Éditeur(s) : HAL CCSD Springer Verlag (Germany) Springer Verlag
Résumé : International audience
Replenished axial melt lenses at fast-spreading mid-oceanic ridges may move upward and intrude into the overlying hydrothermally altered sheeted dikes, resulting in high-grade contact metamorphism with the potential to trigger anatexis in the roof rocks. Assumed products of this process are anatectic melts of felsic composition and granoblastic, two-pyroxene hornfels, representing the residue after partial melting. Integrated Ocean Drilling Program Expeditions 309, 312, and 335 at Site 1256 (eastern equatorial Pacific) sampled such a fossilized oceanic magma chamber. In this study, we simulated magma chamber roof rock anatectic processes by performing partial melting experiments using six different protoliths from the Site 1256 sheeted dike complex, spanning a lithological range from poorly to strongly altered basalts to partially or fully recrystallized granoblastic hornfels. Results show that extensively altered starting material lacking primary magmatic minerals cannot reproduce the chemistry of natural felsic rocks recovered in ridge environments, especially elements sensitive to hydrothermal alteration (e.g., K, Cl). Natural geochemical trends are reproduced through partial melting of moderately altered basalts from the lower sheeted dikes. Two-pyroxene hornfels, the assumed residue, were reproduced only at low melting degrees (<20 vol%). The overall amphibole absence in the experiments confirms the natural observation that amphibole is not produced during peak metamorphism. Comparing experimental products with the natural equivalents reveals that water activity (aH2O) was significantly reduced during anatectic processes, mainly based on lower melt aluminum oxide and lower plagioclase anorthite content at lower aH2O. High silica melt at the expected temperature (1000–1050 °C; peak thermal overprint of two-pyroxene hornfels) could only be reproduced in the experimental series performed at aH2O = 0.1.
ISSN: 0010-7999

hal-01174139
https://hal.archives-ouvertes.fr/hal-01174139
DOI : 10.1007/s00410-015-1136-5

Éditeur(s) : HAL CCSD AGU and the Geochemical Society
Résumé : International audience
In the Oman ophiolite crustal section, a contact zone between the gabbro unit and the volcanics and diabase sheeted dikes, called the root zone of the sheeted dike complex, has been recently mapped at a fine scale in a selected area. The Oman ophiolite is derived from a fast spreading ridge which had a melt lens located between the main gabbro unit and the root zone of the sheeted dike complex. With a few exceptions accounted for, this horizon has a fairly constant thickness, similar to 100 m, and a crude internal pseudo-stratigraphy. At the base of the root zone are isotropic ophitic gabbros interpreted as a thermal boundary layer. This layer is transitional between the magmatic system of the melt lens, convecting at 1200 degrees C, and a high-temperature (< 1100 degrees C) hydrothermal system, convecting within the root zone. Above this level, the isotropic gabbros have been, locally, largely molten due to an influx of seawater, at similar to 1100 degrees C, thus generating varitextured ophitic and pegmatitic gabbros. These latter gabbros constitute the upper part of the root zone and are associated with trondjhemitic intrusions as screens in the lower sheeted dikes. Diorites and trondjhemites were also generated by hydrous melting, at temperatures below 1000 degrees C. The whole root zone is a domain of very sharp average thermal gradient (similar to 7 degrees C/m). At the top of the root zone, a new thermal boundary layer, with diabase dikes hydrated in amphibolite facies conditions, separates the preceding high- temperature convective system from the well-known greenschist facies (< 450 degrees C) hydrothermal system operating throughout the sheeted dike complex, up to the seafloor. The isotropic gabbros near the base of the root zone are intruded by protodikes with distinctive microgranular margins and an ophitic center. Protodike swarms are exceptional because, intruding a medium at similar to 1100 degrees C, they are largely destroyed by dike-in-dike intrusions and by hydrous melting. However, they demonstrate that this zone was generated by melt conduits issued from the underlying melt lens. Each dike of the sheeted dike complex is thus fed by one protodike. As this zone has been recently drilled by IODP in the eastern Pacific Ocean, a brief comparison is proposed.
ISSN: 1525-2027

hal-00411331
https://hal.archives-ouvertes.fr/hal-00411331
DOI : 10.1029/2007GC001918

Éditeur(s) : HAL CCSD AGU and the Geochemical Society
Résumé : International audience
The transition between the small melt lens observed on top of fast spreading ridge magma chambers and the overlying sheeted dike complex marks the interface between magma and the hydrothermal convective system. It is therefore critical to our understanding of fast spreading ridge accretion processes. We present maps of two areas of the Oman ophiolite where this transition zone is observed as continuous outcrops. Our observations, which include the base of the sheeted dike being crosscut by gabbros, are consistent with episodic dike injections in a steady state model but also suggest that the root of these dikes is commonly erased by vertical movements of the top of the melt lens. Dike assimilation is a possible mechanism for incorporating hydrated phases, which result from hydrothermal alteration, to the melt lens during upward migrations of its upper boundary. Upward migrations are also responsible for a granoblastic overprint of the root of the dikes that is also observed in the stoped diabase xenoliths. This granoblastic overprint attests to reheating of previously hydrothermally altered lithologies which can even trigger hydrous partial melting due to the lowering of the solidus of mafic lithologies by the presence of a water activity. Clinopyroxenes present in these granoblastic lithologies are typically low in Ti and Al content, thus strongly contrasting with corresponding magmatic clinopyroxene. This may attest to the recrystallization of clinopyroxenes after amphiboles under the peculiar conditions present at the root zone of the sheeted dike complex. Downward migrations of the top of the melt lens result in the crystallization of the isotropic gabbros at its roof, which represent the partly fossilized melt lens. Melt lens fossilization eventually occurs when magma supply is stopped or at the melt lens margins where the thermal conditions become cooler. Melt lens migration, recrystallization of hydrothermally altered sheeted dikes during reheating stages, and assimilation processes observed in the Oman ophiolite are consistent with the observations made in IODP Hole 1256D. We propose a general dynamic model in which the melt lens at fast spreading ridges undergoes upward and downward movements as a result of either eruption/replenishment stages or variations in the hydrothermal/magmatic fluxes.
ISSN: 1525-2027

hal-00445249
https://hal.archives-ouvertes.fr/hal-00445249
DOI : 10.1029/2009GC002652

Éditeur(s) : HAL CCSD Elsevier
Résumé : International audience
At oceanic spreading centers, interactions between magma and hydrothermal convecting systems trigger major physical, thermal, and chemical exchanges. The two-pyroxene hornfels recovered from the base of the sheeted dike sequence at Integrated Ocean Drilling Program (IODP) Site 1256 (equatorial Eastern Pacific) are interpreted as a conducting boundary layer between the underlying axial melt lens and the hydrothermally cooled sheeted dikes. They are cut by numerous small, felsic veins, which were recently interpreted as a product of hydrous partial melting of sheeted dikes. Here, we present trace element compositions of products (melts and residues) of hydrous partial melting experiments using basalts and hornfels from IODP Site 1256 as starting material. The experimental products generated between 910 °C and 970 °C match the natural lithologies from Site 1256 in terms of major and trace element compositions. The compositions of the anatectic melts correspond to the compositions of the felsic veins, while the residual minerals match the compositions of the two-pyroxene hornfels, evidencing that hydrous partial melting is an important magmatic process in the gabbro/dike transition of fast-spreading mid-oceanic ridges. Our results complement previous experimental studies on anatectic processes occurring at the roof of the magma chambers from fast-spreading mid-ocean ridges. Moreover, calculations of mixing and assimilation fractional crystallization using the experimental partial melts as contaminant/assimilant showed that anatectic melts can only be a minor contributor to the contamination process.
ISSN: 0024-4937

hal-01419949
https://hal.archives-ouvertes.fr/hal-01419949
DOI : 10.1016/j.lithos.2016.05.001

Éditeur(s) : HAL CCSD Mineralogical Society of America
Résumé : International audience
Crystallization experiments were conducted at 200 MPa to determine the effect of small amounts of H2O on the liquidus temperature of basaltic melts in which plagioclase is the liquidus phase. The H2O concentrations in the quenched glasses, determined by infrared spectroscopy and Karl-Fischer titration, ranged from 0.02 to 4.2 wt% H2O. The dry liquidus temperature at 200 MPa was estimated from experiments at 1 atm (H2O-free) and from the known pressure dependence of plagioclase crystallization temperature. The effect of water (expressed as wt% H2O) on the plagioclase liquidus temperature is nonlinear and diminishing with increasing melt H2O concentrations. According to our new experimental data, it can be empirically predicted with following equation: Formula where CH2O is the water concentration in the melt (wt%), TDRY, and TWET are plagioclase crystallization temperatures in water-free and water-bearing systems, respectively. The relationship between CH2O and liquidus temperature worked out in this study is valid for a range of basaltic compositions, ranging from high-alumina basalts to basaltic andesites. The combination of the empirical equation predicting the liquidus depression of plagioclase with previous models predicting the olivine liquidus curve is useful to determine the liquidus temperature in various H2O-bearing basaltic systems in which either plagioclase or olivine is the liquidus phase.
ISSN: 0003-004X

hal-00757600
https://hal.archives-ouvertes.fr/hal-00757600
DOI : 10.2138/am.2012.4100