Éditeur(s) : HAL CCSD AGU and the Geochemical Society
Résumé : International audience
How reliable are shear wave splitting measurements as a means of determining mantle flow direction? This remains a topic of debate, especially in the context of subduction. The answer hinges on whether our current understanding of mineral physics provides enough to accurately translate between seismic observations and mantle deformation. Here, we present an integrated model to simulate strain-history-dependent texture development and estimate resulting shear wave splitting in subduction environments. We do this for a mantle flow model that, in its geometry, approximates the double-sided Molucca Sea subduction system in Eastern Indonesia. We test a single-sided and a double-sided subduction case. Results are compared to recent splitting measurements of this region by Di Leo et al. (2012a). The setting lends itself as a case study, because it is fairly young and, therefore, early textures from the slab's descent from the near surface to the bottom of the mantle transition zone--which we simulate in our models--have not yet been overprinted by subsequent continuous steady state flow. Second, it allows us to test the significance of the double-sided geometry, i.e., the need for a rear barrier to achieve trench-parallel subslab mantle flow. We demonstrate that although a barrier amplifies trench-parallel subslab anisotropy due to mantle flow, it is not necessary to produce trench-parallel fast directions per se. In a simple model of A-type olivine lattice-preferred orientation and one-sided subduction, trench-parallel fast directions are produced by a combination of simple shear and extension through compression and pure shear in the subslab mantle.
ISSN: 1525-2027

hal-01053506
https://hal.archives-ouvertes.fr/hal-01053506
DOI : 10.1002/2013GC005032

Éditeur(s) : HAL CCSD Oxford University Press (OUP)
Résumé : International audience
Detailed structural and petrological mapping in the Beni Bousera peridotite (Rif Belt, northern Morocco) shows that this orogenic peridotite massif is composed of four tectono-metamorphic domains with consistent kinematics, marked by a pervasive, shallowly dipping foliation with a NW-SE stretching lineation that progressively rotates towards a NNE-SSW orientation in the lowermost part of the massif. From top to bottom, these domains are garnet-spinel mylonites, Ariègite subfacies fine-grained porphyroclastic spinel peridotites, Ariègite-Seiland subfacies porphyroclastic, and Seiland subfacies coarse-porphyroclastic to coarse-granular spinel peridotites. Microstructures and crystal preferred orientations point to deformation dominantly by dislocation creep in all domains, but the continuous increase in average olivine grain size indicates decreasing plastic work rates from top to bottom. This evolution in deformation conditions is consistent with the change in synkinematic pressure and temperature conditions, from 900°C at 2*0 GPa in garnet-spinel mylonites to 1150°C at 1*8 GPa in the Seiland domain. A pervasive diffuse dunitic-websteritic layering subparallel to the foliation suggests deformation in the presence of melt in the Seiland domain. Gravitational instabilities owing to local melt accumulation may account for <200 m wide areas exhibiting a vertical lineation in this domain. To account for the consistent kinematics and the tectono-metamorphic evolution, which implies a temperature gradient of c. 125°C km−1 preserved across the Beni Bousera massif, we propose that the entire massif records the functioning of a low-angle shear zone, a few kilometres wide, which accommodated exhumation of the base of the lithosphere from ∼90 to ∼60 km depth. Partial melting in the Seiland domain may be explained by fast decompression of the footwall, without the need for exotic heat sources. Moreover, if the present-day orientation of the shear zone is similar to that when it was active in the mantle, the stretching lineations at high angle to the metamorphic gradient imply that shearing parallel to the trend of the belt accompanied thinning; that is, a transtensional deformation of the margin.
ISSN: 0022-3530

hal-00950056
https://hal.archives-ouvertes.fr/hal-00950056
DOI : 10.1093/petrology/egt067

Éditeur(s) : HAL CCSD Springer Verlag (Germany) Springer Verlag
Résumé : Dehydration reactions result in minerals’ replacement and a transient fluid-filled porosity. These reactions involve interface-coupled dissolution–precipitation and might therefore lead to fixed crystallographic orientation relations between reactant (protolith) and product phases (i.e. topotaxy). We investigate these two phenomena in the dehydration of a foliated antigorite (atg) serpentinite by comparing the crystallographic preferred orientation (CPO) developed by olivine (ol), orthopyroxene (opx) and chlorite (chl) during high-pressure antigorite and chlorite dehydration in piston-cylinder experiments and in natural samples recording the dehydration of antigorite (Cerro del Almirez, Betic Cordillera, Spain). Experiments were performed under undrained conditions resulting in fluid-filled porosity and in strong CPO of the prograde minerals, controlled by the pre-existing antigorite CPO in the reactant foliated serpentinite. The orientation of a ol,opx and c∗chl is parallel to c∗atg from the protolith. The Cerro del Almirez samples show similar, locally well-developed topotactic relations between orthopyroxene, chlorite and antigorite, but the product CPOs are weaker and more complex at the thin section scale. In contrast to the experiments, olivine from natural samples shows a weak correlation between b ol and the former c∗atg. We relate the strengthening of local topotactic relations and the weakening of the inherited CPO at a larger scale in natural samples to compaction and associated fluid migration. Microstructural features that might be related to compaction in the natural samples include: (1) smooth bending of the former foliation, (2) gradual crystallographic misorientation (up to 16°) of prismatic orthopyroxene due to buckling by dislocation creep, (3) inversion of enstatite to low clinoenstatite (P21/c) along lamellae and (4) brittle fracturing of prismatic orthopyroxene enclosed by plastically deformed chlorite. The coexistence of orthopyroxene buckling and clinoenstatite lamellae enables estimating the local strain rates and shear stresses generated during compaction. An lower bound for the strain rates in the order of 10−12 to 10−13 s−1 and shear stresses of 60–70 MPa are estimated based on creep data. Lower shear stresses (20–40 MPa) are retrieved using a theoretical approach. These data point to slow compaction (and fluid extraction) in nature if the system is not perturbed by external forces, with rates only marginally higher than the viscoplastic deformation of the solid matrix.
ISSN: 0010-7999

hal-01174158
https://hal.archives-ouvertes.fr/hal-01174158
DOI : 10.1007/s00410-015-1129-4

Éditeur(s) : HAL CCSD Elsevier
Résumé : International audience
We carried out detailed petrographic, major and trace element geochemical, microstructural and FTIR analyses on eight characteristic ultramafic xenoliths from Nyos and Barombi Mbo Lakes in the continental sector of the Cameroon Volcanic Line (CVL). The studied xenoliths are spinel lherzolites showing lithologies similar to the other xenoliths reported previously along the CVL. They have protogranular and porphyroclastic textures. One of the Barombi xenolith contains amphibole, which had not been previously reported in this locality. Amphibole is common in the Nyos xenoliths suite. Peridotite xenoliths from both localities show some chemical heterogeneity, but Barombi xenoliths generally are less depleted in basaltic elements with respect to Nyos xenoliths. Trace element compositions of Nyos spinel lherzolites show a moderately depleted initial (premetasomatic) composition and variable enrichment in REE. Evidence for both modal and cryptic metasomatism is present in Nyos xenoliths. Rare earth element patterns of clinopyroxene suggest that interaction between mafic melts and the upper mantle occurred beneath the Nyos locality. Barombi Mbo xenoliths, on the other hand, record a small degree of partial melting. The Barombi Mbo xenoliths have weak, dominantly orthorhombic olivine crystal preferred orientations, whereas Nyos ones have strong axial-[010] patterns, which may have formed in response to transpression. Nominally anhydrous mantle minerals (NAMs) of the Barombi Mbo xenoliths show generally higher bulk concentrations of ‘water’ (70–127 ppm) than Nyos xenoliths (32–81 ppm). The Barombi Mbo xenoliths could originate from a juvenile segment of the lithospheric mantle, which had been originally part of the asthenosphere. It became a part of the lithosphere in response to thermal relaxation following the extension, forming a weakly deformed lower lithospheric mantle region along the CVL. The Nyos xenoliths, however, represent a shallow lithospheric mantle bearing imprints of several depletion and enrichment events probably prior or following the extension (at ∼30 Ma).
ISSN: 0899-5362

hal-01236039
https://hal.archives-ouvertes.fr/hal-01236039
DOI : 10.1016/j.jafrearsci.2015.07.006

Éditeur(s) : HAL CCSD Elsevier
Résumé : International audience
The lithospheric mantle is intrinsically heterogeneous and anisotropic. These two properties govern the repartition of deformation, controlling intraplate strain localization and development of new plate boundaries. Geophysical and geological observations provide clues on the types, ranges, and characteristic length scales of heterogeneity and anisotropy in the lithospheric mantle. Seismic tomography points to variations in geothermal gradient and hence in rheological behavior at scales of hundreds of km. Seismic anisotropy data substantiate anisotropic physical properties consistent at scales of tens to hundreds of km. Receiver functions imply lateral and vertical heterogeneity at scales < 10 km, which might record gradients in composition or anisotropy. Observations on naturally deformed peridotites establish that compositional heterogeneity and Crystal Preferred Orientations (CPOs) are ubiquitous from the mm to the km scales. These data allow discussing the processes that produce/destroy heterogeneity and anisotropy and constraining the time scales over which they are active. This analysis highlights: (i) the role of deformation and reactive percolation of melts and fluids in producing compositional and structural heterogeneity and the feedbacks between these processes, (ii) the weak mechanical effect of mineralogical variations, and (iii) the low volumes of fine-grained microstructures and difficulty to preserve them. In contrast, olivine CPO and the resulting anisotropy of mechanical and thermal properties are only modified by deformation. Based on this analysis, we propose that strain localization at the plate scale is, at first order, controlled by large-scale variations in thermal structure and in CPO-induced anisotropy. In cold parts of the lithospheric mantle , grain size reduction may contribute to strain localization, but the low volume of fine-grained domains limits this effect.
ISSN: 0040-1951

hal-01277174
https://hal.archives-ouvertes.fr/hal-01277174
DOI : 10.1016/j.tecto.2015.07.026