Éditeur(s) : HAL CCSD American Geophysical Union (AGU) AGU and the Geochemical Society
Résumé : International audience
To study how an impacting plume modifies the mantle lithosphere, we analyzed the microstructures and crystal preferred orientations (CPO) of 29 peridotites and 37 pyroxenites that sample the mantle root of the Ontong Java Plateau (OJP) from 60 to 120 km depth. The peridotites show a strong compositional variability, but homogeneous coarse granular to tabular microstructures, except for those equilibrated at the shallowest and deepest depths, which are porphyroclastic. All peridotites have clear olivine CPO, with dominant fiber-[010] patterns. Low intragranular misorientations and straight grain boundaries in olivine suggest that, above 100 km depth, annealing often followed deformation. Calculated density and P wave velocities of the peridotites decrease weakly with depth. S wave velocities decrease faster, resulting in increasing Vp/Vs ratio with depth. Calculated densities and seismic velocity profiles are consistent with those estimated for normal mantle compositions under a cold oceanic geotherm. Enrichment in pyroxenites may further increase seismic velocities. The calculated seismic properties cannot therefore explain the low S waves velocities predicted by Rayleigh wave tomography and ScS data in the mantle beneath the OJP. Calculated P and S waves anisotropy is variable (2–12%). It is higher on average in the deeper section of the lithosphere. Because olivine has dominantly [010]-fiber CPO patterns, if foliations are horizontal, vertically propagating S waves and Rayleigh waves will sample very weak anisotropy in the OJP mantle lithosphere. Moreover, if the orientation of the lineation changes with depth, the anisotropy-induced contrast in seismic properties might produce an intralithospheric reflector marking the stratification of the OJP mantle root.
ISSN: 1525-2027

hal-01116428
https://hal.archives-ouvertes.fr/hal-01116428
DOI : 10.1002/2014GC005452

Éditeur(s) : HAL CCSD Elsevier
Résumé : International audience
This study analyses the interactions between deformation and reactive fluid and melt percolation, and their effects on sub-arc mantle seismic properties based on microstructural observations on mantle xenoliths extracted by the Tubaf and Edison seamounts close to the Lihir Island, in the Papua New Guinea archipelago. These xenoliths sample an oceanic lithosphere, which has experienced high-temperature deformation in the presence of fluids or melts. This was followed by metasomatism under static conditions. Syn-kinematic percolation of reactive Si-rich melts or fluids in peridotites has produced pyroxene-enrichment, grain size reduction, and dispersion of olivine crystal preferred orientation (CPO). Fourier transform infrared spectroscopy analyses show that olivine has very low water contents (1-4 wt. ppm H2O), similar to spinel peridotites from other subduction zones. These low values may record both low water solubility in olivine at low pressure and dehydration during transport and exhumation. Water contents in pyroxenes are highly variable and likely result from spatially heterogeneous melt or fluid percolation. Analysis of olivine CPO indicates dominant activation of both (010)[100] and (001)[100] slip systems, which are characteristic of deformation under high temperature, low stress, low pressure and low to moderate hydrous conditions. Fast S-wave polarization and P- and Rayleigh propagation directions are thus parallel to the mantle flow direction. The pyroxene enrichment by melt-rock reactions is accompanied by dispersion of olivine CPO and induces a significant decrease of the maximum S-wave and P-wave anisotropy in the peridotites. The calculated seismic properties also show that the lowest Vp/Vs ratios (< 1.7) mapped in fore-arc mantle may only be explained by taking in consideration the CPO-induced elastic anisotropy of the peridotites.
ISSN: 0040-1951

hal-00950058
https://hal.archives-ouvertes.fr/hal-00950058
DOI : 10.1016/j.tecto.2013.09.024

Éditeur(s) : HAL CCSD European Geosciences Union
Résumé : International audience
We calculated the seismic properties of 47 mantle xenoliths from 9 kimberlitic pipes in the Kaapvaal craton based on their modal composition, the crystal-preferred orientations (CPO) of olivine, ortho- and clinopyroxene, and garnet, the Fe content of olivine, and the pressures and temperatures at which the rocks were equilibrated. These data allow constraining the variation of seismic anisotropy and velocities within the cratonic mantle. The fastest P and S2 wave propagation directions and the polarization of fast split shear waves (S1) are always subparallel to olivine [100] axes of maximum concentration, which marks the lineation (fossil flow direction). Seismic anisotropy is higher for high olivine contents and stronger CPO. Maximum P wave azimuthal anisotropy (AVp) ranges between 2.5 and 10.2% and the maximum S wave polarization anisotropy (AVs), between 2.7 and 8%. Changes in olivine CPO symmetry result in minor variations in the seismic anisotropy patterns, mainly in the apparent isotropy directions for shear wave splitting. Seismic properties averaged over 20 km-thick depth sections are, therefore, very homogeneous. Based on these data, we predict the anisotropy that would be measured by SKS, Rayleigh (SV) and Love (SH) waves for five endmember orientations of the foliation and lineation. Comparison to seismic anisotropy data from the Kaapvaal shows that the coherent fast directions, but low delay times imaged by SKS studies, and the low azimuthal anisotropy with with the horizontally polarized S waves (SH) faster than the vertically polarized S wave (SV) measured using surface waves are best explained by homogeneously dipping (45°) foliations and lineations in the cratonic mantle lithosphere. Laterally or vertically varying foliation and lineation orientations with a dominantly NW-SE trend might also explain the low measured anisotropies, but this model should also result in backazimuthal variability of the SKS splitting data, not reported in the seismological data. The strong compositional heterogeneity of the Kaapvaal peridotite xenoliths results in up to 3% variation in density and in up to 2.3% variation of Vp, Vs, and Vp / Vs ratio. Fe depletion by melt extraction increases Vp and Vs, but decreases the Vp / Vs ratio and density. Orthopyroxene enrichment due to metasomatism decreases the density and Vp, strongly reducing the Vp / Vs ratio. Garnet enrichment, which was also attributed to metasomatism, increases the density, and in a lesser extent Vp and the Vp / Vs ratio. Comparison of density and seismic velocity profiles calculated using the xenoliths' compositions and equilibration conditions to seismological data in the Kaapvaal highlights that (i) the thickness of the craton is underestimated in some seismic studies and reaches at least 180 km, (ii) the deep sheared peridotites represent very local modifications caused and oversampled by kimberlites, and (iii) seismological models probably underestimate the compositional heterogeneity in the Kaapvaal mantle root, which occurs at a scale much smaller than the one that may be sampled seismologically.
ISSN: 1869-9510

hal-01053516
https://hal.archives-ouvertes.fr/hal-01053516
DOI : 10.5194/se-5-45-2014

Éditeur(s) : HAL CCSD Oxford University Press (OUP)
Résumé : We present a regional surface waveform tomography of the Pacific upper mantle, obtained using an automated multimode surface waveform inversion technique on fundamental and higher mode Rayleigh waves, to constrain the VSV structure down to ∼400 km depth. We have improved on previous implementations of this technique by robustly accounting for the effects of uncertainties in earthquake source parameters in the tomographic inversion. We have furthermore improved path coverage in the South Pacific region by including Rayleigh wave observations from the French Polynesian Pacific Lithosphere and Upper Mantle Experiment deployment. This improvement has led to imaging of vertical low-velocity structures associated with hotspots within the South Pacific Super-Swell region. We have produced an age-dependent averagecross-sectionforthePacificOceanlithosphereandfoundthattheincreaseinVSV with age is broadly compatible with a half-space cooling model of oceanic lithosphere formation. We cannot confirm evidence for a Pacific-wide reheating event. Our synthetic tests show that detailed interpretation of average VSV trends across the Pacific Ocean may be misleading unless lateral resolution and amplitude recovery are uniform across the region, a condition that is difficult to achieve in such a large oceanic basin with current seismic stations.
ISSN: 0956-540X

hal-00105949
https://hal.archives-ouvertes.fr/hal-00105949
https://hal.archives-ouvertes.fr/hal-00105949/document
https://hal.archives-ouvertes.fr/hal-00105949/file/Maggi_Pacif_tomo_GJI2006.pdf
DOI : 10.1111/j.1365-246X.2006.03037.x

Éditeur(s) : Amer Geophysical Union
Résumé : We quantify, analyze, and characterize the frequency-dependent microseismic noise recorded by worldwide distributed seismic stations. Microseismic noise is generated through the interaction of ocean waves. It is the strongest ambient noise, and it is observed everywhere on Earth. We introduce a new approach which permits us to detect polarized signals in the time-frequency domain and which we use to characterize the microseismic noise. We analyze 7 years of continuous seismograms from the global GEOSCOPE network. Microseisms are dominated by Rayleigh waves, and we therefore focus on elliptically polarized signals. The polarized signals are detected in the time-frequency domain through a degree of polarization measure. We design polarization spectra and show that microseismic noise is more strongly polarized than noise in other frequency bands. This property is used to measure the directions of the polarized noise at individual stations as a function of time and frequency. Seasonal variations are found for the back azimuths and for the number of polarized signals at many stations. We show that the back azimuth directions are robust measurements that point toward the source areas computed from ocean wave models.
Geochemistry Geophysics Geosystems (1525-2027) (Amer Geophysical Union), 2011-07 , Vol. 12 , N. Q07014 , P. 14 p.

Droits : 2011. American Geophysical Union. All Rights Reserved.
http://archimer.ifremer.fr/doc/00041/15219/12713.pdf
DOI:10.1029/2011GC003661
http://archimer.ifremer.fr/doc/00041/15219/

Éditeur(s) : HAL CCSD Oxford University Press (OUP)
Résumé : International audience
The Eastern Rift System (ERS) of northern Tanzania and southern Kenya, where a cratonic lithosphere is in the early stages of rifting, offers an ideal venue for investigating the roles of magma and other fluids in such an environment. To illuminate these roles, we jointly invert arrival times of locally recorded P and S body waves, phase delays of ambient noise generated Rayleigh waves and Bouguer anomalies from gravity observations to generate a 3-D image of P and S wave speeds in the upper 25 km of the crust. While joint inversion of gravity and arrival times requires a relationship between density and wave speeds, the improvement in resolution obtained by the combination of these disparate data sets serves to further constrain models, and reduce uncertainties. The most significant features in the 3-D model are (1) P and S wave speeds that are 10–15 per cent lower beneath the rift zone than in the surrounding regions, (2) a relatively high wave speed tabular feature located along the western edge of the Natron and Manyara rifts, and (3) low (∼1.71) values of Vp/Vs throughout the upper crust, with the lowest ratios along the boundaries of the rift zones. The low P and S wave speeds at mid-crustal levels beneath the rift valley are an expected consequence of active volcanism, and the tabular, high-wave speed feature is interpreted to be an uplifted footwall at the western edge of the rift. Given the high levels of CO2 outgassing observed at the surface along border fault zones, and the sensitivity of Vp/Vs to pore-fluid compressibility, we infer that the low Vp/Vs values in and around the rift zone are caused by the volcanic plumbing in the upper crust being suffused by a gaseous CO2 froth on top of a deeper, crystalline mush. The repository for molten rock is likely located in the lower crust and upper mantle, where the Vp/Vs ratios are significantly higher.
ISSN: 0956-540X

hal-01622055
https://hal.archives-ouvertes.fr/hal-01622055
https://hal.archives-ouvertes.fr/hal-01622055/document
https://hal.archives-ouvertes.fr/hal-01622055/file/roeckerGJI2017.pdf
DOI : 10.1093/gji/ggx220