Éditeur(s) : HAL CCSD Springer Verlag (Germany)
Résumé : International audience
Surface displacements due to temporal changes in environmental mass redistributions are observable in the coordinate time series of many Global Navigation Satellite System (GNSS) sites. In this study, we investigated the effect of loading on estimates of tectonic velocity computed from campaign-style GNSS observations. The study region is in the Pyrenees mountain range between France and Spain (ResPyr campaigns). In this area, seismic activity is continuous and moderate and the expected amplitude of the horizontal tectonic velocity is less than 0.5 mm/yr. In order to determine the velocity, 4 sparse GNSS campaigns were carried out from 1995 to 2010. Considering this small rate of deformation, loading phenomena can contribute a non-negligible artifact to the velocity computation that could affect our geodynamical interpretation. In this investigation, we specifically considered the atmospheric, hydrological, and non-tidal ocean loading phenomena. The computed loading deformations for this region show the horizontal displacements are dominated by the non-tidal ocean loading (maximum 4 mm for the North and 3.1 mm for the East components); the main vertical contributions are due to the atmospheric and continental water storage loading (maximum 14.3 for the atmosphere and 8.1 mm for the hydrology, respectively). We have found that the dominant loading effect on the horizontal velocity is the non-tidal ocean loading (mean of 0.11 mm/yr), whereas the vertical component is dominated by the hydrological loading (mean of 0.21 mm/yr). Since the study area is in a mountainous region, we also analyzed the difference between the atmospheric and the topography dependent atmospheric loading models at our GNSS campaign sites. We did not find any significant difference between the two atmospheric loading models in terms of horizontal velocity. Finally, we performed simulations to identify the optimum timing and frequency of future GNSS campaigns in this area that would minimize the loading effects on tectonic velocity estimates.
ISSN: 0039-3169

hal-00963629
https://hal.archives-ouvertes.fr/hal-00963629
DOI : 10.1007/s11200-012-0458-2

Éditeur(s) : HAL CCSD Oxford University Press (OUP): Policy P - Oxford Open Option A Oxford University Press (OUP)
Résumé : International audience
The Pyrenean mountain range is a slowly deforming belt with continuous and moderate seismic activity. To quantify its deformation field, we present the velocity field estimated from a GPS survey of the Pyrenees spanning 18 yr. The PotSis and ResPyr networks, including a total of 85 GPS sites, were installed and first measured in 1992 and 1995–1997, respectively, and remeasured in 2008 and 2010. We obtain a deformation field with velocities less than 1 mm yr−1 across the range. The estimated velocities for individual stations do not differ significantly from zero with 95 per cent confidence. Even so, we estimate a maximum extensional horizontal strain rate of 2.0 ± 1.7 nanostrain per year in a N–S direction in the western part of the range. We do not interpret the vertical displacements due to their large uncertainties. In order to compare the horizontal strain rates with the seismic activity, we analyse a set of 194 focal mechanisms using three methods: (i) the ‘r’ factor relating their P and T axes, (ii) the stress tensors obtained by fault slip inversion and (iii) the strain-rate tensors. Stress and strain-rate tensors are estimated for: (i) the whole data set, (ii) the eastern and western parts of the range separately, and (iii) eight zones, which are defined based on the seismicity and the tectonic patterns of the Pyrenees. Each of these analyses reveals a lateral variation of the deformation style from compression and extension in the east to extension and strike-slip in the west of the range. Although the horizontal components of the strain-rate tensors estimated from the seismic data are slightly smaller in magnitude than those computed from the GPS velocity field, they are consistent within the 2σ uncertainties. Furthermore, the orientations of their principal axes agree with the mapped active faults.
ISSN: 0956-540X

hal-01171752
https://hal.archives-ouvertes.fr/hal-01171752
DOI : 10.1093/gji/ggv052

Éditeur(s) : HAL CCSD Oxford University Press (OUP)
Résumé : International audience
Ocean loading effects cause 3-D displacements large enough to affect space geodesy measurements either at the subdiurnal periods or at longer time scales by the means of spurious signals. GPS measurements, in turn, could provide local improvements of the models in coastal areas if their ability to precisely monitor such rapid displacements is assessed. In this paper, we use 105 days of continuous GPS measurements collected in 2004 in the French Brittany and Cotentin region to investigate: (1) the precision achieved by the GPS analysis on measuring 3-D subdiurnal displacements and amplitude and phase of the tidal constituents, (2) the quality of the most recent ocean tide model FES2004 in such a complex coastal context. Indeed, in this area, tide amplitudes are among the largest in the world (up to 16 cm of loading displacements on the vertical component) and are believed to show strong shallow-water tides. From a state of the art GPS analysis using the scientific GAMIT software over 2-h sessions, we test two independent strategies for the realization of the reference frame. The position time series are then compared with the displacements predicted by the FES2004 model applied on an elastic Earth model. The two sets of results are consistent with each other at the same level of agreement than with the predicted displacements, namely 3–5 mm on the horizontal components, 10 mm on the vertical. This assesses the capability of this technique for measuring 3-D ocean tide loading deformation. We validate the FES2004 model in the Brittany area, even though it slightly (2–7 mm) underestimates the three components amplitudes. With a harmonic analysis of the observed position time series, we obtain nevertheless an agreement at a submillimetre level for the M2, N2, O1, Q1 tidal constituents and at a millimetre level for the K1 and S2 tidal constituents. Moreover, we can extract a significant M4 load signal at the 95 per cent confidence level from the GPS time series at the stations located in the Mont St Michel area. The detection of other shallow-water constituents would be helpful to understand the amplitude deficit between the FES2004 predicted and GPS observed displacements.
ISSN: 0956-540X

insu-00335909
https://hal-insu.archives-ouvertes.fr/insu-00335909
https://hal-insu.archives-ouvertes.fr/insu-00335909/document
https://hal-insu.archives-ouvertes.fr/insu-00335909/file/Vergnolle_GJI_08_revised.pdf
DOI : 10.1111/j.1365-246X.2008.03734.x