Éditeur(s) : HAL CCSD American Geophysical Union
Résumé : Results are reported for an acidic water flow-through experiment conducted in a fractured argillaceous limestone sample (73% carbonates). The change in fracture geometry and related parameters is reported for six data sets obtained from synchrotron X-ray microtomography experiments. High-resolution three-dimensional images of the sample allowed quantification of the changes in fracture morphology at a spatial resolution of 6 ;μm. Mineral mass loss and permeability changes in the sample were also determined. Several physico-chemical phenomena were identified during the experiment. Initial smooth fracture surfaces evolved rapidly toward rough surfaces with uneven clay coverage due to the preferential dissolution of carbonate minerals compared to clay minerals whose dissolution rate is about 106 slower. A microporous clay coating progressively developed at the fluid-rock interface during heterogeneous dissolution of the fracture, while the global dissolution rate of the fracture walls exponentially decreased. The increase in surface roughness and the presumed reorganization of clays caused a progressive reduction in permeability. During the last flow-through stage, a large decrease in sample permeability was attributed to the large removal of clay particles; this process was responsible for a dramatic collapse of the fracture walls near the sample inlet and led to the development of preferential flow pathways. The development of the clay coating also acted as a barrier to flow and mass transfer between calcite grains and bulk solution and affected transport processes within the fracture
ISSN: 0043-1397

hal-00405333
https://hal.archives-ouvertes.fr/hal-00405333
DOI : 10.1029/2006WR005379

Éditeur(s) : HAL CCSD Elsevier
Résumé : International audience
This study explores the dynamics of porosity and reactive surface area changes during porous limestone dissolution by CO2-rich water. The Sr and Ca concentrations in both the rock and the outlet solution are used to evaluate the reactive surface area changes of the two rock-forming calcites, i.e. micrite grains and sparite crystals, which have different trace element signatures. The geometric surface area measured with X-ray microtomography decreases slightly whereas the reactive surface area increases continuously with increasing porosity from 20.3 to 30.2%. Surprisingly, changes in reactive surface areas are very different between the two calcites. The reactive surface area changes in the micrite are parabolic while the reactive surface area of sparite increases greatly. The numerical model HYTEC is used to model the change in reactive surface areas during the experiment. Different geometrical models are tested. The model based on spherical-grain dissolution and spherical-pore growth fails to reproduce the experimental results, while the sugar-lump model provides reasonable agreement with the experiment.
ISSN: 0009-2541

hal-00445274
https://hal.archives-ouvertes.fr/hal-00445274
DOI : 10.1016/j.chemgeo.2009.01.032

Éditeur(s) : HAL CCSD
Résumé : International audience
RST 2008
Nancy, France

hal-00569242
https://hal-mines-paristech.archives-ouvertes.fr/hal-00569242