Éditeur(s) : HAL CCSD Elsevier
Résumé : In this study, I examine the strain modes of the forearc, arc and back-arc domains in arc-continent collisional settings leading to arc material subduction, delamination and/or accretion. The study focusses on two well-documented colliding island arcs: the Izu–Bonin–Mariana (IBM) arc in Japan and the Luzon arc in Taiwan, both carried by the Philippine Sea plate. Firstly, there is a body of evidence that both the IBM and the Luzon arcs were built on the same Late Jurassic to Early Cretaceous “proto-Philippine Sea Plate” crust. Their internal structure is thus more heterogeneous than expected from Paleogene or Neogene supposedly “intra-oceanic” island arcs. Secondly, those arc systems and proximal “back-arcs” have similar seismic characteristics attesting either for the presence of a middle crust with continental velocities and/or serpentinized uppermost mantle that facilitate crustal shortening/slivering and subsequent decoupling from the rest of the subducting plate. It is shown that the proximal back-arc domain (called “rear-arc” in case of paleoarc activity), overlying the mantle wedge and the subducting slab, may lose its strength if slab-derived hydration occur. Decoupling then occurs below the Moho. Arc delamination likely occurs in mid-crustal levels because middle-crust, heated by nearby magmatism, becomes weak. Accretion of arc material onto the upper plate depends on the characteristics of the arc itself and the geodynamic configuration. Most of the accreted material is probably underplated rather than frontally accreted.
ISSN: 0743-9547

hal-01243080
https://hal.archives-ouvertes.fr/hal-01243080
DOI : 10.1016/j.jseaes.2013.07.043

Éditeur(s) : HAL CCSD
Résumé : International audience
Metamorphic soles correspond to m to 500m thick tectonic slices welded beneath most of the large-scale ophiolites.They typically show a steep inverted metamorphic structure where the pressure and temperature conditions ofcrystallization increase upward (from 500100ºC at 0.50.2 GPa to 800100ºC at 1.00.2 GPa), with isogradssubparallel to the contact with the overlying ophiolitic peridotite. The proportion of mafic rocks in metamorphicsoles also increases from the bottom (meta-sediments rich) to the top (approaching the ophiolite peridotites). Thesesoles are interpreted as the result of heat transfer from the incipient mantle wedge toward the nascent slab (associatedwith large-scale fluid transfer and possible shear heating) during the first My of intra-oceanic subduction(as indicated by radiometric ages). Metamorphic soles provide therefore major constraints on early subductiondynamics (i.e. thermal structure, fluid migration and rheology along the nascent slab interface).We present a detailed structural and petrological study of the metamorphic sole from 4 major cross-sections alongthe Oman ophiolite. We show precise pressure–temperature estimates obtained by pseudosection modelling andEBSD measurements performed on both the garnet-bearing and garnet-free high-grade sole. Results allow quantificationof the micro-scale deformation and highlight differences in pressure–temperature–deformation conditionsbetween the 4 different locations, showing that the inverted metamorphic gradient through the sole is not continuousin all locations.Based on these new constraints, we suggest a new tectonic–petrological model for the formation of metamorphicsoles below ophiolites. This model involves the stacking of several homogeneous slivers of oceanic crust leadingto the present-day structure of the sole. In this view, these thrusts are the result of rheological contrasts between thesole and the peridotite as the plate interface progressively cools down. These slivers later underwent several stagesof retrogression (partly mediated by ascending fluids from the slab) from amphibolite- to prehnite/pumpellite-faciesconditions.
Geophysical Research Abstracts
Vienne, Austria

insu-01309369
https://hal-insu.archives-ouvertes.fr/insu-01309369