Éditeur(s) : HAL CCSD Springer Verlag
Résumé : A hypothetical mechanism for the generation of maturation stress in wood was tested experimentally. The hypothesis was that the maturation stress could partly originate in a physical mechanism related to daily changes in water pressure and associated diurnal strains. The matrix of lignin and hemicellulose, deposited in the cell wall during the night, would be put in compression by the effect of water tension during the next day. The cellulose framework, crystallizing during the day, would be put in tension by the decrease in tension at night and subsequent cell-wall swelling. This was tested on young saplings of sugi and beech. Half of the saplings were submitted to continuous lighting, which canceled diurnal strains. Saplings were tilted 40 degrees, and their uprighting movement was measured. The uprighting movement is directly due to the production of reaction wood and the concomitant development of large longitudinal maturation stress. It occurred in the continuously lighted plants at least as much as in control plants. We conclude that the generation of longitudinal maturation stress in tension or compression wood is not directly related to variations in water pressure and diurnal strains.
ISSN: 1435-0211

hal-01031891
https://hal.archives-ouvertes.fr/hal-01031891
DOI : 10.1007/s10086-005-0788-6

Éditeur(s) : HAL CCSD Springer Verlag
Résumé : Tangential strains were measured with strain gauges at the surface of xylem and inner bark of saplings of Cryptomeria japonica D. Don. and Fagus silvatica L. during a pressurization test. The test consists in submitting the whole sapling to an artificially imposed hydrostatic pressure of increasing magnitude. The elastic response of the stems was found linear both at the surface of xylem and inner bark. A simple geometric model allows to compute radial strains in each tissue from tangential strain data. Inside inner bark, radial strains are much larger than tangential strains, because tangential strains are restrained by the core of wood. The material compliance of each tissue was computed as the ratio between the radial strain and the pressure that caused it. The material compliance of xylem is much lower than that of inner bark, but, as its thickness is much larger, its contribution to the apparent behavior of the stem is not negligible. Computation of material compliances by this pressurization test provides information about the specific behavior of each tissue in response to hydrostatic pressure. This can be used to estimate and interpret the calibration factor linking the water status of the plant to the apparent strain measured at its surface.
ISSN: 0931-1890

hal-01031900
https://hal.archives-ouvertes.fr/hal-01031900
DOI : 10.1007/s00468-006-0061-7

Éditeur(s) : HAL CCSD Oxford University Press (OUP): Policy B - Oxford Open Option B
Résumé :  
absent
ISSN: 0829-318X

hal-01032128
https://hal.archives-ouvertes.fr/hal-01032128
DOI : 10.1093/treephys/28.10.1513

Éditeur(s) : HAL CCSD Oxford University Press (OUP): Policy B - Oxford Open Option B
Résumé :  
absent
ISSN: 0829-318X

hal-01032099
https://hal.archives-ouvertes.fr/hal-01032099
DOI : 10.1093/treephys/27.11.1505