Éditeur(s) : HAL CCSD Landes Bioscience
Résumé : International audience
In 2008 we published the first set of guidelines for standardizing research in autophagy. Since then, research on this topic has continued to accelerate, and many new scientists have entered the field. Our knowledge base and relevant new technologies have also been expanding. Accordingly, it is important to update these guidelines for monitoring autophagy in different organisms. Various reviews have described the range of assays that have been used for this purpose. Nevertheless, there continues to be confusion regarding acceptable methods to measure autophagy, especially in multicellular eukaryotes. A key point that needs to be emphasized is that there is a difference between measurements that monitor the numbers or volume of autophagic elements (e.g., autophagosomes or autolysosomes) at any stage of the autophagic process vs. those that measure flux through the autophagy pathway (i.e., the complete process); thus, a block in macroautophagy that results in autophagosome accumulation needs to be differentiated from stimuli that result in increased autophagic activity, defined as increased autophagy induction coupled with increased delivery to, and degradation within, lysosomes (in most higher eukaryotes and some protists such as Dictyostelium) or the vacuole (in plants and fungi). In other words, it is especially important that investigators new to the field understand that the appearance of more autophagosomes does not necessarily equate with more autophagy. In fact, in many cases, autophagosomes accumulate because of a block in trafficking to lysosomes without a concomitant change in autophagosome biogenesis, whereas an increase in autolysosomes may reflect a reduction in degradative activity. Here, we present a set of guidelines for the selection and interpretation of methods for use by investigators who aim to examine macroautophagy and related processes, as well as for reviewers who need to provide realistic and reasonable critiques of papers that are focused on these processes. These guidelines are not meant to be a formulaic set of rules, because the appropriate assays depend in part on the question being asked and the system being used. In addition, we emphasize that no individual assay is guaranteed to be the most appropriate one in every situation, and we strongly recommend the use of multiple assays to monitor autophagy. In these guidelines, we consider these various methods of assessing autophagy and what information can, or cannot, be obtained from them. Finally, by discussing the merits and limits of particular autophagy assays, we hope to encourage technical innovation in the field.
Autophagy

hal-00735751
https://hal.archives-ouvertes.fr/hal-00735751
PUBMED : 22966490

Éditeur(s) : HAL CCSD Springer Verlag (Germany) Springer Verlag
Résumé : International audience
Replenished axial melt lenses at fast-spreading mid-oceanic ridges may move upward and intrude into the overlying hydrothermally altered sheeted dikes, resulting in high-grade contact metamorphism with the potential to trigger anatexis in the roof rocks. Assumed products of this process are anatectic melts of felsic composition and granoblastic, two-pyroxene hornfels, representing the residue after partial melting. Integrated Ocean Drilling Program Expeditions 309, 312, and 335 at Site 1256 (eastern equatorial Pacific) sampled such a fossilized oceanic magma chamber. In this study, we simulated magma chamber roof rock anatectic processes by performing partial melting experiments using six different protoliths from the Site 1256 sheeted dike complex, spanning a lithological range from poorly to strongly altered basalts to partially or fully recrystallized granoblastic hornfels. Results show that extensively altered starting material lacking primary magmatic minerals cannot reproduce the chemistry of natural felsic rocks recovered in ridge environments, especially elements sensitive to hydrothermal alteration (e.g., K, Cl). Natural geochemical trends are reproduced through partial melting of moderately altered basalts from the lower sheeted dikes. Two-pyroxene hornfels, the assumed residue, were reproduced only at low melting degrees (<20 vol%). The overall amphibole absence in the experiments confirms the natural observation that amphibole is not produced during peak metamorphism. Comparing experimental products with the natural equivalents reveals that water activity (aH2O) was significantly reduced during anatectic processes, mainly based on lower melt aluminum oxide and lower plagioclase anorthite content at lower aH2O. High silica melt at the expected temperature (1000–1050 °C; peak thermal overprint of two-pyroxene hornfels) could only be reproduced in the experimental series performed at aH2O = 0.1.
ISSN: 0010-7999

hal-01174139
https://hal.archives-ouvertes.fr/hal-01174139
DOI : 10.1007/s00410-015-1136-5

Éditeur(s) : HAL CCSD Elsevier
Résumé : International audience
At oceanic spreading centers, interactions between magma and hydrothermal convecting systems trigger major physical, thermal, and chemical exchanges. The two-pyroxene hornfels recovered from the base of the sheeted dike sequence at Integrated Ocean Drilling Program (IODP) Site 1256 (equatorial Eastern Pacific) are interpreted as a conducting boundary layer between the underlying axial melt lens and the hydrothermally cooled sheeted dikes. They are cut by numerous small, felsic veins, which were recently interpreted as a product of hydrous partial melting of sheeted dikes. Here, we present trace element compositions of products (melts and residues) of hydrous partial melting experiments using basalts and hornfels from IODP Site 1256 as starting material. The experimental products generated between 910 °C and 970 °C match the natural lithologies from Site 1256 in terms of major and trace element compositions. The compositions of the anatectic melts correspond to the compositions of the felsic veins, while the residual minerals match the compositions of the two-pyroxene hornfels, evidencing that hydrous partial melting is an important magmatic process in the gabbro/dike transition of fast-spreading mid-oceanic ridges. Our results complement previous experimental studies on anatectic processes occurring at the roof of the magma chambers from fast-spreading mid-ocean ridges. Moreover, calculations of mixing and assimilation fractional crystallization using the experimental partial melts as contaminant/assimilant showed that anatectic melts can only be a minor contributor to the contamination process.
ISSN: 0024-4937

hal-01419949
https://hal.archives-ouvertes.fr/hal-01419949
DOI : 10.1016/j.lithos.2016.05.001