Éditeur(s) : HAL CCSD Seismological Society of America
Résumé : International audience
Abstract The continuous record of large surface-rupturing earthquakes along the Dead Sea fault brings unprecedented insights for paleoseismic and archaeoseismic research. In most recent studies, paleoseismic trenching documents the late Holocene faulting activity, while tectonic geomorphology addresses the long-term behavior (>10 ka), with a tendency to smooth the effect of individual earthquake rupture events (Mw >7). Here, we combine historical, archaeological, and paleoseismic investigations to build a consolidated catalog of destructive surface-rupturing earthquakes for the last 14 ka along the left-lateral Jordan Valley fault segment. The 120- km-long fault segment limited to the north and the south by major pull-apart basins (the Hula and the Dead Sea, respectively) is mapped in detail and shows five subsegments with narrow stepovers (width < 3 km). We conducted quantitative geomorphology along the fault, measured more than 20 offset drainages, excavated four trenches at two sites, and investigated archaeological sites with seismic damage in the Jordan Valley. Our results in paleoseismic trenching with 28 radiocarbon datings and the archaeoseismology at Tell Saydiyeh, supplemented with a rich historical seismic record, document 12 surface-rupturing events along the fault segment with a mean interval of ∼1160 yr and an average 5 mm=yr slip rate for the last 25 ka. The most complete part of the catalog indicates recurrence intervals that vary from 280 yr to 1500 yr, with a median value of 790 yr, and suggests an episodic behavior for the Jordan Valley fault. Our study allows a better constraint of the seismic cycle and related short-term variations (late Holocene) versus long-term behavior (Holocene and late Pleistocene) of a major continental transform fault.
ISSN: 0037-1106

hal-00747401
https://hal.archives-ouvertes.fr/hal-00747401
DOI : 10.1785/0120100097

Éditeur(s) : HAL CCSD Oxford University Press (OUP)
Résumé : Approximately 4 yr of campaign and continuous Global Positioning System (GPS) measurements across the Dead Sea fault system (DSFS) in Lebanon provide direct measurements of interseismic strain accumulation along a 200-km-long restraining bend in this continental transform fault. Late Cenozoic transpression within this restraining bend has maintained more than 3000 m of topography in the Mount Lebanon and Anti-Lebanon ranges. The GPS velocity field indicates 4-5 mm yr(-1) of relative plate motion is transferred through the restraining bend to the northern continuation of the DSFS in northwestern Syria. Near-field GPS velocities are generally parallel to the major, left-lateral strike-slip faults, suggesting that much of the expected convergence across the restraining bend is likely accommodated by different structures beyond the aperture of the GPS network (e.g. offshore Lebanon and, possibly, the Palmyride fold belt in SW Syria). Hence, these geodetic results suggest a partitioning of crustal deformation involving strike-slip displacements in the interior of the restraining bend, and crustal shortening in the outer part of the restraining bend. Within the uncertainties, the GPS-based rates of fault slip compare well with Holocene-averaged estimates of slip along the two principal strike-slip faults: the Yammouneh and Serghaya faults. Of these two faults, more slip occurs on the Yammouneh fault, which constitutes the primary plate boundary structure between the Arabia and Sinai plates. Hence, the Yammouneh fault is the structural linkage that transfers slip to the northern part of the transform in northwestern Syria. From the perspective of the regional earthquake hazard, the Yammouneh fault is presently locked and accumulating interseismic strain.
ISSN: 0956-540X

hal-00406620
https://hal.archives-ouvertes.fr/hal-00406620
DOI : 10.1111/j.1365-246X.2006.03328.x

Éditeur(s) : HAL CCSD AGU and the Geochemical Society
Résumé : International audience
Analysis of short-term deformation along the southern part of Dead Sea Fault (DSF) provides a systematic view of kinematics this part of the continental transform. The southern DSF consists of two principal segments: the Wadi Araba and Jordan Valley faults. In addition to other regional continuous GPS data, this study uses new data from 25 survey sites and 4 continuous GPS stations in Jordan for improved near-field observations. Resulting velocities are reported with 1-sigma uncertainties ranging from 0.4-1.0 mm/yr. Application of elastic dislocation models yields estimates of slip rates for Wadi Araba and Jordan Valley faults are 4.9 +/- 0.4 mm/yr and 4.7 +/- 0.4 mm/yr, respectively. Modeling also suggests different depths of effective fault locking with 15 +/- 5 km and 8 +/- 5 km for the Wadi Araba and Jordan Valley faults, respectively. These slip rates are generally consistent with the upper end of the range of slip rates estimated from late Quaternary geology. Spatial variations in effective fault locking generally correspond with a heterogeneous mantle lithosphere. A similar observation can be observed along the southern San Andreas Fault, and this may reflect the influence of heterogeneity in the uppermost mantle on crustal faulting processes.
ISSN: 1525-2027

hal-00689031
https://hal.archives-ouvertes.fr/hal-00689031
DOI : 10.1029/2011GC003736