Éditeur(s) : HAL CCSD Wiley-Blackwell
Résumé : International audience
In order to constrain interpretations of seismic reflection records more effectively, the seismic properties of a middle crustal section exposed in the Saint Barthélémy Massif have been determined. The massif, transected by a 200 m thick shear zone has been systematically sampled for density measurements and modal analysis has been performed in order to define the spatial variations of physical properties. Seismic velocities (Vp, V5, shear wave birefringence), have been measured on five representative samples to 600 MPa and 600°C simultaneously in the three structural directions (X, Y and Z). For two samples, the expep.mental data have been compared with calculated values, based on petrofabric analyses. The Lattice Preferred Orientation (LPO) is determined using universal stage, electron channelling microscopy and neutron diffraction goniometry. Using the experimental and calculated velocity data, we establish a lateral homogeneous anisotropie model.
ISSN: 0954-4879

hal-01389722
http://hal.univ-reunion.fr/hal-01389722
http://hal.univ-reunion.fr/hal-01389722/document
http://hal.univ-reunion.fr/hal-01389722/file/Barruol_aniso_St_Barthelemy_TerraNova1992_hal.pdf
DOI : 10.1111/j.1365-3121.1992.tb00451.x

Éditeur(s) : HAL CCSD Elsevier
Résumé : International audience
To quantify the relationships between anisotropy. S-wave splitting and tectonics, we determined the seismic properties of lower-crustal and upper-mantle rocks outcropping in the lvrea Zone (Northem Italy). We obtained P-and S-wave seismic velocities by laboratory direct velocity measurements and/or by calculations based on the modal compositions of the rocks, the lattice preferred orientations (LPOs), and the single crystal stiffness coefficients. Measured P-and S-wave velocities (6.0-7 .5 km s-1 and 3.6-4.2 km s-1) are typical of the lower crust. The P-wave anisotropy is in the range 0-l 0%. Shear-wave birefringence is in the range 0.0-0.6 km s-1 , with typical values between 0.0 and 0.2 km s-1 • In many cases, the birefringence is clearly related to fabric elements (foliation, lineation). Mafic rocks such as anorthosite or pyroxene-bearing gabbros exhibit low P-wave anisotropies (< 5%) and low shear-wave birefringences (less than 0.1 km s-1). In contrast, the seismic properties of felsic rocks such as biotite-bearing gneisses and mafic rocks such as amphibolites display high V P anisotropy (10%) and strong birefringence (0.3 km s-1). Biotite and amphibole preferred orientations clearly control seismic anisotropy and particularly shear-wave splitting. In these rocks, maximum splitting is observed in directions parallel to the foliation with the fast split shear wave polarized parallel to the foliation plane. To have an overview of the seismic properties of this lower-crustal section at a broader scale, we calculated from our data the anisotropie seismic properties of several hypothetical samples that are perhaps more representative of the regional anisotropy than each sample individually. For instance, the average lower-crustal sample displays an anisotropy of 5.5% for P waves and a birefringence around 0.14 km s I for S waves propagating parallel to the foliation. We observe little splitting for waves propagating at high angle to the foliation.
ISSN: 0031-9201

hal-01389712
http://hal.univ-reunion.fr/hal-01389712
http://hal.univ-reunion.fr/hal-01389712/document
http://hal.univ-reunion.fr/hal-01389712/file/Barruol_Kern-PEPI96_hal.pdf
DOI : 10.1016/0031-9201(95)03124-3