Éditeur(s) : HAL CCSD Oxford University Press (OUP)
Résumé : International audience
The interpretation of coseismic surface deformation measurements through inversion techniques is of major importance to understand the mechanical behaviour of a seismic fault. Dense geodetic data sets in the vicinity of the ruptured fault provide unique constraints on detailed fault geometry and slip distribution at depth, making them complementary to seismological data. Bam earthquake (Mw 6.6, 2003 December 26) induced surface deformation has been precisely mapped by Envisat ASAR interferometry and by subpixel correlation techniques applied to Spot-5 and ASAR amplitude images. These oblique and horizontal estimations of deformation have been completed with one levelling profile along the main road crossing the rupture from west to east. We process these data (separately and jointly) in a two-step inversion technique, within the elastic half-space theory framework. Our objective is to determine the dislocation model at depth that satisfies simultaneously all the geodetic constraints. Also, we estimate the relative contribution of each geodetic data set to this inversion process.We first use a stochastic direct approach called neighbourhood algorithm in order to estimate the average characteristics of the rupture, and their relative uncertainty. Constraining in this way the geometry of the ruptured fault, we then linearize the inverse problem and compute the slip distribution on the fault using a standard weighted least-square technique, assuming the solution is smooth to some degree. At each step, we discuss the optimal models, their stability as well as the relative influence of each data set on the derived models parameters. Our preferred model reveals a shallow dislocation on a quasi-vertical fault, slightly dipping towards east. The slip vector has a strike-slip component as high as 2 m, while the dip-slip component seems negligible.However, the estimation of the resolution matrices emphasizes the fact that the details of deep fault slip distribution remain out of the scope of this ill-conditioned inverse problem. Yet, our preferred model suggests a main dislocation limited at depth between 1 and 6 km. By contrast, the aftershocks observed in the months following the earthquake are located just beneath the estimated main shock.
ISSN: 0956-540X

hal-00314173
https://hal.archives-ouvertes.fr/hal-00314173
https://hal.archives-ouvertes.fr/hal-00314173/document
https://hal.archives-ouvertes.fr/hal-00314173/file/GJI-2007-169-849-briole.pdf
DOI : 10.1111/j.1365-246X.2007.03358.x

Éditeur(s) : HAL CCSD Oxford University Press (OUP): Policy P - Oxford Open Option A Oxford University Press (OUP)
Résumé : International audience
The Pyrenean mountain range is a slowly deforming belt with continuous and moderate seismic activity. To quantify its deformation field, we present the velocity field estimated from a GPS survey of the Pyrenees spanning 18 yr. The PotSis and ResPyr networks, including a total of 85 GPS sites, were installed and first measured in 1992 and 1995–1997, respectively, and remeasured in 2008 and 2010. We obtain a deformation field with velocities less than 1 mm yr−1 across the range. The estimated velocities for individual stations do not differ significantly from zero with 95 per cent confidence. Even so, we estimate a maximum extensional horizontal strain rate of 2.0 ± 1.7 nanostrain per year in a N–S direction in the western part of the range. We do not interpret the vertical displacements due to their large uncertainties. In order to compare the horizontal strain rates with the seismic activity, we analyse a set of 194 focal mechanisms using three methods: (i) the ‘r’ factor relating their P and T axes, (ii) the stress tensors obtained by fault slip inversion and (iii) the strain-rate tensors. Stress and strain-rate tensors are estimated for: (i) the whole data set, (ii) the eastern and western parts of the range separately, and (iii) eight zones, which are defined based on the seismicity and the tectonic patterns of the Pyrenees. Each of these analyses reveals a lateral variation of the deformation style from compression and extension in the east to extension and strike-slip in the west of the range. Although the horizontal components of the strain-rate tensors estimated from the seismic data are slightly smaller in magnitude than those computed from the GPS velocity field, they are consistent within the 2σ uncertainties. Furthermore, the orientations of their principal axes agree with the mapped active faults.
ISSN: 0956-540X

hal-01171752
https://hal.archives-ouvertes.fr/hal-01171752
DOI : 10.1093/gji/ggv052

Éditeur(s) : HAL CCSD
Résumé : International audience
Optimizing the resource extraction and limiting the environmental constraint motivate to accurately characterize reservoirs. The extraction of resources induces volume change of the reservoir causing displacements in the surrounding medium up to the surface. The resulting surface deformation is usually significant enough to be measurable by geodetic instruments (GPS, satellites, tiltmeters, strainmeters). However, the data needs to be associated to a reservoir model using an inverse scheme to allow the estimation of physical properties of the reservoir. Complete geodetic data including InSAR, GPS, tilt, strain and gravimetric data are uncommon for conventional, unconventional or mining exploitations. In this study, we work on the one site that gathers a wide range of geodetic data: the salt exploitation of Vauvert, France, operated by KemOne. Our approach aims at estimating the volume changes of the cavities created by the extraction combining all the available geodetic data. To do so, we minimize a global functional including weighting factors for each data type. The weighting factors are optimally estimated for our study and can be adapted depending on the issue. Hence, an optimal distribution of data can be suggested for a specific reservoir characterization.
79th EAGE Conference
Paris, France

Droits : http://hal.archives-ouvertes.fr/licences/copyright/
hal-01575426
https://hal.archives-ouvertes.fr/hal-01575426
https://hal.archives-ouvertes.fr/hal-01575426/document
https://hal.archives-ouvertes.fr/hal-01575426/file/reservoir-characterization-inversion.pdf
DOI : 10.3997/2214-4609.201700987

Éditeur(s) : HAL CCSD
Résumé : When the upper crust below the mountain ranges shows crustal extension with a direction collinear to the convergence direction, it is generally accepted that it is the result of gravitational collapse. However, recent studies challenge this paradigm by showing that erosion induces uplift and extension in the central part of the low convergent mountain ranges. In this study, we investigate the impact of denudation on the seismotectonic regime of mountain ranges.In order to identify a relationship between seismotectonic regime and erosion, the first part of this work presents a compilation of data in the mountain ranges. Based on these observations, a simple kinematic model is proposed to predict the seismotectonic regime of the study ranges.For low convergence rate and moderate mean elevation ranges, this model predicts an extension regime when the denudation rate is 15% higher than the convergence rate.The second part is devoted to the development of thermomechanical 2D finite element models to study the impact of surface processes on the deformation of the Pyrenees. The results show that the isostatic response to erosion reactivates pre-existing structures. The kinematics of an inherited fault plane can be predicted due to the gradient of the horizontal surface velocity profile. Thus, a plane located in the eroded zone is reactivated in normal fault when near the border of the erosion area, this same plane is reactivated in reverse fault. These results suggest that the current deformation in the North Pyrenean Zone could be the result of surface processes.Given the small number of studies quantifying erosion rates in the Pyrenees, the models developed in the second part suffer from high uncertainty. To remedy this, we study the central Pyrenees through a study that combines two types of data : watershed denudation rates from cosmogenic isotopes concentration, and incision rates from sediments buried in the karst. These results are presented in chapter 3. Denudation profiles obtained are consistent with reactivation of a normal fault plane located in the North Zone of the Central Pyrenees.From our study in the Pyrenees, a good correlation appears between the value of the rate of erosion and the glacier occupation. Given that the glaciers where more developed in the Alps, it raises the question of the impact of the late-würmian deglaciation on the present deformation of this range. A numerical model detailing this relationship is presented in the fourth chapter. Theresults show that deglaciation of the western Alps is controlled by the rheological heterogeneity of the crust. Some of our models predict uplift rates consistent with those highlighted by geodesy.
Lorsque l’extension de la croûte sous les parties hautes des chaînes de montagnes est colinéaire à la direction de convergence, il est traditionnellement admis que le moteur est l’effondrement gravitaire. Pourtant, des études récentes remettent en cause ce paradigme en montrant que l’érosion induit un soulèvement et de l’extension dans la partie centrale des chaînes de montagne à faible taux de convergence. L’objectif de notre étude est d’étudier l’impact de la dénudation de la topographie sur le régime sismo-tectonique des chaînes de montagnes.La première partie de ce travail présente une compilation de données dans les chaînes de montagnes afin de dégager des relations entre régime sismo-tectonique et érosion. Sur la base de ces observations, un modèle cinématique simple permettant de prévoir le régime de la chaîne est proposé. Ainsi, pour les chaînes à faible taux de convergence et d’élévation moyenne, ce modèleprédit de l’extension lorsque le taux de dénudation est 15% plus élevé que le taux de convergence.La deuxième partie est consacrée au développement d’un modèle thermo-mécanique 2D en éléments finis pour étudier l’impact des processus de surface sur la déformation des Pyrénées.Les résultats montrent que la réponse isostatique à l’érosion permet de réactiver des structurespré-existantes. La cinématique d’un plan de faille hérité peut être prédite grâce au gradient du profil des vitesses de surface horizontales. Ainsi, un plan situé dans la zone d’érosion est réactivé en faille normale alors qu’en bordure de cette zone une faille est réactivée en régime inverse. Ces résultats suggèrent que la déformation actuelle des Pyrénées pourrait être la conséquence d’unprocessus d’érosion.Compte tenu du faible nombre d’études quantifiant les taux d’érosion dans les Pyrénées, les modèles développés dans la deuxième partie souffrent d’une forte incertitude. Pour y remédier, nous avons cherché à les quantifier dans les Pyrénées Centrales grâce à une étude qui combine deux types de données : taux de dénudation des bassins versants à partir des isotopes cosmogéniques, et vitesses d’incision à partir des sédiments piégés dans les karsts. Ces résultats sontprésentés dans la troisième partie. Les profils de dénudation obtenus sont compatibles avec unrejeu en faille normale d’un plan situé dans la Zone Nord Pyrénéenne des Pyrénées Centrales.Notre étude dans les Pyrénées, montre une bonne corrélation entre la valeur du taux d’érosion et la cartographie de l’occupation glaciaire. Les glaciers ayant été plus développés dans les Alpes, cela pose la question de l’impact de la déglaciation tardi-Wurmienne sur la déformation actuelle de cette chaîne. Un modèle numérique détaillant cette relation est présenté dans le quatrième chapitre. Les résultats montrent que la déglaciation des Alpes occidentales est contrôléepar l’hétérogénéité rhéologique de la croute. Certains de nos modèles prédisent des vitesses de surrection compatibles avec celles mises en évidence par la géodésie.
https://hal.archives-ouvertes.fr/tel-01262333

tel-01262333
https://hal.archives-ouvertes.fr/tel-01262333
https://hal.archives-ouvertes.fr/tel-01262333/document
https://hal.archives-ouvertes.fr/tel-01262333/file/these-Genti-2015-postjury.pdf

Éditeur(s) : HAL CCSD Elsevier
Résumé : International audience
Geodetic data support a short-term continental deformation localized in faults bounding lithospheric blocks. Whether major "faults" observed at the surface affect the lithospheric mantle and, if so, how strain is distributed are major issues for understanding the mechanical behavior of lithospheric plates. A variety of evidence, from direct observations of deformed peridotites in orogenic massifs, ophiolites, and mantle xenoliths to seismic reflectors and seismic anisotropy beneath major fault zones, consistently supports prolongation of major faults into the lithospheric mantle. This review highlights that many aspects of the lithospheric mantle deformation remain however poorly understood. Coupling between deformation in frictional faults in the uppermost crust and localized shearing in the ductile crust and mantle is required to explain the post-seismic deformation, but mantle viscosities deduced from geodetic data and extrapolated from laboratory experiments are only reconciled if temperatures in the shallow lithospheric mantle are high (> 800 °C at the Moho). Seismic anisotropy, especially shear wave splitting, provides strong evidence for coherent deformation over domains several tens of km wide in the lithospheric mantle beneath major transcurrent faults. Yet it cannot detect narrow strain localization zones or shallowly dipping faults. Seismic profiling images shallow-dipping seismic reflectors in the lithospheric mantle interpreted as the continuation of normal or, less frequently, inverse faults in the mantle. However the nature of these reflectors is poorly understood. There is a large discrepancy between the scale at which deformation processes are studied (a few kilometers, at most, due to the limited size of continuous mantle exposures at the Earth's surface) and the scale inferred for strain localization in the mantle from geophysical observations (tens of kilometers). Combining data on deformation microstructures and crystal preferred orientations in naturally deformed peridotites and seismologic observations allows nevertheless discussing strain localization processes that may play a role on the development of mantle shear zones.
ISSN: 0040-1951

hal-00750314
https://hal.archives-ouvertes.fr/hal-00750314
DOI : 10.1016/j.tecto.2012.06.006