Éditeur(s) : HAL CCSD Springer Verlag (Germany) Springer Verlag
Résumé : International audience
Separated olivine grains from a deeply subducted serpentinized wehrlite (Changawuzi in the western Tianshan ultrahigh-pressure belt, China) were analysed with unpolarized transmission FTIR and the Ti contents were determined using LA-ICP-MS. The major bands in the olivine spectra display striking similarities to Ti-clinohumite and are interpreted as OH in lamellae. The quantification of the water content in lamellae requires calibration of the IR-absorption for such bands. We have obtained a new absorption coefficient for Ti-clinohumite of 0.125+/−0.017 ppm cm2 based on polarized FTIR measurements on three orthogonal sections through a large single crystal of Ti-clinohumite from Val Malenco, which has a known water content of 1.53 wt%. The resulting water content in olivine using this calibration factor ranges from 440 to 2,600 ppm and correlates positively with the Ti content that ranges from 130 to 1,400 ppm. For the quantification of the water content in Ti-chondrodite and Ti-clinohumite that are associated with olivine, we developed a new method using attenuated total reflectance FTIR spectroscopy. Ti-chondrodite and Ti-clinohumite display similar IR bands at ~3,562, 3,525 and ~3,583–3,586 cm−1. As in olivine, the water content and Ti content correlate in both Ti-clinohumite and Ti-chondrodite, indicating an intergrowth of these minerals, which has been confirmed by TEM analyses. Our results confirm previous suggestions that there is a strong correlation between the Ti content of ultramafic rocks and their capacity to transport water to the deeper mantle in subduction zones beyond conditions where hydrous phases are stable.
ISSN: 0010-7999

hal-01172237
https://hal.archives-ouvertes.fr/hal-01172237
DOI : 10.1007/s00410-014-0992-8

Éditeur(s) : HAL CCSD Oxford University Press (OUP)
Résumé : International audience
The southwestern Tianshan (China) metamorphic belt records high-pressure (HP) to ultrahigh-pressure (UHP) conditions corresponding to a cold oceanic subduction-zone setting. Serpentinites enclosing retrogressed eclogite and rodingite occur as lenses within metapelites in the UHP unit, which also hosts coesite-bearing eclogites. Based on the petrology and petrography of these serpentinites, five events are recognized: (1) formation of a wehrlite–harzburgite–dunite association in the mantle; (2) retrograde metamorphism and partial hydration during exhumation of the mantle rocks close to the seafloor; (3) oceanic metamorphism leading to the first serpentinization and rodingitization; (4) UHP metamorphism during subduction; (5) retrograde metamorphism during exhumation together with a second serpentinization. The peak metamorphic mineral assemblage of the serpentinized wehrlite comprises Ti-chondrodite + olivine + antigorite + chlorite + magnetite + brucite. A computed pseudosection for this serpentinized wehrlite shows that the Al content in antigorite is mostly sensititive to temperature but can also be used to constrain pressure. The average XAl = 0·204 ± 0·026 of antigorite (XAl = Al (a.p.f.u.)/8, where Al is in atoms per formula unit for a structural formula M48T34O85(OH)62, and M and T are octahedral and tetrahedral sites, respectively) included in Ti-chondrodite and average XAl = 0·203 ± 0·019 of antigorite in the matrix result in a well-constrained peak metamorphic temperature of 510–530°C. Peak pressures are less precisely constrained at 37 ± 7 kbar. The Tianshan serpentinites thus record UHP metamorphic conditions and represent the deepest subducted serpentinites discovered so far. The retrograde evolution occurs within the stability field of brucite + antigorite + olivine + chlorite and formation of Ti-clinohumite at the expense of Ti-chondrodite has been observed, suggesting isothermal decompression. The resulting P–T path is in excellent agreement with the metamorphic evolution of country rocks, indicating that the UHP unit in Tianshan was subducted and exhumed as a coherent block. To refine the metamorphic path of the ultramafic rocks, we have investigated the stability fields of Ti-chondrodite and Ti-clinohumite using piston-cylinder experiments. A total of 11 experiments were conducted at 25–55 kbar and 600–750°C in a F-free natural system. Combined with previous experiments and information from natural rocks we constructed a petrogenetic grid for the stability of Ti-chondrodite and Ti-clinohumite in F-free peridotite compositions. The formation of Ti-chondrodite in serpentinites requires a minimum pressure of about 26 kbar, whereas in Ti-rich systems it can form at considerably lower pressures. A key finding is that at UHP conditions, F-free Ti-chondrodite or Ti-clinohumite breaks down in the presence of orthopyroxene between 700 and 750°C, at temperatures that are significantly lower than those of the terminal breakdown reactions of these humite minerals. These breakdown reactions are an additional source of fluid during prograde subduction of serpentinites.
ISSN: 0022-3530

hal-01243507
https://hal.archives-ouvertes.fr/hal-01243507
DOI : 10.1093/petrology/egv042

Éditeur(s) : HAL CCSD Elsevier
Résumé : International audience
The Cerro del Almirez massif (Nevado–Filábride Complex, Betic Cordillera, SE Spain) is composed of antigorite (Atg-) serpentinite and chlorite (Chl-) harzburgite separated by a thin reaction front formed in a palaeo-subduction setting. These ultramafic rocks preserve unique prograde structures related to the pre- and peak high-pressure event (1.6–1.9 GPa and 680–710 °C). The oldest subduction-related structures are preserved in Atg-serpentinites: a penetrative S1 foliation and associated L1 stretching lineation that formed in a non-coaxial regime with a top-to-the-W sense of shear. This planar–linear fabric is crosscut by olivine ± Ti-clinohumite veins, formed during the prograde breakdown of brucite and pre-metamorphic clinopyroxene, which form a system of veins decimetres long. They record embrittlement processes due to the release of 6 vol.% of H2O associated with brucite dehydration. The growth of prograde olivine and/or tremolite porphyroblasts is syn- to post-kinematic in relation to the S1 foliation. Further reactions at higher temperature related to the complete breakdown of the Atg (i.e. Atg-out) are post-kinematic to S1. Prograde Chl-harzburgite is crosscut by sets of conjugate zones associated with grain-size reduction of olivine grains. These grain-size reduction zones are interpreted as brittle structures generated by hydrofracturing due to overpressure fluids in a compressional setting at low-differential stresses.Structures related to the exhumation process are mainly preserved in the metasedimentary host rock, where an S2/L2 planar–linear fabric developed within a shear zone dominated by a non-coaxial regime with a top-to-the-W sense of movement in a transpressional regime. Peak metamorphic conditions deduced for the schists are similar in pressure (1.3–1.9 GPa) but lower in temperature (560–590 °C) compared to the ultramafic rocks in contact with them, suggesting a major shear zone at the base of the ultramafic massif during D2 deformation in a right-handed transpressional regime.
ISSN: 0040-1951

hal-01172303
https://hal.archives-ouvertes.fr/hal-01172303
DOI : 10.1016/j.tecto.2014.12.022

Éditeur(s) : HAL CCSD Springer/Terra Scientific Publishing Company
Résumé : International audience
Titanian clinohumite is an accessory phase found in peridotites, and it can be a key repository of volatile and other trace elements in sub-arc mantle. To characterize spectroscopic variations due to volatile elements in the phase, we have investigated the infrared spectroscopic characteristics of a suite of naturally occurring Ti clinohumite minerals with varying F and Ti concentrations. Samples were ultramafic rocks from Cerro del Almirez, Spain and Cima di Gagnone, Switzerland. The infrared spectra corresponding to OH vibrations showed systematic variation in regard to the abundance of F in Ti clinohumite. In particular, the intensity ratios of infrared absorption spectra at 3,565 and 3,390 cm-1 correlated linearly with the abundance of F independently of the crystal orientation. Raman spectra did not corroborate the Fourier transform infrared (FTIR) results. This intensity ratio provides an alternative analytical criterion for the characterization of Ti clinohumite.
ISSN: 1343-8832

hal-01133685
https://hal.archives-ouvertes.fr/hal-01133685
DOI : 10.1186/1880-5981-66-60

Éditeur(s) : HAL CCSD Mineralogical Society of America
Résumé : International audience
The effect of trace concentrations of Ti on the rate and mechanism of hydrogen diffusion in pure forsterite was investigated experimentally. Forsterite doped with 350–400 ppm Ti (predominantly octahedral Ti3+, minor tetrahedral Ti4+) was prepared by diffusing Ti into pure synthetic forsterite at high temperature (1500 °C), very low oxygen fugacity (~QFM-5) at atmospheric pressure. The Ti-doped forsterite was then diffusively hydroxylated in a piston-cylinder apparatus at much lower temperatures (650–1000 °C) and higher oxygen fugacities, at 1.5–2.5 GPa, with chemical activities buffered by forsterite-enstatite or forsterite-periclase and partial pressure of H2O equal to total pressure. This produced hydrogen concentration-distance profiles of several hundred micrometers in length. Diffusion of hydrogen through the Ti-doped forsterite, even at very high Embedded Image , does not lead to redox re-equilibration of the high Ti3+/ΣTi ratio set during the synthesis of the starting material at extremely reducing conditions—the metastable point defects are partially preserved.Three main hydroxylated point defects are observed; hydroxyl is associated with Ti4+ (titano-clinohumite point defects), Ti3+ (and possibly other trivalent cations), and M-site vacancies. Concentration-distance profiles represent an interplay between diffusion and reaction (i.e., site rearrangement) to form the observed point defects. In all experiments, the concentration-distance profiles of the hydroxylated Ti defects coincide with the concentration-distance profiles of the M-site vacancy substitution, with the same crystallographic anisotropy. This suggests that the macroscopic movement of hydrogen through the crystal is due to one diffusion mechanism (the diffusion of hydroxylated M-site vacancies). The net H diffusion coefficient [logD(ΣH)], between 650–1000 °C, is Embedded Image where the values of logD0(ΣH) parallel to [100] and [001] directions are −3.0 ± 0.4 and −2.2 ± 0.4, respectively; diffusion is therefore around one order of magnitude faster along the c axis than along the a axis. The diffusion of hydrogen is slightly faster in Ti-doped forsterite than in pure forsterite. There is no effect of chemical activity or oxygen fugacity on the rate of diffusion. Hydrogen diffusion profiles represent a complex interplay between the movement of H through the crystal lattice and point-defect reactions to maintain charge balance.
ISSN: 0003-004X

hal-01467402
https://hal.archives-ouvertes.fr/hal-01467402
DOI : 10.2138/am-2016-55681571

Éditeur(s) : HAL CCSD Elsevier
Résumé : International audience
Synthetic hydroxylated titanium-bearing and undoped MgO-buffered forsterite crystals were heated at atmospheric pressure in air at temperatures from 800 to 1200 °C to determine hydrogen diffusion as a function of the type of point-defect mechanism by which the hydroxyl is incorporated. OH-stretching bands, measured by infrared spectroscopy, were assigned to the four substitution mechanisms: Ti-clinohumite point defects, silicon and magnesium vacancies, and point defects associated with trivalent cations. In the experiments at 800 to 1000 °C, hydrous defects related to trivalent cations and Mg-vacancies disappear first in the Ti-doped forsterite, followed by the hydrous defects related to Ti and a fraction of the hydrated Si-vacancies. Measured bulk diffusion coefficients for hydrogen exchange related to the latter process are one order of magnitude slower than previously reported and with higher activation energy (View the MathML source296±14 kJmol−1). After the elimination of the defects related to Ti, the hydroxyl concentration related to Si-vacancies remained constant for the duration of the experiments. This observation is in agreement with the very slow diffusivity of hydrogen in Si-vacancies measured in the undoped MgO-buffered dehydroxylation experiments at higher temperatures (from 1000 to 1200 °C), which were ∼3 orders of magnitude slower than previously reported at 1000 °C, and with an activation energy of View the MathML source461±11 kJmol−1. Hydrogen diffusion in forsterite is far more complex than previously assumed. This complexity can be used to gain more information on the timescales of the processes causing olivine to lose its structural “water”, but quantitative modeling will require not only the knowledge of the intrinsic diffusivities of the different hydrous defects but also their relative proportions and the possible reactions between them.
ISSN: 0012-821X

hal-01172253
https://hal.archives-ouvertes.fr/hal-01172253
DOI : 10.1016/j.epsl.2014.01.055