Éditeur(s) : HAL CCSD Elsevier
Résumé : SUBSURF
Statistical sequential analysis was performed on a series of sediment cores collected from the Têt prodelta in the Gulf of Lions, northwestern Mediterranean Sea, between October 2003 and October 2004. Seabed changes during that period were correlated to hydrodynamic conditions (waves and currents) and river discharge. Low sediment supply prevents full preservation of new sediment strata on this low-accumulation prodelta located on a microtidal, storm-dominated inner shelf. Severe meteorological events caused a rapid succession of erosion and deposition phases. For example, the December 2003 flood and storm produced a flood layer deposit that persisted for 2 months with only slight transformations due to early diagenesis and/or bioturbation, until a new storm event eroded this layer. A typical sedimentary sequence was observed for the secular deposits composed of a 10-cm-thick sandy layer overlaying siltyclayey layers. These characteristic features were used to analyse the last millennia sedimentary record of the Têt prodelta. The low preservation of freshly deposited sediments and variable sedimentation rates during the last millennia period yield a sedimentary sequence formed by the outcropping of muddy prodeltaic units intersected by heterogeneous siltysandy units similar to those formed under present day hydrodynamic conditions. No flood layer was found related to catastrophic flooding of the last century in the sedimentary record. The Little Ice Age ( 1550–1850 AD) probably favoured the formation of a well-developed muddy prodelta in the mouth of the Têt River. Later on, the decrease of sediment supply by rivers due to climate change and/or human activities (damming, irrigation), and the increase of the number of high-energy storms reaching the coast, induced a coarsening of the top sediment layer on this prodelta. This modern change of the substrate is also observed in the composition of benthic biota found in the substrate
ISSN: 0025-3227

hal-00407662
https://hal.archives-ouvertes.fr/hal-00407662
DOI : 10.1016/j.margeo.2007.04.009

Éditeur(s) : HAL CCSD
Résumé : SilviLaser 2015, La Grande Motte, FRA, 28-/09/2015 - 30/09/2015
International audience
The study provides technical guidelines to optimize sampling design parameters in the context of the implementation of biomass predictive models from airborne lidar data. Parameters under study were those easily controlled when implementing an area-based approach, i.e. lidar pulse density and both field sampling protocols and measurements. Parameters most impacting the model accuracy were identified by conducting a one-factor- at -a-time and a global sensitivity analyses. Number and size of field plot, and plot center position accuracy were identified to be the parameters most impacting model accuracy.
Proceedings of silviLaser 2015. Durrieu S. et Véga, C. (eds)
La Grande Motte, France

hal-01286833
https://hal.archives-ouvertes.fr/hal-01286833
https://hal.archives-ouvertes.fr/hal-01286833/document
https://hal.archives-ouvertes.fr/hal-01286833/file/mt2015-pub00046522.pdf
IRSTEA : PUB00046522