Éditeur(s) : HAL CCSD Elsevier
Résumé : International audience
A detailed rock-magnetic and archeointensity study was carried out on materials baked by a western Mexican artisan following traditional techniques to produce faithful reproductions of archeological pieces of the Michoacan region (Western Mesoamerica). The field strength at the site (41.0 +/- 0.51 mu T) was measured with a fluxgate magnetometer and the temperature of the furnace during the baking process was monitored continually by means of a thermocouple placed in the middle of the baking cavity.;Rock-magnetic experiments performed on the raw material (clay and paste) and on in situ prepared baked ceramics and bricks included measurement of thermomagnetic curves (susceptibility and strong-field magnetization versus temperature), first-order reversal curves (FORC), anisotropy of magnetic susceptibility (AMS) and anisotropy of thermoremanent magnetization (A-TRM). Magnetite and probably hematite are present in the samples as carriers of the remanence. Hysteresis ratios suggest that the samples fall in the pseudo-single-domain grain size region, which may indicate a mixture of multidomain and a significant amount of single-domain grains.;Ceramic pieces and brick fragments were subjected to the Thellier-Coe archeointensity method and to an alternative paleointensity experiment, with a TRIAXE magnetometer, in order to check whether they are faithful recorders of the local geomagnetic field strength.;Mean raw-intensity of sample M1 (pottery) overestimates a 7% the expected site intensity, while those corresponding to the brick samples (LQ1 and LQ2) underestimate it 15%. Brick sample LNQ shows a slightly lower intensity (7%), but agrees with the expected site intensity within the experimental uncertainty. The intensity retrieved from the volcanic fragment also included closely reproduces the expected intensity. After A-TRM and cooling-rate corrections, all mean raw values move closer to the expected intensity.;Measurement of temperatures at different parts inside the kiln (bottom and upper parts of both central and peripheral parts) revealed the existence of significant thermal gradients, similar to those observed in ovens from other localities. Different cooling rates are then expected in a single oven.;The scatter in the intensity determinations observed in this study, retrieved from pieces elaborated together in the same oven, could arise from this differentiated cooling rate within the oven and thus, to an inappropriate cooling rate correction in the archeointensity protocol. As this situation was probably reproduced in the baking of ancient ceramic artifacts, a better knowledge of the temperature distribution inside these types of kiln would be desirable in order to choose the appropriate cooling rate correction.
ISSN: 0031-9201

hal-00644559
https://hal.archives-ouvertes.fr/hal-00644559
DOI : 10.1016/j.pepi.2011.06.007

Éditeur(s) : HAL CCSD Wiley
Résumé : International audience
Due to shallow penetration of millimeter waves (MMW) and convection in liquid medium surrounding cells, the problem of accurate assessment of local MMW heating in in vitro experiments remains unsolved. Conventional dosimetric MMW techniques, such as infrared imaging or fiber optic (FO) sensors, face several inherent limits. Here we propose a methodology for accurate local temperature measurement and subsequent specific absorption rate (SAR) retrieval using microscale thermocouples (TC). SAR was retrieved by fitting the measured initial temperature rise to the numerical solution of an equivalent thermal model. It was found that the accuracy of temperature measurement depends on thermosensor size, that is, the smaller TC, the more accurate the temperature measurement. SAR determined using TC with lead diameters of 25 and 75m demonstrated 98.5% and 80.4% match with computed SAR, respectively. However, both TC provided the same temperature rises in long run (>10min). FO probe failed to measure adequately local heating both for short and long exposures due to the relatively large size of the probe sensor (400m) and time constant (0.6s). Calculated SAR in the cell monolayer was almost two times lower than that in the surrounding liquid. It was shown that the impact of the cell monolayer on heating due to its small thickness (5 to 10m) can be considered as negligible. Moreover, we demonstrated the possibility of accurate measurement of MMW-induced thermal pulses (up to 10 degrees C) using 25m TC. Bioelectromagnetics. 38:11-21, 2017. (c) 2016 Wiley Periodicals, Inc.
ISSN: 0197-8462

hal-01436768
https://hal-univ-rennes1.archives-ouvertes.fr/hal-01436768
DOI : 10.1002/bem.21999
PUBMED : 27571392

Éditeur(s) : HAL CCSD INRA Editions
Résumé : International audience
The objective of this study was to examine the water relations and hydraulic architecture and vulnerability to cavitation in Virola surinamensis and V. michelii and to compare to similar measurements in Eperua falcata. In several previous reports Virola was seen to have a rather narrow range of xylem pressure potentials (Ψx) near zero in the course of a wet-season day while having water fluxes quite close to Eperua. We tested the hypothesis that the narrow range of Ψx might be consistent with very high hydraulic conductivities of stems, roots and shoots and high vulnerability to cavitation in Virola compared to Eperua. When this hypothesis proved false we concluded that the previous determinations of Ψx might be wrong in Virola due to latex. We re-examined the determination of Ψx in Virola by the pressure chamber technique and compared results to determination of Ψleaf by the thermocouple psychrometer technique and found that the likely range of Ψx are more negative than previously reported. Problems concerning the determination of Ψx in species with latex are discussed.
ISSN: 2268-4565

hal-01077475
https://hal.archives-ouvertes.fr/hal-01077475
https://hal.archives-ouvertes.fr/hal-01077475/document
https://hal.archives-ouvertes.fr/hal-01077475/file/JPH-1-e0002.pdf

Éditeur(s) : HAL CCSD
Résumé : HYDRO
The objective of this study was to examine the water relations and hydraulic architecture and vulnerability to cavitation in Virola surinamensis and V. michelii and to compare to similar measurements in Eperua falcata. In several previous reports Virola was seen to have a rather narrow range of xylem pressure potentials ( Yx) near zero in the course of a wet-season day while having water fluxes quite close to Eperua. We tested the hypothesis that the narrow range of Yx might be consistent with very high hydraulic conductivities of stems, roots and shoots and high vulnerability to cavitation in Virola compared to Eperua. When this hypothesis proved false we concluded that the previous determinations of Y x might be wrong in Virola due to latex. We re-examined the determination of Yx in Virola by the pressure chamber technique and compared results to determination of Yleaf by the thermocouple psychrometer technique and found that the likely range of Yx are more negative than previously reported. Problems concerning the determination of Yx in species with latex are discussed.
Journal of Sigmoidal Plant Hydraulics

hal-01032396
https://hal.archives-ouvertes.fr/hal-01032396