Éditeur(s) : HAL CCSD Elsevier
Résumé : International audience
Deep crustal and mantle rocks are exhumed in core complex mode of extension in three types of structures: metamorphic core complexes, oceanic core complexes and magma poor passive margins. Using available analogue and numerical models and their comparison with natural examples, the present paper reviews the mechanical processes involved in these different types of extensional setting. Three main aspects are considered: i) the primary role of lithosphere rheology, ii) the lithosphere-scale patterns of progressive deformation that lead to the exhumation of deep metamorphic or mantle rocks and iii) the initiation and development of detachment zones. Crustal core complexes develop in continental lithospheres whose Moho temperature is higher than 750 °C with “upper crust-dominated” strength profiles. Contrary to what is commonly believed, it is argued from analogue and numerical models that detachments that accommodate exhumation of core complexes do not initiate at the onset of extension but in the course of progressive extension when the exhuming ductile crust reaches the surface. In models, convex upward detachments result from a rolling hinge process. Mantle core complexes develop in either the oceanic lithosphere, at slow and ultra-slow spreading ridges, or in continental lithospheres, whose initial Moho temperature is lower than 750 °C, with “sub-Moho mantle-dominated” strength profiles. It is argued that the mechanism of mantle exhumation at passive margins is a nearly symmetrical necking process at lithosphere scale without major and permanent detachment, except if strong strain localization could occur in the lithosphere mantle. Distributed crustal extension, by upper crust faulting above a décollement along the ductile crust increases toward the rift axis up to crustal breakup. Mantle rocks exhume in the zone of crustal breakup accommodated by conjugate mantle shear zones that migrate with the rift axis, during increasing extension.
ISSN: 0040-1951

insu-01610186
https://hal-insu.archives-ouvertes.fr/insu-01610186
https://hal-insu.archives-ouvertes.fr/insu-01610186/document
https://hal-insu.archives-ouvertes.fr/insu-01610186/file/brun-tect-2017.pdf
DOI : 10.1016/j.tecto.2017.09.017

Éditeur(s) : HAL CCSD
Résumé : International audience
Aegean extension is a process driven by slab rollback that, since 45 Ma, shows a twostage evolution. From Middle Eocene to Middle Miocene it is accommodated by localized deformation leading to i) the exhumation of high-pressure metamorphic rocks from mantle to crustal depths, ii) the exhumation of high-temperature rocks in core complexes and iii) the deposition of Paleogene sedimentary basins. Since Middle Miocene, extension is distributed over the whole Aegean domain giving a widespread development of onshore and offshore Neogene sedimentary basins. We reconstructed this two-stage evolution in 3D at Aegean scale by using available ages of metamorphic and sedimentary processes, geometry and kinematics of ductile deformation, paleomagnetic data and available tomographic models. The restorationmodel shows that the rate of trench retreat was around 0.6 cm/y during the first 30 My and then accelerated up to 3.2 cm/y during the last 15 My. The sharp transition observed in the mode of extension, localized versus distributed, which occurred in Middle Miocene correlates with the acceleration of trench retreat and is more likely a consequence of the Hellenic slab tearing documented by mantle tomography. The development of large dextral NE-SW strike-slip faults during the second stage of Aegean extension, since Middle Miocene, is illustrated by the 450 Km-long fault, recently put in evidence, offshore from Myrthes to Ikaria and onshore from Izmir to Balikeshir, in western Anatolia. Therefore, the interaction between the Hellenic trench retreat and the westward displacement of Anatolia started in Middle Miocene,almost 10 Ma before the propagation of the North Anatolian Fault in the North Aegean. This raises a fundamental issue concerning the dynamic relationship between slab tearing and Anatolia displacement
ISSN: 0438-9557

insu-01574659
https://hal-insu.archives-ouvertes.fr/insu-01574659
https://hal-insu.archives-ouvertes.fr/insu-01574659/document
https://hal-insu.archives-ouvertes.fr/insu-01574659/file/EFFECTS_OF_SLAB_ROLLBACK_ACCELERATION_ON_AEGEAN_EX.pdf
DOI : 10.12681/bgsg.11697

Éditeur(s) : HAL CCSD Elsevier
Résumé : International audience
The initiation and subsequent evolution of intra-plate orogens, resulting from continental plate interior deformation due to transmission of stresses over large distances from the active plate boundaries, is controlled by lateral and vertical strength contrasts in the lithosphere. We present lithospheric-scale analogue models combining 1) lateral strength variations in the continental lithosphere, and 2) different vertical rheological stratifications. The experimental continental lithosphere has a four-layer brittle–ductile rheological stratification. Lateral heterogeneity is implemented in all models by increased crustal strength in a central narrow block. The main investigated parameters are strain rate and strength of the lithospheric mantle, both playing an important role in crust–mantle coupling. The experiments show that the presence of a strong crustal domain is effective in localizing deformation along its boundaries. After deformation is localized, the evolution of the orogenic system is governed by the mechanical properties of the lithosphere such that the final geometry of the intra-plate mountain depends on the interplay between crust–mantle coupling and folding versus fracturing of the lithospheric mantle. Underthrusting is the main deformation mode in case of high convergence velocity and/or thick brittle mantle with a final asymmetric architecture of the deep lithosphere. In contrast, lithospheric folding is dominant in case of low convergence velocity and low strength brittle mantle, leading to the development of a symmetric lithospheric root. The presented analogue modelling results provide novel insights for 1) strain localization and 2) the development of the asymmetric architecture of the Pyrenees.
ISSN: 0012-821X

hal-01243577
https://hal.archives-ouvertes.fr/hal-01243577
DOI : 10.1016/j.epsl.2015.05.022

Éditeur(s) : HAL CCSD Elsevier
Résumé : International audience
In the Schistes Lustres of Alpine Corsica (France) serpentinized mantle rocks are associated with continental basement and meta-volcanic/-seclimentary cover rocks. The relationships among these different lithologies are especially well exposed in the Monte San Petrone unit, where Alpine metamorphism reached lawsonite-eclogite conditions. The contact between serpentinites and slivers of continental basement, relatively flat-lying over several kilometers, is characterized by evidence of cataclastic deformation pre-dating Alpine High-Pressure ductile fabrics. The serpentinite/continental basement pair is stratigraphically overlain by metasediments with a typical Jurassic-Cretaceous supra-ophiolitic lithostratigraphy, with metaradiolarites passing upward to marbles and cal cschists. Noticeably, no evidence of cataclastic deformation is found in metasediments. These observations indicate that the lithostratigraphy of the Monte San Petrone unit was established during a pre-Alpine polyphase evolution, which culminated in extensive brittle deformation along a flat-lying detachment fault prior to the deposition of Jurassic sediments. We suggest that the inferred Mesozoic extensional tectonics were related to the opening of the Westem Tethys. The Mesozoic architecture of the Monte San Petrone area, which is typical of an Ocean-Continent Transition (OCT) zone, was preserved despite Alpine deformation and metamorphism, when the different lithologies (i.e. meta-ophiolites, continent-derived rocks and metasediments) underwent a common metamorphic evolution, culminating at T=490-550 degrees C and P= 2.2-2.6 GPa. Similar tectonostratigraphic associations are observed in other high-pressure terranes of Alpine Corsica, suggesting that inherited OCT-type domains may be common in Alpine-type orogens.
ISSN: 0024-4937

hal-00617744
https://hal.archives-ouvertes.fr/hal-00617744
DOI : 10.1016/j.lithos.2011.02.013

Éditeur(s) : HAL CCSD Elsevier
Résumé : International audience
We report microstructural evidence for fluid-assisted ductile strain localization in a ≤ 50 m-wide mylonitic–ultramylonitic shear zone in the Ronda Peridotite massif, Southern Spain. Strain localization occurred at relatively low pressure (< 0.8 GPa) and moderate temperature (750–1000 °C). Initial deformation by dislocation creep resulted in formation of mylonites. Focusing of aqueous fluids in the shear zone favored the activation of dissolution–precipitation creep, resulting in further strain localization. This process is recorded by two generations of ultramylonitic bands composed of fine-grained, well-mixed olivine–orthopyroxene aggregates. Microstructural observations in the ultramylonites suggest alternating dissolution and precipitation of olivine and orthopyroxene, which may be explained by local changes in silica molality of the percolating fluid (disequilibrium and mass transfer at scales > mm). In the mylonites, olivine shows a crystal preferred orientation (CPO) coherent with dominant (001)[100] glide, probably due to the presence of interstitial fluids during deformation. In the ultramylonites, olivine CPO is weak to very weak, consistently with a decreasing contribution of dislocation creep to deformation. In contrast, fine-grained orthopyroxene in both mylonites and ultramylonites displays a clear CPO characterized by a [001] maximum normal to the foliation, which is not consistent with dislocation glide in any known slip system for orthopyroxene. We interpret this CPO as formed by oriented crystallization during dissolution–precipitation. In the present study, dissolution–precipitation creep predominates only in small-scale ultramylonite bands due to limited fluid availability and localized dynamic permeability. However, this process may be important in intermediate temperature domains of subduction zones, where it may lead to a feedback between strain localization and fluid transport.
ISSN: 0024-4937

hal-01395122
https://hal.archives-ouvertes.fr/hal-01395122
DOI : 10.1016/j.lithos.2016.07.038

Éditeur(s) : HAL CCSD European Geosciences Union
Résumé : International audience
An increasing number of field examples in mountain belts show that the formation of passive margins during extreme continent thinning may occur under conditions of high to very high thermal gradient beneath a thin cover of syn-rift sediments. Orogenic belts resulting from the tectonic inversion of distal margins and regions of exhumed continental mantle may exhibit high-temperature, low-pressure (HT-LP) metamorphism and coeval syn-extensional, ductile deformation. Recent studies have shown that the northern flank of the Pyrenean belt, especially the North Pyrenean Zone, is one of the best examples of such inverted hot, passive margin. In this study, we provide a map of HT-LP metamorphism based on a data set of more than 100 peak-temperature estimates obtained using Raman spectroscopy of the carbona-ceous material (RSCM). This data set is completed by previous PT (pressure and temperature) estimates based on mineral assemblages, and new 40 Ar– 39 Ar (amphibole, micas) and U–Pb (titanite) ages from metamorphic and magmatic rocks of the North Pyrenean Zone. The implications on the geological evolution of the Cretaceous Pyrenean paleomar-gins are discussed. Ages range mainly from 110 to 90 Ma, and no westward or eastward propagation of the metamor-phism and magmatism can be clearly identified. In contrast, the new data reveal a progressive propagation of the thermal anomaly from the base to the surface of the continental crust. Focusing on the key localities of the Mauléon basin, Arguenos–Moncaup, Lherz, Boucheville and the Bas-Agly, we analyze the thermal conditions prevailing during the Cre-taceous crustal thinning. The results are synthetized into a series of three regional thematic maps and into two detailed maps of the Arguenos–Moncaup and Lherz areas. The results indicate a first-order control of the thermal gradient by the intensity of crustal thinning. The highest grades of metamor-phism are intimately associated with the areas where subcon-tinental mantle rocks have been unroofed or exhumed.
ISSN: 1869-9510

insu-01161826
https://hal-insu.archives-ouvertes.fr/insu-01161826
https://hal-insu.archives-ouvertes.fr/insu-01161826/document
https://hal-insu.archives-ouvertes.fr/insu-01161826/file/PL03457.pdf
DOI : 10.5194/se-6-643-2015

Éditeur(s) : HAL CCSD National Research Council Canada
Résumé : International audience
Back-arc extension in the Aegean, which was driven by slab rollback since 45 Ma, is described here for the first time in two stages. From Middle Eocene to Middle Miocene, deformation was localized leading to i) the exhumation of high-pressure metamorphic rocks to crustal depths, ii) the exhumation of high-temperature metamorphic rocks in core complexes and iii) the deposition of sedimentary basins. Since Middle Miocene, extension distributed over the whole Aegean domain controlled the deposition of onshore and offshore Neogene sedimentary basins. We reconstructed this two-stage evolution in 3D and four steps at Aegean scale by using available ages of metamorphic and sedimentary processes, geometry and kinematics of ductile deformation, paleomagnetic data and available tomographic models. The restoration model shows that the rate of trench retreat was around 0.6 cm/y during the first 30 My and then accelerated up to 3.2 cm/y during the last 15 My. The sharp transition observed in the mode of extension, localized versus distributed, in Middle Miocene correlates with the acceleration of trench retreat and is likely a consequence of the Hellenic slab tearing documented by mantle tomography. The development of large dextral NE-SW strike-slip faults, since Middle Miocene, is illustrated by the 450 Km-long fault zone, offshore from Myrthes to Ikaria and onshore from Izmir to Balikeshir, in western Anatolia. Therefore, the interaction between the Hellenic trench retreat and the westward displacement of Anatolia started in Middle Miocene, almost 10 Ma before the propagation of the North Anatolian Fault in the North Aegean.
ISSN: 0008-4077

insu-01271296
https://hal-insu.archives-ouvertes.fr/insu-01271296
https://hal-insu.archives-ouvertes.fr/insu-01271296/document
https://hal-insu.archives-ouvertes.fr/insu-01271296/file/Brun%20etal%20CJES%202016.pdf
DOI : 10.1139/cjes-2015-0203