Éditeur(s) : HAL CCSD Elsevier
Résumé : International audience
The present study aims at better deciphering the different mechanisms involved in the functioning of the subduction interplate. A 2D thermo-mechanical model is used to simulate a subduction channel, made of oceanic crust, free to evolve. Convergence at constant rate is imposed under a 100 km thick upper plate. Pseudo-brittle and non-Newtonian behaviours are modelled. The influence of the subduction channel strength, parameterized by the difference in activation energy between crust and mantle () is investigated to examine in detail the variations in depth of the subduction plane down-dip extent, . First, simulations show that numerical resolution may be responsible for an artificial and significant shallowing of if the weak crustal layer is not correctly resolved. Second, if the age of the subducting plate is 100 Myr, subduction occurs for any . The stiffer the crust is, that is, the lower is, the shallower is (60 km depth if kJ/mol) and the hotter the fore-arc base is. Conversely, imposing a very weak subduction channel ( J/mol) leads there to an extreme mantle wedge cooling and inhibits mantle melting in wet conditions. Partial kinematic coupling at the fore-arc base occurs if kJ/mol. If the incoming plate is 20 Myr old, subduction can occur under the conditions that the crust is either stiff and denser than the mantle, or weak and buoyant. In the latter condition, cold crust plumes rise from the subduction channel and ascend through the upper lithosphere, triggering (1) partial kinematic coupling under the fore-arc, (2) fore-arc lithosphere cooling, and (3) partial or complete hindrance of wet mantle melting. then ranges from 50 to more than 250 km depth and is time-dependent if crust plumes form. Finally, subduction plane dynamics is intimately linked to the regime of subduction-induced corner flow. Two different intervals of are underlined: 80–120 kJ/mol to reproduce the range of slab surface temperature inferred from geothermometry, and 10–40 kJ/mol to reproduce the shallow hot mantle wedge core inferred from conditions of last equilibration of near-primary arc magmas and seismic tomographies. Therefore, an extra process controlling mantle wedge dynamics is needed to satisfy simultaneously the aforementioned observations. A mantle viscosity reduction, by a factor 4–20, caused by metasomatism in the mantle wedge is proposed. From these results, I conclude that the subduction channel down-dip extent, , should depend on the subduction setting, to be consistent with the observed variability of sub-arc depths of the subducting plate surface.
ISSN: 0031-9201

hal-01623155
https://hal.archives-ouvertes.fr/hal-01623155
DOI : 10.1016/j.pepi.2017.05.008

Éditeur(s) : HAL CCSD Wiley
Résumé : International audience
We report trace element analyses from mineral phases in chondrules from carbonaceous chondrites (Vigarano, Renazzo, and Acfer 187), carried out by laser ablation inductively coupled plasma-mass spectrometry. Results are similar in all three meteorites. Mesostasis has rare earth element (REE) concentrations of 10-20 × CI. Low-Ca pyroxene has light REE (LREE) concentrations near 0.1 × CI and heavy REE (HREE) near 1 × CI, respectively. Olivine has HREE concentrations at 0.1-1 × CI and LREE around 10−2 × CI. The coarsest olivine crystals tend to have the most fractionated REE patterns, indicative of equilibrium partitioning. Low-Ca pyroxene in the most pyroxene-rich chondrules tends to have the lowest REE concentrations. Type I chondrules seem to have undergone a significant degree of batch crystallization (as opposed to fractional crystallization), which requires cooling rates slower than 1-100 K h−1. This would fill the gap between igneous calcium-aluminum-rich inclusions (CAIs) and type II chondrules. The anticorrelation between REE abundances and pyroxene mode may be understood as due to dilution by addition of silica to the chondrule melt, as in the gas-melt interaction scenario of Libourel et al. (2006). The rapid cooling rate (of the order of 1000 K h−1) which seems recorded by low-Ca pyroxene, contrasted with the more diverse record of olivine, may point to a nonlinear cooling history or suggest that formation of pyroxene-rich chondrule margins was an event distinct from the crystallization of the interior.
ISSN: 1086-9379

hal-00795434
https://hal.archives-ouvertes.fr/hal-00795434
DOI : 10.1111/maps.12005

Éditeur(s) : HAL CCSD Elsevier
Résumé : International audience
Carbonation of peridotite is a widespread process in nature, with emerging societal and environmental implications through geological storage of CO2. We studied the micro- and nano-scale structures associated with the carbonation of peridotite pervaded by a CO2-rich water and the induced changes of its hydrodynamic properties. Focused ion beam (FIB) nanotomography was coupled with scanning electron microscopy (SEM) and transmission electron microscopy (TEM) observations. An experimental sample of dunite core percolated by a CO2-rich fluid (pCO2 = 11 MPa) at 160 °C was compared with a naturally carbonated sample from the Atlantic Ridge (Exp. IODP 304). Results of the 8-days percolation experiment show continuous alteration of olivine into magnesite locally associated with a poorly crystalline serpentine-type mineral referred to as proto-serpentine. The experiment is also characterized by an overall decrease in rock porosity (from 7.7 to 6.4%) and permeability (from 8.5 × 10− 16 to 1.7 × 10− 16 m2). The primary inter-granular porosity (1 to 10 μm) is progressively filled with magnesite, leading to the overall decrease of permeability. At the same time, a secondary small-scale porosity (10 nm to 1 μm) is created at the tip of the dissolution features along the (010) cleavage planes of olivine grains. Carbonate crystals grow within these etch-pit structures behind the dissolution front. Dissolution and precipitation occur at a relative rate that maintains the secondary porosity over the timescale of the experiment (i.e. carbonate growth has to be the slowest one). This process is interpreted as an interface coupled dissolution-precipitation mechanism of olivine carbonation. Proto-serpentine is only formed in highly reduced flow areas, such as small olivine etch-pits (10 to 500 nm wide), which are more isolated from CO2 input. SEM-FIB analyses show the 3D preferential orientation of the dissolution-precipitation planes within a given olivine grain. It suggests the formation of lateral connections between the etch-pits (infra-micrometric “channels”) providing access to reactants and removing reaction products at the reaction sites. The experimental results show that olivine dissolution and magnesite precipitation converge to a quasi-steady state resulting in a constant carbonation rate controlled by reaction kinetics and not by mass transfer for this flow regime. The system self-regulates, independently of the porosity change at least during this incipient stage of olivine carbonation. Similar textures are observed in natural samples collected at 170 m-depth in the vicinity of veinlets driving late fluids down into the cooling oceanic lithosphere. This suggests that similar mechanisms are active in nature and can play an important role in the late, low temperature alteration stages of fractured peridotite. These results also highlight the critical role of nm-scale spatial arrangement of dissolution and precipitation features on mass transfers and on the sustainability of olivine carbonation through coupled dissolution-precipitation processes.
ISSN: 0009-2541

hal-01684733
https://hal.archives-ouvertes.fr/hal-01684733
DOI : 10.1016/j.chemgeo.2017.11.013

Éditeur(s) : HAL CCSD Elsevier
Résumé : International audience
The basement of central Madagascar displays two contrasted structural patterns. The first one (D1) is characterized by north-striking foliations that are gently dipping to the west and carry W- to WSW-plunging lineations, whereas the second one (D2) is characterized by steeper foliations that are striking to the NNE and lineations that are either subhorizontal or gently plunging to the SSW. The younger pattern is related to late-Panafrican tectonics along the major Angavo shear zone that is about 1000 km in length and 40 km in width with apparently little offset. Deformation in the Angavo zone induced interference folding on both sides. The D2 event is characterized by low pressures (ca 400 MPa) and high temperatures (up to 790 degrees C) responsible for prograde granulite facies conditions, that resulted from heat transfer due to magma and fluid advection in the Angavo shear zone. The D2 event is pinned at 550 +/- 11 Ma by a new monazite age from a reoriented Andringitrean granite near Ankaramena. A new suite of amphibole and biotite Ar-Ar geochronological data enables to retrace the thermochronogical evolution inside and outside the Angavo shear zone. Combined with new structural results from the western interference zone. these ages yield a better understanding of the late-Panafrican history of central Madagascar. No diachronism is observed along the strike of the Angavo shear zone. Conversely, amphibole and especially biotite ages decrease from West to East, i.e. towards the shear zone. These new ages range from 511 to 469 Ma. A 1-D conductive model constrains the thermal effect in relation with the Angavo shear zone to be restricted to a lateral distance of ca 60 km (in map view) for a maximum heating duration of 20 Myr. This is in agreement with the Ar-Ar data and with the width of the observed interference zone. Following this episode of deformation and heat transfer, the estimated cooling rates of the Angavo shear zone range from to 15 to 6 degrees C/Myr, respectively before and after 515 Ma. A post-collision intracontinental setting is suggested for the Angavo shear zone, which is regarded as a remote effect of the Kuunga Orogeny between India and Antarctica.
ISSN: 0040-1951

hal-00463507
https://hal.archives-ouvertes.fr/hal-00463507
DOI : 10.1016/j.tecto.2009.03.009

Éditeur(s) : HAL CCSD Elsevier
Résumé : International audience
A laser ablation ICP-MS U-Pb age of 17.84 +/- 0.12 Ma (late Burdigalian) was obtained from monazites separated from a leucocratic diatexite collected in close proximity to a small peridotite massif incorporated into the lower crustal sequence of the Edough Massif (north-eastern Algeria), a southern segment of the peri-Mediterranean Alpine Belt. Monazites extracted from a neighbouring deformed leucogranite intruding early Paleozoic phyllites yield a consistent age of 17.4 +/- 1.3 Ma. Zircons occurring in the same leucogranite, with magmatic characteristics, have an age of 308 +/- 7 Ma interpreted as dating magmatic crystallisation of the leucogranite and reflecting partial melting during the Hercynian orogeny. Low Th/U domains (Th/U<0.10) from the same grains substantiate recrystallisation during a younger metamorphic event whose upper age limit is 286 +/- 11 Ma. These results emphasize the polycyclic evolution of basement rocks preserved in the crystalline units of the western Mediterranean and indicate that part of their metamorphic features were inherited from older, Hercynian, events. Taken together with published Ar-Ar dates, the late Burdigalian age of monazites indicates a rapid cooling rate of c. 370 degrees C/Ma and is regarded as closely approximating the emplacement of the peridotites into the Hercynian basement. The monazite ages are significantly younger than those recorded for orogenic peridotites from the Betic-Rif oroctine and for the timing of lithospheric extension forming the Alboran sea. It is also younger than rifting and back-arc extension opening the Liguro-Provencal basin. The late Burdigalian age is interpreted as dating the incipient rifting event that opened the Algerian basin, which is consequently not a continuation of the Liguro-Provencal basin. At the scale of the western Mediterranean, these observations concur with current models supporting slab roll-back and an eastwards migration of extension in the western Mediterranean, but suggest that the Algerian basin opened as a result of torsion and stretching of the Thethyan slab due to its steepening under the Alboran microplate.
ISSN: 0009-2541

hal-00424511
https://hal.archives-ouvertes.fr/hal-00424511
DOI : 10.1016/j.chemgeo.2008.11.016

Éditeur(s) : HAL CCSD Oxford University Press (OUP)
Résumé : International audience
Three kilns and a collection of baked bricks from Italian archaeological sites have been studied for archaeointensity determination using the Thellier method as modified by Coe. All sites are dated based on archaeological information and their ages range from 500 to 800 AD and 1500 to 1700 AD. Rock magnetic studies identify magnetite, Ti- magnetite and hematite as the main magnetic minerals, and magnetic susceptibility versus temperature shows a good thermal stability of the samples. The intensity results have been corrected for anisotropy of the thermoremanent magnetization and cooling rate effects. The new data together with 136 previously published results are used to estimate the variation of the Earth's magnetic field over the past three millennia. The time distribution of the Italian absolute intensity data is irregular with the majority of determinations concentrated during the last four centuries, while older periods are very poorly covered. Most of the data come from volcanic rocks and show significant discrepancies. All data have been compared with archaeointensity results from Europe and regional and global models predictions. This work indicates the need to obtain more high quality archaeointensity results, in particular for the periods older than 200 BC and between 200 and 1000 AD, in order to determine a robust Italian intensity secular variation curve that, in combination with directional data, could be used for archaeomagnetic dating.
ISSN: 0956-540X

hal-00452451
https://hal.archives-ouvertes.fr/hal-00452451
DOI : 10.1111/j.1365-246X.2009.04455.x