the Eurasian margin in the north: oceanic subduction took place below the continental Eurasian margin and intra-oceanic subduction resulted in ophiolite obduction onto the South Armenian Block in the Late Cretaceous.The paleolatitude position of the South Armenian Block before its collision with Eurasia within paleogeographic reconstructions is poorly determined and limited to one study. This earlier study places the South Armenian Block at the African margin in the Early Jurassic. To reconstruct the paleolatitude history of the South Armenian Block, we sampled Upper Devonian–Permian and Cretaceous sedimentary rocks in Armenia. The sampled Paleozoic rocks have likely been remagnetized. Results from two out of three sites sampled in Upper Cretaceous strata pass fold tests and probably all three carry a primary paleomagnetic signal. The sampled sedimentary rocks were potentially affected by inclination shallowing. Therefore, two sites that consist of a large number of samples (> 100) were corrected for inclination shallowing using the elongation/inclination method.These are the first paleomagnetic data that quantify the South Armenian Block's position in the Tethys ocean between post-Triassic rifting from the African margin and post-Cretaceous collision with Eurasia. A locality sampled in Lower Campanian Eurasian margin sedimentary rocks and corrected for inclination shallowing, confirms that the corresponding paleolatitude falls on the Eurasian paleolatitude curve. The north–south distance between the South Armenian Block and the Eurasian margin just after Coniacian–Santonian ophiolite obduction was at most 1000 km.
ISSN: 0040-1951

hal-01365871
https://hal.archives-ouvertes.fr/hal-01365871
DOI : 10.1016/j.tecto.2015.01.012