Éditeur(s) : HAL CCSD Elsevier
Résumé : International audience
We use first first-principle methods and the Peierls-Nabarro model to evaluate the resistance to glide, characterized by the Peierls stress, of glide systems for end-member MgSiO3 Perovskite at mantle pressures. [010](100) is the easiest glide system in Mg-Perovskite at all pressures. Peierls stresses increase systematically with pressure for all systems except [001](010), indicating the importance of lattice friction at lower mantle pressures. The ratio of the maximum Peierls stress for each system relative to the [010](100) value defines their critical resolved shear stress (CRSS). These CRSS are used in a visco-plastic self-consistent homogenization model to predict the evolution of crystal preferred orientations (CPO) during deformation of polycrystalline Mg-Perovskite. In axial compression, [100] tends to align with the compression direction, in agreement with in situ observations in axial compression experiments. In simple shear, [010] concentrates near the shear direction and (100), although more dispersed, tends to align near the shear plane, consistent with the dominant activity of the easier [010](100) system. The calculated seismic anisotropy for a 100% Mg-Perovskite aggregate using the CPO in simple shear and the elastic constants Of MgSiO3 perovskite at lower mantle pressures and temperatures is weak (>3% for P-waves with and >2% for S-waves) and decreases with increasing temperature and pressure. P-waves show the fastest propagation parallel to the lineation and S-waves fast polarization is in the foliation at 38 GPa and normal to the lineation at 88 GPa. This weak anisotropy is consistent with global seismological observations of a nearly isotropic lower mantle. There are however two regions where strain-induced Mg-Perovskite CPO could contribute to anisotropy; a) low temperature regions in the uppermost lower mantle, where the predicted S-wave polarization anisotropy may attain 1.6% with a fast polarization parallel to the foliation, b) in high high-temperature domains in the D '' layer, where Mg-Perovskite may be the major stable phase, leading to polarization of fast S-waves normal to the lineation for propagation directions at high angle to the lineation and an apparent isotropy for all other propagation directions.
ISSN: 0012-821X

hal-00411460
https://hal.archives-ouvertes.fr/hal-00411460
DOI : 10.1016/j.epsl.2008.03.058

Éditeur(s) : HAL CCSD American Geophysical Union
Résumé : International audience
Using first principle simulations we calculated the elasticity of chlorite. At a density ρ~ 2.60 g cm−3, the elastic constant tensor reveals significant elastic anisotropy: VP ~27%, VS1 ~56%, and VS2 ~43%. The shear anisotropy is exceptionally large for chlorite and enhances upon compression. Upon compression, the shear elastic constant component C44 and C55 decreases, whereas C66 shear component stiffens. The softening in C44 and C55 is reflected in shear modulus, G, and the shear wave velocity, VS. Our results on elastic anisotropy at conditions relevant to the mantle wedge indicates that a 10-20 km layer of hydrated peridotite with serpentine and chlorite could account for the observed shear polarization anisotropy and associated large delay times of 1-2 s observed in some subduction zone settings. In addition, chlorite could also explain the low VP/VS ratios that have been observed in recent high-resolution seismological studies.
ISSN: 0094-8276

hal-01053707
https://hal.archives-ouvertes.fr/hal-01053707
https://hal.archives-ouvertes.fr/hal-01053707/document
https://hal.archives-ouvertes.fr/hal-01053707/file/Mookherjee_et_al-2014-Geophysical_Research_Letters.pdf
DOI : 10.1002/2014GL059334

Éditeur(s) : HAL CCSD Elsevier
Résumé : International audience
We investigated the response of the crystal structure, lattice parameters, and unit-cell volume of hydrous layered silicate phlogopite at conditions relevant to subduction zone settings. We have used first principles simulation based on density functional theory to calculate the equation of state and full elastic constant tensor. Based on the generalized gradient approximation, the full single crystal elastic constant tensor with monoclinic symmetry shows significant anisotropy with the compressional elastic constants: c11 = 181 GPa, c22 = 185 GPa, c33 = 62 GPa, the shear elastic constants c44 = 14 GPa, c55 = 20 GPa, c66 = 68 Ga, and c46 = −6 GPa; the off diagonal elastic constants c12 = 48 GPa, c13 = 12 GPa, c23 = 12 GPa, c15 = −16 GPa, c25 = −5 GPa and c35 = −1 GPa at zero pressure. The elastic anisotropy of phlogopite is larger than most of the layered hydrous phases relevant in the subduction zone conditions. The shear anisotropy, AVS for phlogopite is ∼77% at zero pressure condition and although it decreases upon compression it remains relatively high compared to other hydrous phases relevant in the subduction zone settings. We also note that the shear elastic constants for phlogopite are relatively low. Phlogopite also has a high isotropic bulk VP/VS ratio ∼2.0. However, the VP/VS ratio also exhibits significant anisotropy with values as low as 1.49. Thus, phlogopite bearing metasomatized mantle could readily explain unusual VP/VS ratio as observed from seismological studies from the mantle wedge regions of the subduction zone.
ISSN: 0031-9201

hal-01115670
https://hal.archives-ouvertes.fr/hal-01115670
DOI : 10.1016/j.pepi.2014.05.004

Éditeur(s) : HAL CCSD Elsevier
Résumé : International audience
In this study, we propose a theoretical approach to test the validity of the isomechanical analogues for post-perovskite structures. Intrinsic plastic properties are evaluated for three materials exhibiting a post-perovskite phase: MgSiO3, MgGeO3 and CaIrO3. Dislocation properties of each structure are determined using the Peierls-Nabarro model based on first-principles calculations of generalised stacking fault and the plastic properties are extended to crystal-preferred orientations using a visco-plastic self-consistent method. This study provides intrinsic parameters of plastic deformation such as dislocation structures and Peierls stresses that can be directly compared between the three materials. It appears that it is very difficult to draw any simple conclusions on polycrystalline deformation simply by comparing single crystal properties. In particular, contrasting single crystal properties of MgSiO3 and CaIrO3 lead to similar crystal-preferred orientation of the polycrystal aggregates.
ISSN: 0031-9201

hal-00420104
https://hal.archives-ouvertes.fr/hal-00420104
DOI : 10.1016/j.pepi.2008.04.003

Éditeur(s) : HAL CCSD Elsevier
Résumé : The dense hydrous magnesium silicate called the D phase is the most likely candidate to recycle hydrogen into the lower mantle in subduction zones. As seismology represents the preferred method to detect this mineral in subduction zones, the single crystal elastic tensor has been calculated using first principle methods. A triple cell (View the MathML source) was used to account for an ordered ideal composition of the D phase to lower mantle pressures. The elastic tensor of the mineral at ambient conditions is predicted to be C11 = 387.7, C33 = 287.7, C44 = 100.4, C12 = 108.0, C13 = 51.1, C14 = − 14.6 in GPa with bulk modulus at zero pressure Ko = 163 GPa and a statistical error of about 4.0 GPa for all constants. The pressure derivatives of the elastic constants have been determined to pressure of 80 GPa. Our tensor correctly predicts the published experimental measurements of linear compressibility along the a- and c-axes, the logarithmic pressure derivative of the c/a axial ratio and bulk modulus at zero pressure. It contradicts the experimentally measured elastic tensor reported by (Liu, L.-G., Okamoto, K., Yang, Y.-J., Chen, C.-C., Lin, C.-C., 2004. Elasticity of single-crystal phase D (a dense hydrous magnesium silicate) by Brillouin spectroscopy. Solid State Commun. 132, 517–520), which fails to reproduce the experimental compressibility data. Using the elastic constants and density predicted to 85 GPa, the seismic anisotropy of P- and S-waves has been calculated as a function of pressure. The single crystal has high P-wave velocities and shear wave splitting in the basal plane below 20 GPa. At high pressures, the maximum P-wave velocities have threefold symmetry normal to a-axes in the basal plane, whereas the maximum shear wave splitting is parallel to a-axes with twofold symmetry. The D phase has high Vp and Vs anisotropy at ambient pressure, 17.6% for Vp and 19.9% for Vs. The Vp anisotropy decreases with increasing pressure to about 30 GPa, while it remains constant at 8% from 30 to 85 GPa. The Vs anisotropy decreases to 17% at 20 GPa and then increases to 22% at 85 GPa. The isotropic velocity ratios of S to P (Rs/p), bulk sound to S (Rphi/s) and density to S (Rρ/s) are calculated as a function of pressure. The Rs/p shows very little variation with pressure with low value of 0.6, whereas both Rphi/s and Rρ/s increase with pressure to peak values of 2.8 and 2.0 respectively at about 60 GPa. The presence of the D phase in subducted horizontal ‘stagnant' plates in the circum Pacific could contribute to a number of seismic observations, such as the observed velocity heterogeneity at depths between 500 and 1000 km and the fast S-waves travelling horizontally with horizontal polarization in this depth range. Further the lower density of the D phase compared with anhydrous minerals could influence buoyancy of the hydrated ‘stagnant' slabs. The transformation of the D phase to perovskite plus ferripericlase during thermal annealing may be responsible for horizontal slab seismogenesis.
ISSN: 0012-821X

hal-00406379
https://hal.archives-ouvertes.fr/hal-00406379
DOI : 10.1016/j.epsl.2007.04.053

Résumé : This document is written for and at the request of the Central Committee of Maritime Fishing. Yet it is also addressed to regional institutions, several of which would like to equip themselves with an economic monitor. In his "report on the modernisation of the Interprofessional Organisation of Fishing and Marine Farming", the president of the CCPM makes the development of economic information one of the main principles of reform. At the same time, a growing number of regional authorities wish to equip themselves with economic monitors, with the concern of controlling the management and future of their sector of fishing and marine farming. The two problems are similar insomuch as: (i) it is a matter, in both cases, of responding to the same questions: - what information? - according to what means of collection, processing and distribution? - to what ends? (ii) although the concerns at regional and national levels differ, they are interdependent: - the report on modernisation foresees a devolution of competencies to the regional level; - the information needs of each of the levels will be partially satisfied by information available in the other. The first part of this document examines the concerns to which economic and social information should respond; the second addresses the building of indicators likely to help the responsible parties through clarification of the choices and arbitrages they must confront. The references marked in the text refer to publications containing many illustrations of types of information, indicators, economic calculations and models.
(OCR non controlé) Ce document est rédigé à l'attention et à la demande du Comité Central des Pêches Maritimes. Toutefois, il s'adresse également aux institutions régionales, dont plusieurs souhaiteraient se doter d'un observatoire économique. Dans son «rapport sur la modernisation de l'Organisation Interprofessionnelle des Pêches et Cultures Marines», le Président du CCPM fait du développement de l'information économique, l'un des principes essentiels de la réforme. Dans le même temps, un nombre croissant d'autorités régionales sont désireuses de se doter d'observatoires économiques , dans le souci de maîtriser la gestion et le devenir de leur secteur des pêches et cultures marines. Les deux problèmes se rejoignent dans la mesure où: (i) il s'agit, dans les deux cas, de répondre aux mêmes questions: - quelle information? - selon quelles modalités de recueil, traitement et diffusion? - pour quelles finalités? (ii) si les préoccupations des niveaux régional et national diffèrent, elles sont interdépendantes: - le rapport sur la modernisation prévoit une déconcentration des compétences au niveau régional; - les besoins d'information de chacun des niveaux seront partiellement satisfaits par l'information disponible dans l'autre. La première partie de ce document examine les préoccupations auxquelles devrait répondre l'information économique et sociale; la seconde traite de la construction des indicateurs susceptibles d'assister les responsables par un éclairage des choix et des arbitrages auxquels ils ont à faire face. Les références indiquées dans le texte renvoient à des publications contenant de nombreuses illustrations des types d'information, d'indicateurs, de calcul économique et de modèles.

Droits : info:eu-repo/semantics/openAccess
http://archimer.ifremer.fr/doc/1989/rapport-2477.pdf
http://archimer.ifremer.fr/doc/00000/2477/