Éditeur(s) : HAL CCSD Royal Society, The
Résumé : International audience
Infectious marine diseases can decimate populations and are increasing among some taxa due to global change and our increasing reliance on marine environments. Marine diseases become emergencies when significant ecological, economic or social impacts occur. We can prepare for and manage these emergencies through improved surveillance, and the development and iterative refinement of approaches to mitigate disease and its impacts. Improving surveillance requires fast, accurate diagnoses, forecasting disease risk and real-time monitoring of disease-promoting environmental conditions. Diversifying impact mitigation involves increasing host resilience to disease, reducing pathogen abundance and managing environmental factors that facilitate disease. Disease surveillance and mitigation can be adaptive if informed by research advances and catalysed by communication among observers, researchers and decision-makers using information-sharing platforms. Recent increases in the awareness of the threats posed by marine diseases may lead to policy frameworks that facilitate the responses and management that marine disease emergencies require.
ISSN: 0962-8436

hal-01282464
https://hal-univ-perp.archives-ouvertes.fr/hal-01282464
DOI : 10.1098/rstb.2015.0364

Éditeur(s) : HAL CCSD Royal Society of Chemistry
Résumé : International audience
Low-level water measurements of geological materials are fundamental in understanding the volatile inventories of the Earth from the mantle to crustal reservoirs. Here we describe the development of microanalytical techniques using the new SHRIMP SI ion microprobe to measure the abundances of OH− (as a proxy for water) in volcanic glass and nominally anhydrous minerals (NAMs). Samples were first analysed at the Carnegie Institute of Washington (CIW) on their Cameca ims-6f with calibrations based on previous FTIR and manometry analyses. SHRIMP SI is a large geometry ion microprobe and is currently mainly used for O and S isotope analyses. The analytical protocol used here incorporates multiple collection of 16O− and 16O1H− allowing rapid measurements. A single calibration line incorporating all glasses and NAMs for the SHRIMP SI allows calibration of 16O1H−/16O− to H2O over a wide range in concentration (50 to 15 000 ppm H2O). This calibration line has around a 10% uncertainty, which appears to be limited only by sample heterogeneity. The current background for SHRIMP analysis is between 20–40 ppm but this is expected to improve with improved pumping on the source chamber. A current limitation to water analysis of NAM samples, by any technique, is having a range of standard materials to enable OH− calibration to absolute H2O concentrations. Data are presented for 7 NAM samples (2 olivines, 2 orthopyroxenes and 3 clinopyroxenes) that appear to be promising as potential standards for international laboratory H2O measurements. These NAM samples have been analysed and characterised here by SHRIMP SI, FTIR, EMP and the Cameca ims-6f ion microprobe at CIW. Four of these samples have previously been measured by manometry to determine absolute H2O concentrations.
ISSN: 0267-9477

hal-01243514
https://hal.archives-ouvertes.fr/hal-01243514
DOI : 10.1039/c5ja00047e

Éditeur(s) : HAL CCSD
Résumé : International audience
Seismic anisotropy is a ubiquitous feature of the subcontinental mantle. This can be inferred both from direct seismic observations of shear wave splitting from teleseismic shear waves, as well as the petrofabric analyses of mantle nodules from kimberlite pipes. The anisotropy is principally due to the strain-induced lattice preferred orientation (LPO) of olivine. The combined use of these mantle samples, deformation experiments on olivine, and numerical modeling of LPO, provides a critical framework for making inferences about mantle deformation from observed seismic anisotropy. In most cases there is a close correspondence between mantle deformation derived from seismic observations of anisotropy, and crustal deformation, from the Archean to the present. This implies that the mantle plays a major, if not dominant role in continental deformation. No clear evidence is found for a continental asthenospheric decoupling zone, suggesting that continents are probably coupled to general mantle circulation.
Mantle Petrology: Field Observations and high Pressure experimentations: a Tribute to Francis R. (Joe) Boyd

hal-01391514
http://hal.univ-reunion.fr/hal-01391514
http://hal.univ-reunion.fr/hal-01391514/document
http://hal.univ-reunion.fr/hal-01391514/file/Silver_et_al_BoydVolume 1999_hal.pdf

Éditeur(s) : HAL CCSD American Geophysical Union
Résumé : International audience
We have analyzed shear wave splitting recorded by portable and permanent broadband and long-period stations located in the eastern United States. Teleseismic shear waves (SKS, SKKS, and PKS) were used to retrieve the splitting parameters: the orientation of the fast wave polarization plane ϕ and the delay time δt. In total, 120 seismic events were processed, allowing for more than 600 splitting measurements. Within the Appalachians, stations located in the western (external) part are characterized by δt≈1s and ϕ trending N50°– 70°E in the south and central regions and N30°–40°E in the north, closely following the trend of the orogenic belt in these areas. The transition region between north and central is characterized by δt≈1–1.3 s and by E-W trending ϕ that are at a high angle to the regional geologic trend. Measurements at two stations located in the eastern (internal) part of the belt indicate very weak anisotropy. The large-scale pattern of anisotropy is not consistent with that predicted for simple asthenospheric flow beneath the plate. Splitting along the southern and eastern margins of the continent is consistent with that expected for Grenvillian deformation, an alternative model of asthenospheric flow around the cratonic keel cannot be ruled out. Within the cratonic core, the correlation between δt and lithospheric thickness suggests a lithospheric anisotropy. Smaller-length-scale variations also argue for a significant contribution of lithospheric structures. The fabric responsible for shear wave splitting may have formed during tectonic episodes that affected the eastern United States, i.e., the Grenville and Appalachian orogenies and the subsequent rifting of the North Atlantic Ocean. Our observations in the western Appalachians suggest that the anisotropy may be preserved since the Grenvillian orogeny. The absence of detectable splitting in the two stations in the eastern Appalachians is attributed to the igneous intrusions related to the Atlantic rifting. The measurements in the transition between the northern and central southern Appalachians, constitute an intriguing anomaly, whose E-W ϕ have little obvious relation to the regional surface geology. We suggest two possible causes: (1) the local dominance of asthenospheric flow, motivated by the proximity of a pervasive low-velocity anomaly and (2) lithospheric deformation in a transcontinental strike-slip fault zone active during the Appalachian collision.
ISSN: 2169-9313

hal-01388859
http://hal.univ-reunion.fr/hal-01388859
http://hal.univ-reunion.fr/hal-01388859/document
http://hal.univ-reunion.fr/hal-01388859/file/Barruol_JGR_1997.pdf
DOI : 10.1029/96JB03800

Éditeur(s) : HAL CCSD Elsevier
Résumé : International audience
Displacement-length data from dilatant fractures (joints, veins, igneous dikes) and several varieties of deformation bands were analyzed statistically to investigate the applicability of mechanical models proposed for their formation. All 17 datasets are generally consistent with equilibrium or long-term power-law slopes on the displacement-length diagram of either 1.0 or 0.5. Similar to many faults, disaggregation deformation bands are consistent with a power-law scaling relation having a slope of approximately c = 1, implying a linear dependence of maximum displacement and discontinuity length (Dmax = γL). In contrast, dilatant fractures, cataclastic deformation bands, and shear-enhanced compaction bands are consistent with a power-law scaling relation with a slope of approximately c = 0.5, implying a dependence of maximum displacement on the square root of length (Dmax = αL1/2). The scaling relations represent an average, or long-term equilibrium outcome of deformation for conditions such as length-scale, time-scale, temperature, chemistry, and an effectively homogeneous far-field stress field, allowing for variations such as rapid and/or localized behaviors. The displacement-length scaling of these geologic structures follows systematic relationships that provide information on host-rock properties and the physics of fracture and deformation-band propagation.
ISSN: 0191-8141

hal-00818130
https://hal.archives-ouvertes.fr/hal-00818130
DOI : 10.1016/j.jsg.2012.12.005

Éditeur(s) : HAL CCSD Elsevier
Résumé : International audience
Melting experiments were performed on a silica-rich peridotite composition at 10-17 GPa to determine majoritic garnet-melt partition coefficients (D) for major and trace elements. Our results show that D for many elements, including Na, Sc, Y and rare earth elements (REE), varies significantly with increasing pressure or proportion of majorite component. Lu and Sc become incompatible at 17 GPa, with D decreasing from 1.5 at 10 GPa to 0.9 at 17 GPa. As predicted from lattice strain, log D for isovalent cations entering the large site of majoritic garnet exhibits a near-parabolic dependence on ionic radius. Our data are used to refine a previously published predictive model for garnet-melt partitioning of trivalent cations, which suffered from a lack of calibration in the 10-20 GPa range. Our results suggest that Archean Al-depleted komatiites from Barberton (South Africa) may have been generated by partial melting of dry peridotite at depths between 200 and 400 km. We also speculate that transition zone diamonds from Kankan (Guinea), which contain inclusions of majoritic garnet, may have formed from the partial reduction of CO2-rich magmas that subsequently transported them to the surface. This hypothesis would provide an explanation for the REE patterns of majoritic garnet trapped within these diamonds, including Eu anomalies. Finally, we show that segregation of majoritic garnet-bearing cumulates during crystallisation of a deep Martian magma ocean could lead to a variety of Lu/Hf and Sm/Nd ratios depending on pressure, leading to a range of ε143Nd and ε176Hf isotope signatures for potential mantle sources of Martian rocks.
ISSN: 0024-4937

hal-00767567
https://hal.archives-ouvertes.fr/hal-00767567
DOI : 10.1016/j.lithos.2012.06.013

Éditeur(s) : HAL CCSD Springer-Verlag
Résumé : International audience
High-resolution borehole strainmeters are usually installed in tectonically active regions in order to detect slow-slip events, and to estimate slow transients related to earthquake swarms. However, they are also sensitive to other numerous influences, internal or external. Furthermore, the quality of their coupling to the rock through cementation, and the mechanical properties of the rock mass around them, have a critical influence on their records. Many of the existing strainmeters present such problems, and the correction for these effects often remains a challenge. In this paper, we present the analysis of the records of a high-resolution borehole dilatometer (Sacks–Evertson), located in the seismically active rift of Corinth (Greece) (station TRZ in the Trizonia island). We show that the instrument suffers from an only partial-solid coupling, and that the nearby sea tides have a direct (through elastic response) and indirect (through pore-pressure diffusion) effect on the dilatation signal, which adds up to the solid tidal strain source. We propose a methodology that allows, in a first step, to better separate the internal (solid tide) from the external (air pressure, sea level) influences, by calculating a frequency-dependent transfer function outside the range of the tidal periods. We then extrapolate this function, in particular at the tidal periods. In a second step, the resulting variation with frequency of the coupling coefficients with sea level led us to estimate the proportion of instrument not solidly cemented to rock (thus in contact with water pore pressure), which is about 90 % of the total height. Despite the small proportion of solid coupling, the sensor resolution remains very good up to a few tens of hours of a time period, thanks to the confining effects of the rocks on the local pore pressure. These results allow us to correct for the external effects, and reduce the associated variance by 80–90 % (in the period range of minutes to days). The empirical correction of the sea level effect could be explained using a simple Boussinesq’s approximation and 1D pore-pressure diffusion model, which contributed to better constraint of some of the poro-elastic parameters in the vicinity of the instrument. After correction, the solid tidal signal at the 24-h period is almost anti-correlated with those of the theoretical solid tide. This surprising result is consistent with a similar anti-correlation observed for the longest period surface waves (200 s) comparing the TRZ dilatometer signals to the strain measured by a nearby borehole strainmeter (MOK, 15 km). This could be related to the presence of a shallow fault close to the instrument, which would creep in response to seismic wave-related stress.
ISSN: 0033-4533

hal-01122853
https://hal.archives-ouvertes.fr/hal-01122853
DOI : 10.1007/s00024-013-0742-2