Éditeur(s) : HAL CCSD Oxford University Press (OUP)
Résumé : International audience
ISSN: 0956-540X

hal-01187132
https://hal.archives-ouvertes.fr/hal-01187132

Éditeur(s) : HAL CCSD Oxford University Press (OUP)
Résumé : International audience
Sensitive instruments like strainmeters and tiltmeters are necessary for measuring slowly varying low amplitude Earth deformations. Nonetheless, laser and fibre interferometers are particularly suitable for interrogating such instruments due to their extreme precision and accuracy. In this paper, a practical design of a simple pendulum borehole tiltmeter based on laser fibre interferometric displacement sensors is presented. A prototype instrument has been constructed using welded borosilicate with a pendulum length of 0.85 m resulting in a main resonance frequency of 0.6 Hz. By implementing three coplanar extrinsic fibre Fabry-Perot in-terferometric probes and appropriate signal filtering, our instrument provides tilt measurements that are insensitive to parasitic deformations caused by temperature and pressure variations. This prototype has been installed in an underground facility (Rustrel, France) where results show accurate measurements of Earth strains derived from Earth and ocean tides, local hydro-logic effects, as well as local and remote earthquakes. The large dynamic range and the high sensitivity of this tiltmeter render it an invaluable tool for numerous geophysical applications such as transient fault motion, volcanic strain and reservoir monitoring.
ISSN: 0956-540X

hal-01265967
https://hal.archives-ouvertes.fr/hal-01265967
https://hal.archives-ouvertes.fr/hal-01265967/document
https://hal.archives-ouvertes.fr/hal-01265967/file/HCS1.pdf
DOI : 10.1093/gji/ggv358

Éditeur(s) : HAL CCSD
Résumé : International audience
A fiber interferometer interfaced to 3 geo-mechanical elements is presented for applications in geophysics. The fiber sensor is based on an extrinsic fiber Fabry-Perot interferometer (EFFPI) which incorporates a modulation scheme to lock the interferometer at quadrature and to enable displacement measurements below a quarter of the interrogating wavelength. It operates over a relatively large frequency dynamic of ~500000 with a precision better than 2 nm. The fiber interferometer is next interfaced to a differential hydrostatic long baseline inclinometer, a 3-axis borehole tiltmeter and a single-axis seismometer, respectively. Results obtained demonstrate that the fiber interferometrically-interrogated instruments exhibit performances equivalent to or even surpassing those of the reference instruments employed for comparison during their deployment to an underground test site since March 2012. Keywords—modulation-based extrinsic fiber Fabry-Perot interferometer; fiber optique hydrostatic inclinometer; fiber optique borehole tiltmeter; fiber optique seismometer
IEEE SENSORS 2015
Busan, South Korea

hal-01265963
https://hal.archives-ouvertes.fr/hal-01265963
https://hal.archives-ouvertes.fr/hal-01265963/document
https://hal.archives-ouvertes.fr/hal-01265963/file/HCS3.pdf
DOI : 10.1109/ICSENS.2015.7370316

Éditeur(s) : HAL CCSD Optical Society of America
Résumé : This Letter describes a dual-amplitude modulation technique incorporated into a double reflection extrinsic-type fiber Fabry-Perot interferometer to measure periodic, nonperiodic as well as quasi-static displacements. The modulation scheme simultaneously maintains the interference signal pair in quadrature and provides a reference signal for displacements inferior to a quarter of the source wavelength. The control and phase demodulation of the interferometer carried out via software enable quasi-real-time measurement and facilitates sensor alignment. The sensor system can be exploited in the low frequency range from 10−3 to ∼500 Hz and has a resolution better than 2.2 nm, targeting applications in geophysics.
ISSN: 0146-9592

hal-00758140
https://hal.archives-ouvertes.fr/hal-00758140
DOI : 10.1364/OL.37.002886

Éditeur(s) : HAL CCSD
Résumé : Monitoring crustal deformation during the interseismic phase when searching for earth transients requires precise instruments able to operate for very long periods. The ANR-LINES project aimed to develop three new instruments: a single-axis seismometer, a hydrostatic long base tiltmeter and a borehole pendulum tiltmeter. These three instruments benefit of an extrinsic Fabry-Pérot interferometer (EFFPI) with long optic fibers for displacement detections. Their mechanical architectures and their disposal of long fibers help these newly manufactured geophysical instruments complete their goals. The first objective of this study is to propose appropriate methods for estimating the phase of the optical path in the Fabry-Pérot cavities. A modulation of the laser diode current, followed by a homodyne demodulation of the interference signal and a Kalman filter, allow determining the phase in real time. The results are convincingwhile taking short periods measurements but require additional solutions for protection against environmental phenomena variations. The EFFPI sensor integrated in the LINES borehole tiltmeter gives it the opportunity to establish a differential measurement of the bob's oscillation thanks to three Fabry-Perot cavities. The LINES seismometer also uses the EFFPI displacement sensor to measure its coil's displacement. A description of the two instruments' mechanical structures and an analysis of the detected phenomena (slow movements, tides, earthquakes, microseisms . . . ) are part of this thesis.
Le suivi de la déformation de la croûte terrestre durant la phase intersismique pour la recherche des transitoires nécessite des instruments précis capables d'opérer pour de très longues durées. Le projet ANR-LINES a visé le développement de trois nouveaux instruments : un sismomètre mono-axial, un inclinomètre hydrostatique à longue base et un inclinomètre de forage pendulaire. Ces trois instruments profitent d'un capteur interférométrique de déplacement à longues fibres optiques du type Fabry-Pérot Extrinsèque (EFFPI). Leurs architectures mécaniques et l'utilisation de longues fibres permettent à ces instruments géophysiques nouvellement fabriqués d'atteindre les objectifs fixés. Le premier objectif de cette étude est de proposer des méthodes adaptées à l'estimation de la phase du chemin optique dans les cavités Fabry-Pérot. Une modulation du courant de la diode laser, suivie par une démodulation homodyne du signal d'interférence et un filtre de Kalman permettent de déterminer la phase en temps réel. Les résultats sont convaincants pour des mesures de courtes durées mais exigent des solutions complémentaires pour se prémunir des effets de la variation des phénomènes environnementaux. Le capteur EFFPI intégré dans l'inclinomètre de forage LINES lui offre l'opportunité d'établir une mesure différentielle de l'oscillation de la masselotte pendulée grâce à trois cavités Fabry-Pérot. Le sismomètre LINES utilise lui aussi le capteur de déplacement EFFPI pour la mesure du déplacement de sa bobine. Une description de l'architecture mécanique de ces instruments et une analyse des phénomènes détectés (mouvements lents, marées, séismes, microséismes . . . ) font partie de cette thèse.
https://tel.archives-ouvertes.fr/tel-00779335

tel-00779335
https://tel.archives-ouvertes.fr/tel-00779335
https://tel.archives-ouvertes.fr/tel-00779335/document
https://tel.archives-ouvertes.fr/tel-00779335/file/Manuscript_Chawah.pdf