Éditeur(s) : HAL CCSD American Institute of Physics
Résumé : International audience
ISSN: 0003-6951

hal-01680699
https://hal.univ-antilles.fr/hal-01680699
DOI : 10.1063/1.4818716

Éditeur(s) : HAL CCSD Institute of Physics
Résumé : International audience
ISSN: 0957-4484

hal-01674723
https://hal-umontpellier.archives-ouvertes.fr/hal-01674723
DOI : 10.1088/1361-6528/aa9c07

Éditeur(s) : HAL CCSD American Institute of Physics
Résumé : International audience
ISSN: 0021-8979

hal-01685831
https://hal.univ-antilles.fr/hal-01685831
DOI : 10.1063/1.363195

Éditeur(s) : HAL CCSD Institute of Physics: Open Access Journals
Résumé : International audience
The Amazon river basin has been recently affected by extreme climatic events, such as the exceptional drought of 2005, with significant impacts on human activities and ecosystems. In spite of the importance of monitoring freshwater stored and moving in such large river basins, only scarce measurements of river stages and discharges are available and the signatures of extreme drought conditions on surface freshwater dynamics at the basin scale are still poorly known. Here we use continuous multisatellite observations of inundation extent and water levels between 2003 and 2007 to monitor monthly variations of surface water storage at the basin scale. During the 2005 drought, the amount of water stored in the river and floodplains of the Amazon basin was ~130 km3 (~70%) below its 2003-7 average. This represents almost a half of the anomaly of minimum terrestrial water stored in the basin as estimated using the Gravity Recovery and Climate Experiment (GRACE) data.
Environmental Research Letters

hal-00779275
https://hal.archives-ouvertes.fr/hal-00779275
https://hal.archives-ouvertes.fr/hal-00779275/document
DOI : 10.1088/1748-9326/7/4/044010

Éditeur(s) : HAL CCSD American Institute of Physics
Résumé : International audience
In order to be able to provide valuable data in multiparameter measurement field operations, tiltmeters need to have a noise level better or equal than 10-9 rad for a period range from a few minutes to a few years and a long term stability ranging from 10-7 to 10-8 rad/yr. Tiltmeter measurements should also be as much as possible insensitive to thermal disturbances, by taking great care of the horizontality of the base line tube first. Secondly, thermal responses have been assessed. We also took great care of the coupling of our tiltmeters with the bedrock. We've designed a long base tiltmeter with sensors in silica which has a low dilatation coefficient. The linear variable displacement transducer is based on coil coupling (powered by an alternative voltage). Finally we show the results of two 100 m silica water tube tiltmeters which were installed in a mine in the French Vosges massif in the framework of a hydrology research project. These instruments show a remarkably good stability (6.5×10-9 rad/month) and a low noise level (of the order of 10-11 rad). Toroidal and spheroidal free modes of the Earth were observed after the two last major earthquakes on Sumatra.
ISSN: 0034-6748

hal-00708013
https://hal.archives-ouvertes.fr/hal-00708013
https://hal.archives-ouvertes.fr/hal-00708013/document
https://hal.archives-ouvertes.fr/hal-00708013/file/2008_RSI.pdf
BIBCODE : 2008RScI...79c4502B

Éditeur(s) : HAL CCSD American Institute of Physics
Résumé : International audience
ISSN: 0034-6748

hal-01685780
https://hal.univ-antilles.fr/hal-01685780
DOI : 10.1063/1.1637436

Éditeur(s) : HAL CCSD American Institute of Physics
Résumé : International audience
Laser-induced periodic surface structures (LIPSS) were formed on Cu/Si or Cu/glass thin films using Nd:YAG laser beam (40 ps, 10Hz, and 30mJ/cm2). The study of ablation threshold is always achieved over melting when the variation of the number of pulses increases from 1 to 1000. But the incubation effect is leading to reduce the threshold of melting as increasing the number of laser pulse. Also, real time reflectivity signals exhibit typical behavior to stress the formation of a liquid phase during the laser-processing regime and helps to determine the threshold of soft ablation.Atomic Force Microscopy (AFM) analyses have shown the topology of the micro-crater containing regular spikes with different height. Transmission Electron Microscopy (TEM) allows finally to show three distinguished zones in the close region of isolated protrusions. The central zone is a typical crystallized area of few nanometers surrounded by a mixed poly-crystalline and amorphous area. Finally, in the region far from the protrusion zone, Cu film shows an amorphous structure. The real time reflectivity, AFM, and HR-TEM analyses evidence the formation of a liquid phaseduring the LIPSS formation in the picosecond regime. VC 2015 AIP Publishing LLC
ISSN: 0003-6951

hal-01226065
https://hal.archives-ouvertes.fr/hal-01226065
DOI : 10.1063/1.4935413