Éditeur(s) : HAL CCSD Elsevier
Résumé : International audience
In this paper, we determine dislocation core structures and Peierls stresses of wadsleyite, a high-pressure mineral present in the Earth mantle. We use a Peierls-Nabarro model combined with a finite-element method in which we introduce two-dimensional generalized stacking fault energies. Several potential slip planes of wadsleyite are considered. The results show that dislocations in this mineral can exhibit complex dislocation cores with linear or non-collinear dissociation and even three-dimensional dislocation cores. The calculation of the Peierls stresses gives information on the potential activity of slip systems governing the plasticity of wadsleyite. Our study confirms experimental observations that 1/2 < 1 1 1 >{1 0 1} is the easiest slip system in this structure at high-pressure and that [1 0 0](0 1 0) is the second easiest. Both these easily slip systems have dislocations that dissociate into collinear partial dislocations. In contrast [0 1 0] dislocations with very large Burgers vector (11.2 angstrom) are stabilized by complex dissociations involving four partial dislocations.
ISSN: 1359-6454

hal-00475548
https://hal.archives-ouvertes.fr/hal-00475548
DOI : 10.1016/j.actamat.2009.10.047

Éditeur(s) : HAL CCSD Elsevier
Résumé : We have studied the phase transformation of forsterite to wadsleyite under shear stress at the Earth's transition zone pressure and temperature conditions. Two-step experiments were performed using a multi-anvil press. First, we hot pressed iron-free forsterite at 6 or 11 GPa and 1100 degrees C. Then we deformed a slab of this starting material using a direct simple shear assembly at 16 GPa and 1400 degrees C for 1, 15, 35, 40, or 60 min. Both the starting material and the deformed samples were characterized using optical and scanning electron microscopy including measurements of crystal preferred orientations (CPO) by electron back scattered diffraction (EBSD), transmission electron microscopy (TEM), and Fourier transform infrared spectroscopy (FTIR). The phase transformation occurs very rapidly, in less than 1 min, and metastable forsterite relics are not observed after deformation. The grain size of wadsleyite is slightly smaller than the forsterite starting material. The water contents obtained from FTIR analyses in forsterite and wadsleyite are 65-124 wt ppm H2O and 114-736 wt ppm H2O, respectively, which are well below water solubility at similar conditions in the presence of free water. Wadsleyite aggregates display weak CPO patterns with [1 0 0] axes concentrated at low angle to the shear direction, [0 1 0] axes perpendicular to the shear plane and nearly random [0 0 1] axes. Only a few dislocations were observed in wadsleyite with TEM. This observation is consistent with the assumption that most dislocations formed during the initial high-stress stages of these stress-relaxation experiments, were consumed in the phase transformation, probably enhancing the transformation rate. CPO patterns vary as a function of the water content: with increasing water content the density of [1 0 0] axes parallel to the shear direction decreases, and the density of [0 0 1] axes increases. Viscoplastic self-consistent modeling of CPO evolution using previously reported glide systems for wadsleyite, i.e., [1 0 0]{0 k 1} and 1/2 (1 1 1){1 0 1}, cannot reproduce the measured CPO, unless the [0 0 1](0 1 0) system, for which dislocations have not been observed by TEM, is also activated. In addition, wadsleyite grain growth suggests the participation of diffusion-assisted processes in deformation. Calculated anisotropies for P and S-waves using measured CPO are always below 1%. This very low anisotropy is due to both the low finite strain achieved in the experiments, which leads to weak wadsleyite CPO, and to the diluting effect of added majorite. The present experiments emphasize the importance of stress, grain size evolution and water content in the forsterite to wadsleyite phase transformation and subsequent deformation in the transition zone.
ISSN: 0031-9201

hal-00617430
https://hal.archives-ouvertes.fr/hal-00617430
DOI : 10.1016/j.pepi.2010.11.001

Éditeur(s) : HAL CCSD Oxford University Press (OUP)
Résumé : International audience
Phase equilibrium data pertaining to melting of simplified carbonated peridotite in the systems CaO-MgO-SiO2-CO2 and CaO-MgO-Al2O3-SiO2-CO2 at pressures of 10-26 GPa, corresponding to similar to 300-750 km depths in the Earth, are presented. In both the studied systems, liquid compositions, with changing crystalline phase assemblage, are carbonatitic throughout the studied pressure range. In the system CMS-CO2, melting phase relations are isobarically invariant; liquid is in equilibrium with forsterite + clinoenstatite + clinopyroxene + magnesite, forsterite + majorite + clinopyroxene + magnesite, wadsleyite + majorite + clinopyroxene + magnesite, ringwoodite + majorite + calcium-silicate perovskite + magnesite, magnesium-silicate perovskite + periclase + calcium-silicate perovskite + magnesite at 12, 14, 16, 20, and 26 GPa, respectively. In the system CMAS-CO2, a phase assemblage consisting of forsterite + orthopyroxene + clinopyroxene + magnesite + garnet + melt from 10 to 14 GPa is isobarically invariant. However, owing to the disappearance of orthopyroxene at pressures greater than 14 GPa, from 16 and up to at least 26 GPa, the solidus of simplified carbonated peridotite spans a divariant surface in pressure-temperature space. The liquid coexists with wadsleyite + clinopyroxene + garnet + magnesite, ringwoodite + calcium-silicate perovskite + garnet + magnesite, and magnesium-silicate perovskite + periclase + calcium-silicate perovskite + magnesite at 16, 20, and 26 GPa, respectively. A curious, and as yet unexplained, feature of our study is an abrupt drop in the solidus temperature between 14 and 16 GPa that causes a small amount of melting of carbonated mantle in the Transition Zone of the Earth. In the systems CMS-CO2 and CMAS-CO2 liquid compositions at 16 and 20 GPa are highly calcic bona fide carbonatites; however, these liquids revert to being magnesiocarbonatites at 10-14 and 26 GPa. In the system CMS-CO2, at 16 GPa we locate an isobaric invariant point consisting of wadsleyite + clinopyroxene + anhydrous B + magnesite + melt. The presence of anhydrous B at 16 GPa and 1475 degrees C is interesting, as it lies outside the composition space of the mantle peridotite analog we have studied. However, despite the presence of two highly magnesian silicate crystalline phases, wadsleyite and anhydrous B, at 16 GPa and 1475 degrees C, the liquid composition remains calcic with molar Ca-number [Ca/(Ca + Mg) x 100] of about 63. The melting reactions at 16 and 20 GPa (with or without anhydrous B) show that lime-bearing crystalline silicates play a fairly large part in generating and controlling the composition of the liquids. At 16 GPa, in the system CMS-CO2, we also report an experimental run at 1575 degrees C, in which liquid coexists with only wadsleyite and majorite. The liquid composition is less calcic (Ca-number 54) than that for other runs at lower temperatures, but is still more calcic than liquids at 10-14 and 26 GPa in both the studied systems. At present, the likely cause for these changes in the reported phase relations is not known. For normally assumed mantle temperatures, melting in the Transition Zone of the Earth, owing to the presence of carbonate, is probably unavoidable. The depth range of the drop in the carbonated peridotite solidus closely matches that of commonly observed low seismic velocities at similar to 400-600 km depth in the Earth.
ISSN: 0022-3530

hal-00669945
https://hal.archives-ouvertes.fr/hal-00669945
DOI : 10.1093/petrology/egr048

Éditeur(s) : HAL CCSD Mineralogical Society of America
Résumé : International audience
Wadsleyites with various iron contents were synthesized at ~12-14 GPa and 1400 °C under oxidizing and hydrous conditions in coexistence with enstatite. The samples were studied using micro-X-ray absorption near edge structure (XANES) and micro-Mössbauer spectroscopy to determine the ferric iron contents in polyphasic samples and secondary ion mass spectrometry (SIMS) to determine the water concentrations. XANES and Mössbauer analyses show that ferric iron content increases with increasing total iron content, and reaches a maximum of ~30% Fe3+/Fetotal. Two XANES results were cross-checked by Mössbauer analysis and both methods are in reasonable agreement. The use of Fourier transform infrared spectroscopy reveals a new protonation scheme in wadsleyite, with a significant proportion of protons associated with the high-frequency band at 3611 cm−1 and a new band located at 3500 cm−1. The intensity of these two bands is higher for Fe3+-rich wadsleyite. SIMS analyses show that water contents in wadsleyite vary from 4500 to 9400 ppm H2O by weight. Pyroxene water contents range from 790 to 1600 ppm wt H2O. The concentration of water in both phases decreases with increasing iron content. The partition coefficient of water between wadsleyite and pyroxene varies between 5 and 9 and increases with increasing Fe-number of wadsleyite [i.e., XFe/(XFe + XMg) × 100 ratio]. The divalent cation concentrations (i.e., Mg2+ + Fe2+), the Si as well as the H content in wadsleyite decrease with increasing Fe3+ content, indicating an incorporation mechanism via substitution into the metal (Me = Mg2+ and Fe2+) and Si sites with a ratio of 5/3 for (Fe3++H+):Me and of 5/1 for (Fe3++H+):Si, similarly as in the dry system. Thus, coupled substitution of Fe3+ and H+ does not affect the incorporation mechanism of Fe3+, but does affect the location of H+, which is partly incorporated at tetrahedral edges forming [FeSi′-(OH)o*]X neutral defects substituting for Si. In this model 25% of the ferric iron occupies the tetrahedral sites.
ISSN: 0003-004X

hal-00758071
https://hal.archives-ouvertes.fr/hal-00758071
DOI : 10.2138/am.2012.3869

Éditeur(s) : HAL CCSD Springer-Verlag
Résumé : The seismology is the most effective method to explore the Structure of subduction zones to great depth. The distinguishing feature of the mantle in the subduction regions is the presence of hydrated phases, which transport water into the Earth's interior and release it with dramatic local consequences, triggering earthquakes and melting. The seismological detection of these hydrous phases and geo-dynamic interpretation of flow in the hydrous mantle depend on knowledge of the anisotropic elastic properties and the characteristics of the wave propagation in anisotropic media. In this paper we briefly recall the distinguishing features of anisotropic wave propagation and the observable parameters. We suggest the Vp/Vs ratio is a physically sound parameter than can be observed by seismology in anisotropic regions of the Earth, whereas the Poisson's ratio, which is often quoted, is not directly observable and does not correspond to the characteristics of wave propagation in an anisotropic or isotropic medium. We report for the first time the ratios of Vp/Vs1 and Vp/Vs2, where Vs1 is the fastest and Vs2 slowest S-wave velocities of an anisotropic media. We present the current knowledge of the anisotropic seismic properties of hydrous minerals in the upper mantle, transition zone, and lower mantle that are stable along low temperature geotherms associated with subduction, and identify which minerals are likely to influence seismological observations because they have very high volume fractions, or very high anisotropies, or both of these.;In the upper mantle antigorite and talc are exceptionally anisotropic (Vp 71% Vs 68% and Vp 65%, Vs 68%, respectively) and chlorite is also very anisotropic for S-waves (Vp 35%, Vs 76%). Comparatively less anisotropic are hornblende (Vp 27%, Vs 31%), used as proxy for tremolite in subduction zones, and clinohumite (21.8%, Vs 15.9%). Brucite at 4 GPa (Vp 26.5%, Vs 30.9%) and the dense hydrogen magnesium silicate (DHMS) phase A at 9GPa (Vp 9.3%, Vs 17.6%) are the only hydrous minerals stable in the upper mantle that have had their elastic properties measured at in situ mantle pressures. Except for the phase A, all these minerals are more anisotropic than olivine for at least one parameter (Vp, Vs, Vp/Vs1, or Vp/Vs2). In the transition zone the major phases hydrous wadsleyite and ringwoodite C have moderate to weak anisotropies (Vp 16.3%, Vs 16.5%, and Vp 1.9%, Vs 4.4%, respectively). The DHMS Superhydrous B has a moderate anisotropy (Vp 6.9%, Vs 11.6%). At greater depth the DHMS phase D Lit 24 GPa (Vp 10.8%, Vs 18.0%) is the only hydrous phase that can transport hydrogen from the transition zone into the lower mantle. The phase D is more anisotropic for S than P waves like many of the hydrous phases. From these data it is clear that hydrous phases are in general very anisotropic. However, pressure can play a strong role in reducing anisotropy. It is the case for brucite and talc, in which increasing pressure from ambient to 4 GPa reduces the anisotropy by about 50% for both P and S waves. In contrast, the anisotropy of the DHMS phase A does not change significantly with pressure.;Our picture of the seismic anisotropy of hydrated minerals remains incomplete; the elastic properties of many have not been measured even at ambient conditions (e.g., 10 angstrom phase and phase E) or not measured in their true elastic symmetry (e.g., clinochlore). The majority of hydrous minerals have not been measured at high pressure. and none related to hydrated mantle have been measured at elevated temperature. We have shown in the few cases where hydrous minerals have been measured as a function of pressure, that this variable has an important effect oil the velocity distribution and in most cases reduces the degree of anisotropy, hence we Would expect seismic anisotropy to play a key role in the determination of the shallow structure of subduction zones in the upper mantle.
Subduction zone geodynamics

hal-00420893
https://hal.archives-ouvertes.fr/hal-00420893