Éditeur(s) : HAL CCSD Elsevier
Résumé : International audience
This study addresses the mechanical and chemical behavior of allanite during shear zone formation under high-pressure metamorphism. Understanding physico-chemical processes related to the retention or resetting of Pb isotopes in allanite during geological processes is essential for robust petrochronology. Dating of allanite in meta-granodiorite showing variable amounts of strain (from an undeformed protolith to mylonite) at Monte Mucrone (Sesia Zone, NW Italy) gave surprising results. Based on structural and petrographic observations the shear zones at Mt Mucrone are Alpine, yet allanite located within an eclogite facies mylonite yielded Permian ages (208Pb/232Th average age: 287 ± 7 Ma). These mm-sized allanite grains are rimmed by an aggregate of coarse-grained garnet + phengite, thought to derive from former epidote. These aggregates were immersed in a weak matrix that experienced granular flow, and they were thus chemically and mechanically shielded during Alpine mylonitization. In undeformed samples (8a and 8b), two populations of epidote group minerals were found. Allanite forms either coronas around Permian monazite or individual grains with patchy zoning. Both types yield Permian ages (208Pb/232Th age: 291 ± 5 Ma). On the other hand, grains of REE-rich clinozoisite of Cretaceous age are found in undeformed rocks. These grains appear as small fragments with embayed surface outlines and minute satellites or rims around Permian allanite. These (re)crystallized grains are Sr-rich and show mosaic zoning. These results indicate that allanite crystals retained their chemical and isotopic characteristics, and thus their Permian age, as a result of strong strain partitioning between the epidote group porphyroclasts and the eclogite facies matrix in HP-mylonites. The observed partial mobilization of Pb isotopes, which lead to the Cretaceous-aged rims or grains in undeformed samples was facilitated by (re)crystallization of allanite and not by mere Pb diffusion alone under the HP conditions.
ISSN: 0024-4937

insu-00679730
https://hal-insu.archives-ouvertes.fr/insu-00679730
DOI : 10.1016/j.lithos.2011.01.005

Éditeur(s) : HAL CCSD Oxford University Press (OUP)
Résumé : International audience
The diffusion of titanium along with Ni, Co and Mn in pure synthetic forsterite has been studied as a function of temperature, oxygen fugacity, crystallographic orientation and chemical potentials in the four-component system MgO–SiO2–TiO2–TiO1·5. In over 100 different experimental conditions, no Ti diffusion profiles with the classical shape of the error function were observed. Instead, the profiles vary between ‘stepped’ at high fO2 (probably owing to diffusion on octahedral sites and trapping in tetrahedral sites), to hockey-stick shapes at low fO2 owing to concentration-dependent diffusion. The profile shapes vary systematically between these end-members according to oxygen fugacity. These profile shapes are also reproduced in experiments using natural San Carlos olivine. The change in profile shape is interpreted to be a function of valence-state change from Ti4+ to Ti3+, shown by a sigmoidal log fO2–diffusivity relationship. To distinguish between Ti4+ and Ti3+ in forsterite, a diffusion profile was also investigated using ‘hydroxylation spectroscopy’ whereby a crystal from a diffusion experiment was hydroxylated by annealing in an H2O-rich fluid at moderate pressure and temperature. The point defects associated with the added structural OH were then determined by infrared spectroscopy, providing evidence for the presence of Ti4+ and Ti3+ at intermediate oxygen fugacity. The transition from Ti4+ to Ti3+ occurs at considerably higher fO2 in these diffusion experiments than in equilibrium experiments in similar systems. Titanium diffusion, qualified using a mobility parameter (M), is fastest along the c-axis, at high activity of silica, low oxygen fugacity and high temperature. The rate of Ti diffusion is broadly similar to those of Mn, Ni and Co, and closer to published rates of Mg self-diffusion in olivine than Si self-diffusion. The observed Ti3+ and Ti4+ diffusion occurs on the M-sites. From statistical examination of the large Mn, Ni and Co diffusivity dataset, we determine that there is a 102/3 dependence of diffusion on aSiO2; the cations diffuse more rapidly at high aSiO2. In addition, diffusivity has a 10–1/8 dependence on fO2, suggested to be the result of increased concentration of loosely bound Ti3+–vacancy pairs, which enhance the mobility of other cations. This behaviour is likely to be present in natural systems where trivalent (e.g. Fe3+, Al3+, Cr3+) and divalent cations diffuse together. Consideration should be given to diffusive interference by highly charged, fast-moving cations when extracting time scales from frozen diffusion profiles.
ISSN: 0022-3530

hal-01531344
https://hal.archives-ouvertes.fr/hal-01531344
DOI : 10.1093/petrology/egw067