Éditeur(s) : HAL CCSD Springer Verlag (Germany) Springer Verlag
Résumé : Direct numerical simulations of flow through two millimeter-scale rock samples of limestone and sandstone are performed using three diverse fluid dynamic simulators. The resulting steady-state velocity fields are compared in terms of the associated empirical probability density functions (PDFs) and key statistics of the velocity fields. The pore space geometry of each sample is imaged at 5.06−μm voxel size resolution using X-ray microtomography. The samples offer contrasting characteristics in terms of total connected porosity (about 0.31 for the limestone and 0.07 for the sandstone) and are typical of several applications in hydrogeology and petroleum engineering. The three-dimensional fluid velocity fields within the explicit pore spaces are simulated using ANSYS® FLUENT® ANSYS Inc. (2009), EULAG Prusa et al. (Comput. Fluids 37, 1193–1207 2008), and SSTOKES Sarkar et al. (2002). These computational approaches are highly disperse in terms of algorithmic complexity, differ in terms of their governing equations, the adopted numerical methodologies, the enforcement of internal no-slip boundary conditions at the fluid-solid interface, and the computational mesh structure. As metrics of comparison to probe in a statistical sense the internal similarities/differences across sample populations of velocities obtained through the computational systems, we consider (i) integral quantities, such as the Darcy flux and (ii) main statistical moments of local velocity distributions including local correlations between velocity fields. Comparison of simulation results indicates that mutually consistent estimates of the state of flow are obtained in the analyzed samples of natural pore spaces despite the considerable differences associated with the three computational approaches. We note that in the higher porosity limestone sample, the structures of the velocity fields obtained using ANSYS FLUENT and EULAG are more alike than either compared against the results obtained using SSTOKES. In the low-porosity sample, the structures of the velocity fields obtained by EULAG and SSTOKES are more similar than either is to the fields obtained using ANSYS FLUENT. With respect to macroscopic quantities, ANSYS FLUENT and SSTOKES provide similar results in terms of the average vertical velocity for both of the complex microscale geometries considered, while EULAG tends to render the largest velocity values. The influence of the pore space structure on fluid velocity field characteristics is also discussed.
ISSN: 1420-0597

hal-01174152
https://hal.archives-ouvertes.fr/hal-01174152
DOI : 10.1007/s10596-015-9486-7

Éditeur(s) : HAL CCSD Elsevier
Résumé : International audience
Numerical programs for simulating flow and reactive transport in porous media is essential for predicting reservoir properties related to CO2 sequestration performance, subsurface storage and risk assessment. In this paper we solve the Navier Stokes' equation using finite difference method, on a simulated porous rock structure, to study the velocity distribution of fluid flowing through it under a constant pressure gradient. A reactive solute carried through the fluid is allowed to interact with the minerals in the rock. This chemical reaction dissolves the mineral which changes the rock structure thus affecting its flow properties. These changes of flow properties are studied with variation in reactive solute concentration and pressure field. The different mechanisms of dissolution responsible for the variation of flow properties for the different parameters is predicted. Before the onset of homogeneous dissolution, variation in porosity follows a power-law behaviour with change in permeability when the latter is scaled by the concentration of the reactive species. The simulation results are compared with available experimental data and found to give a reasonable match.
ISSN: 0022-1694

hal-00757760
https://hal.archives-ouvertes.fr/hal-00757760
DOI : 10.1016/j.jhydrol.2012.05.024

Éditeur(s) : HAL CCSD Elsevier
Résumé : International audience
In this paper we solve the Navier Stokes’ equation using finite difference method, on a simulated porous rock structure in 2-D, to study the velocity distribution of fluid flowing through it under a constant pressure gradient. A reactive solute carried through the fluid is allowed to interact with the minerals in the rock. Depending on the rock composition, both dissolution and precipitation reactions may occur. However precipitation occurs only through the cations that are released in the solution due to dissolution. These combined dissolution–precipitation reactions change the porosity, permeability and pore geometry of the sedimentary rock. We study the temporal changes of these properties as functions of Peclet number, concentration of the reactive solute and ratio of Damkholer numbers of dissolution to precipitation. The final flow property is decided by a combination of these parameters.
ISSN: 0022-1694

hal-01115291
https://hal.archives-ouvertes.fr/hal-01115291
DOI : 10.1016/j.jhydrol.2014.10.019