Éditeur(s) : HAL CCSD Elsevier
Résumé : International audience
Synthetic hydroxylated titanium-bearing and undoped MgO-buffered forsterite crystals were heated at atmospheric pressure in air at temperatures from 800 to 1200 °C to determine hydrogen diffusion as a function of the type of point-defect mechanism by which the hydroxyl is incorporated. OH-stretching bands, measured by infrared spectroscopy, were assigned to the four substitution mechanisms: Ti-clinohumite point defects, silicon and magnesium vacancies, and point defects associated with trivalent cations. In the experiments at 800 to 1000 °C, hydrous defects related to trivalent cations and Mg-vacancies disappear first in the Ti-doped forsterite, followed by the hydrous defects related to Ti and a fraction of the hydrated Si-vacancies. Measured bulk diffusion coefficients for hydrogen exchange related to the latter process are one order of magnitude slower than previously reported and with higher activation energy (View the MathML source296±14 kJmol−1). After the elimination of the defects related to Ti, the hydroxyl concentration related to Si-vacancies remained constant for the duration of the experiments. This observation is in agreement with the very slow diffusivity of hydrogen in Si-vacancies measured in the undoped MgO-buffered dehydroxylation experiments at higher temperatures (from 1000 to 1200 °C), which were ∼3 orders of magnitude slower than previously reported at 1000 °C, and with an activation energy of View the MathML source461±11 kJmol−1. Hydrogen diffusion in forsterite is far more complex than previously assumed. This complexity can be used to gain more information on the timescales of the processes causing olivine to lose its structural “water”, but quantitative modeling will require not only the knowledge of the intrinsic diffusivities of the different hydrous defects but also their relative proportions and the possible reactions between them.
ISSN: 0012-821X

hal-01172253
https://hal.archives-ouvertes.fr/hal-01172253
DOI : 10.1016/j.epsl.2014.01.055

Éditeur(s) : HAL CCSD Mineralogical Society of America
Résumé : International audience
The effect of trace concentrations of Ti on the rate and mechanism of hydrogen diffusion in pure forsterite was investigated experimentally. Forsterite doped with 350–400 ppm Ti (predominantly octahedral Ti3+, minor tetrahedral Ti4+) was prepared by diffusing Ti into pure synthetic forsterite at high temperature (1500 °C), very low oxygen fugacity (~QFM-5) at atmospheric pressure. The Ti-doped forsterite was then diffusively hydroxylated in a piston-cylinder apparatus at much lower temperatures (650–1000 °C) and higher oxygen fugacities, at 1.5–2.5 GPa, with chemical activities buffered by forsterite-enstatite or forsterite-periclase and partial pressure of H2O equal to total pressure. This produced hydrogen concentration-distance profiles of several hundred micrometers in length. Diffusion of hydrogen through the Ti-doped forsterite, even at very high Embedded Image , does not lead to redox re-equilibration of the high Ti3+/ΣTi ratio set during the synthesis of the starting material at extremely reducing conditions—the metastable point defects are partially preserved.Three main hydroxylated point defects are observed; hydroxyl is associated with Ti4+ (titano-clinohumite point defects), Ti3+ (and possibly other trivalent cations), and M-site vacancies. Concentration-distance profiles represent an interplay between diffusion and reaction (i.e., site rearrangement) to form the observed point defects. In all experiments, the concentration-distance profiles of the hydroxylated Ti defects coincide with the concentration-distance profiles of the M-site vacancy substitution, with the same crystallographic anisotropy. This suggests that the macroscopic movement of hydrogen through the crystal is due to one diffusion mechanism (the diffusion of hydroxylated M-site vacancies). The net H diffusion coefficient [logD(ΣH)], between 650–1000 °C, is Embedded Image where the values of logD0(ΣH) parallel to [100] and [001] directions are −3.0 ± 0.4 and −2.2 ± 0.4, respectively; diffusion is therefore around one order of magnitude faster along the c axis than along the a axis. The diffusion of hydrogen is slightly faster in Ti-doped forsterite than in pure forsterite. There is no effect of chemical activity or oxygen fugacity on the rate of diffusion. Hydrogen diffusion profiles represent a complex interplay between the movement of H through the crystal lattice and point-defect reactions to maintain charge balance.
ISSN: 0003-004X

hal-01467402
https://hal.archives-ouvertes.fr/hal-01467402
DOI : 10.2138/am-2016-55681571