Éditeur(s) : HAL CCSD Elsevier
Résumé : International audience
During the early years of the Iceland Deep Drilling Project (IDDP), development of three distinctive technological and scientific approaches were formalised and then carried out until 2010 within a European funded project called HiTI (high temperature instruments for supercritical geothermal reservoir characterisation and exploitation). These approaches were: (1) development of several downhole instruments allowing them to function up to 300 ◦C and 400 ◦C, (2) identification of two new Na/Li cation ratio geothermometric relationships valid at very high temperature, (3) tracer testing with high temperature tolerant organic isomers and finally and (4) basalt rock deformation and petrophysical properties laboratory investigations at high temperature and pressure conditions.
ISSN: 0375-6505

hal-00921127
https://hal-brgm.archives-ouvertes.fr/hal-00921127
DOI : 10.1016/j.geothermics.2013.07.008

Éditeur(s) : HAL CCSD American Geophysical Union
Résumé : International audience
The brittle to ductile transition (BDT) in rocks may strongly influence their transport properties (i.e., permeability, porosity topology ...) and the maximum depth and temperature where hydrothermal fluids may circulate. To examine this transition in the context of Icelandic crust, we conducted deformation experiments on a glassy basalt (GB) and a glass-free basalt (GFB) under oceanic crust conditions. Mechanical and micro-structural observations at a constant strain rate of 10(-5) s(-1) and at confining pressure of 100-300 MPa indicate that the rocks are brittle and dilatant up to 700-800 degrees C. At higher temperatures and effective pressures the deformation mode becomes macroscopically ductile, i.e., deformation is distributed throughout the sample and no localized shear rupture plane develops. The presence of glass is a key component reducing the sample strength and lowering the pressure of the BDT. In the brittle field, strength is consistent with a Mohr-Coulomb failure criterion with an internal coefficient of friction of 0.42 for both samples. In the ductile field, strength is strain rate-and temperature-dependent and both samples were characterized by the same stress exponent in the range 3 < n < 4.2 but by very different activation energy Q(GB) = 59 +/- 15 KJ/mol and Q(GFB) = 456 +/- 4 KJ/mol. Extrapolation of these results to the Iceland oceanic crust conditions predicts a BDT at similar to 100 degrees C for a glassy basalt, whereas the BDT might occur in non-glassy basalts at deeper conditions, i.e., temperatures higher than 550 +/- 100 degrees C, in agreement with the Icelandic seismogenic zone.
ISSN: 0148-0227

hal-00760905
https://hal.archives-ouvertes.fr/hal-00760905
DOI : 10.1029/2011JB008884

Éditeur(s) : HAL CCSD Geological Society of America
Résumé : International audience
Fluid-rock interactions can control earthquake nucleation and the evolution of earthquake sequences. Experimental studies of fault frictional properties in the presence of fluid can provide unique insights into these interactions. We report the first results from experiments performed on cohesive silicate-bearing rocks (microgabbro) in the presence of pressurized pore fluids (H2O, drained conditions) at realistic seismic deformation conditions. The experimental data are compared with those recently obtained from carbonate-bearing rocks (Carrara marble). Contrary to theoretical arguments, and consistent with the interpretation of some field observations, we show that frictional melting of a microgabbro develops in the presence of water. In microgabbro, the initial weakening mechanism (flash melting of the asperities) is delayed in the presence of water; conversely, in calcite marble the weakening mechanism (brittle failure of the asperities) is favored. This opposite behavior highlights the importance of host-rock composition in controlling dynamic (frictional) weakening in the presence of water: cohesive carbonate-bearing rocks are more prone to slip in the presence of water, whereas the presence of water might delay or inhibit the rupture nucleation and propagation in cohesive silicate-bearing rocks.
ISSN: 0091-7613

hal-01054327
https://hal.archives-ouvertes.fr/hal-01054327
DOI : 10.1130/G34916.1

Éditeur(s) : HAL CCSD
Résumé : International audience
In order to improve our knowledge on the vertebral development, structure and mineralization in Acipenseriformes, we undertook a study in a growth series of reared Siberian sturgeons (Acipenser baerii) using in toto clear and stain specimens, histological and ultrastructural observations, X-ray micro-tomography, and solid state NMR analyses. Scutes were also studied to compare the tissue structure and mineralization of endoskeletal and dermal skeletal elements. This study completes and clarifies previous investigations on vertebral development and architecture in sturgeons, and brings original data on the structure of (i) the perichondral bone that is progressively deposited around the vertebral elements during ontogeny, (ii) the typical cartilage composing these elements, and (iii) the scutes. In addition we provide data on the mineralization process, on the nature of the bone mineral phase, and on the growth dynamics of the vertebral elements.
THE ANATOMICAL RECORD

hal-01429958
http://hal.upmc.fr/hal-01429958
DOI : 10.1002/ar.23515

Éditeur(s) : HAL CCSD American Geophysical Union
Résumé : International audience
We performed 31 friction experiments on glassy basalts (GB) and glass-free basalts (GFB) at slip rates up to 6.5 m s−1 and normal stress up to 40 MPa (seismic conditions). Frictional weakening was associated to bulk frictional melting and lubrication. The weakening distance (Dw) was about 3 times shorter in GB than in GFB, but the steady state friction was systematically higher in GB than in GFB. The shorter Dw in GB may be explained by the thermal softening occurring at the glass transition temperature (Tg ~500°C), which is lower than the bulk melting temperature (Tm ~1250°C) of GFB. Postexperiment microanalyses suggest that the larger crystal fraction measured in GB melts results in the higher steady state friction value compared to the GFB melts. The effect of interstitial glass is to facilitate frictional instability and rupture propagation in GB with respect to GFB.
ISSN: 0094-8276

hal-01054139
https://hal.archives-ouvertes.fr/hal-01054139
DOI : 10.1002/2013GL058601

Éditeur(s) : HAL CCSD Springer Verlag
Résumé : International audience
Electrical resistivity soundings are used by geophysicists to determine the structure and composition of the Earth's crust and mantle and to explore natural resources (ore, oil, gas, water). Their interpretations in terms of composition and in-situ physical conditions depend mainly on laboratory measurements of electrical conductivity of rocks at simulated crustal conditions of temperature, pressure, saturation and pore pressures. These measurements present a numbers of limitations, in particular, in the case where conductive pore fluids are present, as in the case of deep reservoir conditions, where temperature exceeds 250 A degrees C. Here, we present a new cell capable of measuring electrical conductivity of large saturated samples at confining pressure up to 200 MPa, pore pressure up to 50 MPa, and temperature up to 500 A degrees C. The measurement cell has been developed in a commercial, internally heated, gas pressure apparatus (Paterson press). It is based on the concept of "guard ring" electrode, which is adapted to samples that are jacketed by a very conductive, metallic material. Numerical modeling of the current flow in the electrical cell allowed defining the optimal cell geometry. Calibration tests have been performed on Fontainebleau sandstones saturated with electrolytes of different conductivities, up to 350 A degrees C. The resulting electrical formation factor and temperature dependence of electrical conductivity are in very good agreement with previous studies. This new cell will improve the exploration and exploitation of deep fluid reservoirs, as in unconventional, high enthalpy geothermal fields. In particular, the investigations address possible effects of fluid-rock interactions on electrical resistivity of a reservoir host rock.
ISSN: 0169-3913

hal-00681997
https://hal.archives-ouvertes.fr/hal-00681997
DOI : 10.1007/s11242-011-9846-2