Éditeur(s) : HAL CCSD Elsevier
Résumé : International audience
The southernmost part of the Ryukyu subduction, where the Philippine Sea Plate is subducting under the Eurasian Plate, is known to be a very seismically active region of transition from a north-dipping subduction along the Ryukyu subduction to an ~ SE-NW collision along the Taiwanese orogenic wedge. In this paper, we will focus on the Ryukyu forearc area close to Taiwan where the deformation is paroxysmal. In order to decipher the nature of the seismic deformation in this region, a three month passive experiment, combining 22 Ocean Bottom Seismometers and 51 onland stations, has been led. Starting from an a-priori heterogeneous model, we have obtained 801 well-located earthquake hypocenters, a precise P-wave tomography model and 14 focal mechanisms. The seismicity along the Ryukyu forearc is mainly located not only in the vicinity of the Interplate Seismogenic Zone (ISZ) but also within both the subducting PSP and the overriding plate. Seismicity within the upper-plate is essentially localized east of Nanao basin where NW-SE extension occurs, and northwest of the Hoping basin where strike-slip dominates. As revealed by both the P-wave velocity structure and the newly derived seismicity, we argue that a sub-vertical step offsetting the subducting PSP around 10 km may support the presence of a trench-parallel tear. The PSP also undergoes extension in its upper part that is probably caused by buckling and slab pull. The P-wave velocity structure reveals three other major features: (1) a continuity between the Central Range and the Ryukyu Arc with a shallower Moho (~ 30 km depth) between ~ 122.3°N and ~ 122.5°N along the Ryukyu Arc, (2) high P-wave velocities along the eastern side of the Central Range and, (3) two bodies with similar high crustal velocities (6.5-7.0 km/s) at 12-18 km depths, embedded within the Ryukyu arc basement, just north of Hoping Basin and north of the Nanao Basin.
ISSN: 0040-1951

hal-00795521
https://hal.archives-ouvertes.fr/hal-00795521
DOI : 10.1016/j.tecto.2012.04.011

Éditeur(s) : HAL CCSD American Geophysical Union (AGU)
Résumé : International audience
Detailed seafloor mapping in the area east of Taiwan revealed trench-parallel stretching and folding of the Ryukyu forearc and lateral motion of the accretionary wedge under oblique convergence. East of 122ø40'E, a steep accretionary wedge is elongated in an E-W direction. A major transcurrent right-lateral strike-slip fault accommodates the strain partitioning caused by an oblique convergence of 40 ø. A spectacular out-of-sequence thrust may be related to the subduction of a structural high lying in the axis of the N-S trending Gagua Ridge. This asperity is likely responsible for the uplift of the accretionary wedge and forearc basement and may have augmented strain partitioning by increasing the coupling between the two plates. West of 122ø40'E, the low-taper accretionary wedge is sheared in a direction subparallel to the convergence vector with respect to the Ryukyu Arc. The bayonet shape of the southern Ryukyu Arc slope partly results from the recent (re)opening of the southern Okinawa Trough at a rate of about 2 to 4 cm/yr. Right-lateral shearing of the sedimentary forearc with respect to the nonlinear Ryukyu backstop generates trench-parallel extension in the forearc sediment sequence at dilational jogs and trench-parallel folding at compressive jogs. The Hoping Basin lies above a diffuse trench/trench/fault (TTF) or TFF unstable triple junction moving toward the south along a N-S transform zone which accommodates the southward drift of the Ryukyu Arc with respect to Eurasia.
ISSN: 0278-7407

hal-01261555
https://hal.archives-ouvertes.fr/hal-01261555
https://hal.archives-ouvertes.fr/hal-01261555/document
https://hal.archives-ouvertes.fr/hal-01261555/file/Lallemand_et_al-1999-Tectonics.pdf
DOI : 10.1029/1998TC900011

Éditeur(s) : HAL CCSD Elsevier
Résumé : International audience
An active seismic experiment has been conducted across the southern Ryukyu margin east of Taiwan over the whole trench-arc-backarc system in May 2009. Twenty-four ocean bottom seismometers (OBS) were deployed from the Ryukyu trench to the southern Okinawa trough over the Ryukyu arc and forearc. Wide angle seismic data were recorded by the OBS array while coincident reflection seismic data were acquired using a 6 km long streamer and a 6600 cubic inch seismic airgun array. Results from tomographic inversion of 21091 travel time picks along this line allowed us to image crustal structures of the Ryukyu margin down to a depth of 25 km. The transect has been designed to provide a better seismic velocity structure of the subduction zone in a highly deformed area that has produced an M8 earthquake in 1920. The line crosses a seismic cluster of earthquakes which source mechanisms are still poorly understood. The subducting oceanic crust of the Huatung Basin is about 5-6 km thick. The underlying mantle exhibits low seismic velocities around 7.8 km/s suggesting some hydrothermal alterations or alteration of the upper mantle through faults generated by the flexure of the subducting plate as it enters the subduction. Low velocities, up to 4.5 km/s, associated with the accretionary wedge are well imaged from the trench back to the Nanao forearc. A major result concerns the abrupt termination of the buttress at the rear of the accretionary wedge. Despite the low resolution of the tomographic inversion near the subduction interface, several lines of evidence supporting the presence of a low velocity zone beneath the toe of the forearc buttress could be established. The Moho beneath the Ryukyu non-volcanic arc is located at a depth around 25 km depth.
ISSN: 0040-1951

hal-00795573
https://hal.archives-ouvertes.fr/hal-00795573
DOI : 10.1016/j.tecto.2011.10.010

Éditeur(s) : HAL CCSD Elsevier
Résumé : International audience
The active collision zone around Taiwan orogen receives a variety of sedimentary inputs, including terrigenous flux from Taiwan and Chinese rivers, oceanic currents and atmospheric dust. In order to determine the present-day respective contributions of these different sources, we analysed the Pb and Sr isotopic compositions of late Quaternary sediments accumulated offshore east Taiwan. Samples from the Taiwan Coastal Range (andesites, sandstones, conglomerate and Peinan River terraces and suspended loads) have also been analysed to constrain the mean Taiwan isotopic signature. Mixing lines between the different sources of material indicate that the core located in the Okinawa Trough represents a mixture of about 60% of Taiwan, 30% of Chinese Loess and 10% of Yangtze River contributions. The southernmost core, located close to Luzon Are, is influenced by Taiwan (60%) and volcanic material (40%). The Sr and Pb isotopic compositions of samples cored in the Manila Trench and in the Huatung Basin are strongly influenced by the Taiwan signature, while the Ryukyu Trench core samples point to significant but variable contributions of Chinese Loess and Yangtze River. This work also reports Zn isotopic variations in the silicate fraction of these marine core samples. The overall variation in Zn isotopic compositions (expressed as 666 Zn) is greater than 0.3 per mil (parts per thousand) for an analytical precision of +/- 0.05 parts per thousand. The Zn isotopic signal for most of the marine core samples is similar to the literature data measured on sedimentary material, except for the Manila Trench core samples and the older sample from the Huatung Basin: they present values heavier by 0.2-0.3 parts per thousand, close to those obtained on all Taiwan rocks and Peinan River particulates. These results show: 1- the particular characteristics of Taiwan Zn isotopic compositions on a large scale; and: 2- the possible use of Zn isotopes as a tracer of material sources.
ISSN: 0009-2541

hal-00412214
https://hal.archives-ouvertes.fr/hal-00412214
DOI : 10.1016/j.chemgeo.2007.10.024

Éditeur(s) : HAL CCSD Elsevier
Résumé : International audience
Absolute earthquake hypocenter locations have been determined in the area offshore eastern Taiwan, at the Southernmost Ryukyu subduction zone. Location process is run within a 3D velocity model by combining the Taiwanese and neighboring Japanese networks and using the 3D MAXI technique. The study focuses on the most active seismic cluster in the Taiwan region that occurs in the forearc domain offshore eastern Taiwan. Earthquakes distribute mainly along 2 active planes. The first one aligns along the subduction interface and the second one, shallower affects the overriding margin. Focal mechanisms within the shallow group indicate that nodal planes are either compatible with high-angle back-thrusts or low-angle thrusts. The active seismic deformation exclusively indicates reverse faulting revealing that the forearc basement undergoes trench-perpendicular strong compression. By integrating the seismological image into the regional context, we favor the hypothesis in which the dense seismicity occurring offshore marks the activity of en-échelon high-angle reverse faults accommodating the uplift of a broken piece of Ryukyu Arc basement, called Hoping Basement Rise. The uplift is inferred to be caused by the subduction of an oceanic relief, either exotic block, seamount or oceanic crust sliver. Our favored solution satisfies the narrowness of epicenter's cluster along the Hoping Canyon, and the observation of high-angle active faults on seismic lines crossing the area. Furthermore, this solution is compatible with the active uplift of the Hoping Rise demonstrated from morphological and sedimentological data. We do not exclude the branching of the high-angle reverse faults system onto a splay fault connected with the subduction interface but further investigations are needed to map precisely the 3D distribution of active faults that break the margin.
ISSN: 0040-1951

hal-00407726
https://hal.archives-ouvertes.fr/hal-00407726
DOI : 10.1016/j.tecto.2007.11.018

Éditeur(s) : HAL CCSD Wiley-Blackwell
Résumé : International audience
Physical modeling of oblique subduction is performed to study the mechanism of strain partitioning. The model is two-layer and includes the elasto-plastic lithosphere (the overriding and subducting plates) and the low-viscosity liquid asthenosphere. The subduction is driven by a push force from a piston and a pull force when the density contrast Ap between the subducting plate and the asthenosphere is positive. We vary both Ap and the interplate friction (frictional stresses). Slip partitioning is obtained only in the models with high interplate friction and only when the overriding plate contains a weak zone. This zone in the models corresponds either to locally thinned litho-sphere or to cut (fault). The horizontal, trench-normal component of the interplate friction force [Ffh[ can be comparable with the absolute value of the horizontal component of the nonhydrostatic interplate pressure force [Fph [ in the subduction zone. Ffh is always negative (compression), while Fph can be either negative (compressional subduction regime) or positive (extensional regime). High friction, which promotes partitioning, can completely cancel the extensional (suction) force Fph. Back arc tension and strike-slip faulting appear thus as conflicting processes, although they can coexist in the same subduction zone, depending on the relative values of relevant forces. It appears that high friction can exist only in compressional subduction zones where partitioning should develop more easily. This conclusion is supported by the comparison of two oblique subduction zones, having similar geometry: the compressional southern Kurile zone (strong partitioning) and extensional southern Ryukyu zone (no lithospheric-scale partitioning). Other factors controlling the strain partitioning are the length of the oblique subductlon zone, the boundary conditions at the transverse limits of the forearc sliver, and of course, the obliquity of subduction.
ISSN: 2169-9275

hal-01261396
https://hal.archives-ouvertes.fr/hal-01261396
https://hal.archives-ouvertes.fr/hal-01261396/document
https://hal.archives-ouvertes.fr/hal-01261396/file/chemendaJGR2000.pdf
DOI : 10.1029/1999JB900332