Éditeur(s) : HAL CCSD
Résumé : International audience
High Pressure - Low Temperature (HP-LT) rocks testify for burying and exhumation of crustal material in subduction zones. The question of their exhumation is nevertheless still unclear. The Aegean domain offers several HP-LT belts. Especially, the Attic-Cycladic Blueschist unit (ACBU) is an example of a HP-LT unit exhumed in a convergent and then in a divergent context. It actually appears in metamorphic core complexes (MCCs) formed in the back-arc of the subduction. The syn-convergence "message" is however difficult to read because of the post-convergence structural and thermal overprint that accompanied the formation of the MCCs. Particularly, the geometry, the timing and the amount of the syn-orogenic exhumation remain unclear. We investigate theses questions with metamorphic petrology (Andros and Ios islands) and phengite population, single grain and in situ 40Ar-39Ar geochronology (Andros, Tinos, Syros and Ios islands). Based on these new constraints and a synthesis of published data, we are able to refine the geometry, the timing and the modes of the exhumation of the ACBU. Data from the whole Cyclades exhibit little differences in the age and P-T conditions at the successive stages of syn-orogenic exhumation. The peak of pressure (500±50 °C-18±1 kbar) has been reached at 50-55 Ma. The onset of the exhumation occurred at 40-45 Ma in blueschist facies conditions, between a basal thrust and a summital detachment. The following decompression was accompanied by cooling until 30-35 Ma (400±50 °C-8±1 kbar). At that time, the boundary conditions switched to extension. The change in boundary conditions is recorded by slowing of the exhumation and isobare heating. The conditions of post-orogenic exhumation differ from an island to another. The onset of post-orogenic exhumation is dated around 30 Ma in the northern Cyclades and 25 Ma in the southern Cyclades. It is related to top-to-the-North deformation in all the studied domain. The end of ductile deformation below the detachments is also diachronous (21 Ma in the North and 18 Ma in the South). Finally, we propose a model for the final steps of the exhumation related to the intrusion of granitic bodies around 14 Ma.
American Geophysical Union, Fall Meeting
San Francisco, United States

insu-00860510
https://hal-insu.archives-ouvertes.fr/insu-00860510
BIBCODE : 2010AGUFM.T23C2301L

Éditeur(s) : HAL CCSD AGU and the Geochemical Society
Résumé : International audience
[1] Statistical analysis of modern oceanic subduction zone parameters, such as the age of a downgoing plate or the absolute plate motions, is performed in order to investigate which parameter controls the dip of a slab and, conversely, what the influence of slab geometry is on upper plate behavior. For that purpose, parameters have been determined from global databases along 159 transects from all subduction zones that are not perturbed by nearby collision or ridge/plateau/seamount subduction. On the basis of tomographic images, slabs that penetrate through, or lie on, the 670 km discontinuity are also identified. The results of the statistical analysis are as follows: (1) Back-arc stress correlates with slab dip, i.e., back-arc spreading is observed for deep dips (deeper than 125 km) larger than 50°, whereas back-arc shortening occurs only for deep dips less than 30°. (2) Slab dip correlates with absolute motion of the overriding plate. The correlation is even better when the slab lies on, or even more penetrates through, the 670 km discontinuity. (3) Slabs dip more steeply, by about 20° on average, beneath oceanic overriding plates than beneath continental ones. (4) Slabs dip more steeply on average by about 10° near edges. (5) Slab dip does not correlate with the magnitude of slab pull, the age of subducting lithosphere at the trench, the thermal regime of the subducting lithosphere, the convergence rate, or the subduction polarity (east versus west). The present study provides evidence that the upper plate absolute motion plays an important role on slab dip, as well as on upper plate strain. Retreating overriding plates are often oceanic ones and thus may partially explain the steeper slab dips beneath oceanic upper plates. One can infer that low slab dips correlate well with compression in continental advancing upper plates, whereas steep dips are often associated with extension in oceanic retreating upper plates. Excess weight of old slabs is often counterbalanced by other forces, probably asthenospheric in origin, such as lateral mantle flow near slab edges or anchor forces, to determine slab dip. Components: 12,676 words, 13 figures, 1 table.
ISSN: 1525-2027

hal-01261567
https://hal.archives-ouvertes.fr/hal-01261567
https://hal.archives-ouvertes.fr/hal-01261567/document
https://hal.archives-ouvertes.fr/hal-01261567/file/lallemandG32005.pdf
DOI : 10.1029/2005GC000917