Éditeur(s) : HAL CCSD Nature Publishing Group
Résumé : International audience
Temperature and fluid pressure conditions control rock deformation and mineralization on geological faults, and hence the distribution of earthquakes1. Typical intraplate continental crust has hydrostatic fluid pressure and a near-surface thermal gradient of 31 ± 15 degrees Celsius per kilometre2, 3. At temperatures above 300–450 degrees Celsius, usually found at depths greater than 10–15 kilometres, the intra-crystalline plasticity of quartz and feldspar relieves stress by aseismic creep and earthquakes are infrequent. Hydrothermal conditions control the stability of mineral phases and hence frictional–mechanical processes associated with earthquake rupture cycles, but there are few temperature and fluid pressure data from active plate-bounding faults. Here we report results from a borehole drilled into the upper part of the Alpine Fault, which is late in its cycle of stress accumulation and expected to rupture in a magnitude 8 earthquake in the coming decades4, 5. The borehole (depth 893 metres) revealed a pore fluid pressure gradient exceeding 9 ± 1 per cent above hydrostatic levels and an average geothermal gradient of 125 ± 55 degrees Celsius per kilometre within the hanging wall of the fault. These extreme hydrothermal conditions result from rapid fault movement, which transports rock and heat from depth, and topographically driven fluid movement that concentrates heat into valleys. Shear heating may occur within the fault but is not required to explain our observations. Our data and models show that highly anomalous fluid pressure and temperature gradients in the upper part of the seismogenic zone can be created by positive feedbacks between processes of fault slip, rock fracturing and alteration, and landscape development at plate-bounding faults.
ISSN: 0028-0836

hal-01685757
https://hal.archives-ouvertes.fr/hal-01685757
DOI : 10.1038/nature22355

Éditeur(s) : [S.l.] : Lippincott
Résumé : A propos de l'éruption de la Montagne Pelée en 1902. Photographies
Siècle(s) traité(s) : 20
Droits : Domaine public
Provenance : Université des Antilles. Service commun de la documentation
Permalien : http://www.manioc.org/patrimon/HASH0a691d818470fe033d61ec
HASH0a691d818470fe033d61ec

Éditeur(s) : HAL CCSD Elsevier
Résumé : International audience
Carbonation of peridotite is a widespread process in nature, with emerging societal and environmental implications through geological storage of CO2. We studied the micro- and nano-scale structures associated with the carbonation of peridotite pervaded by a CO2-rich water and the induced changes of its hydrodynamic properties. Focused ion beam (FIB) nanotomography was coupled with scanning electron microscopy (SEM) and transmission electron microscopy (TEM) observations. An experimental sample of dunite core percolated by a CO2-rich fluid (pCO2 = 11 MPa) at 160 °C was compared with a naturally carbonated sample from the Atlantic Ridge (Exp. IODP 304). Results of the 8-days percolation experiment show continuous alteration of olivine into magnesite locally associated with a poorly crystalline serpentine-type mineral referred to as proto-serpentine. The experiment is also characterized by an overall decrease in rock porosity (from 7.7 to 6.4%) and permeability (from 8.5 × 10− 16 to 1.7 × 10− 16 m2). The primary inter-granular porosity (1 to 10 μm) is progressively filled with magnesite, leading to the overall decrease of permeability. At the same time, a secondary small-scale porosity (10 nm to 1 μm) is created at the tip of the dissolution features along the (010) cleavage planes of olivine grains. Carbonate crystals grow within these etch-pit structures behind the dissolution front. Dissolution and precipitation occur at a relative rate that maintains the secondary porosity over the timescale of the experiment (i.e. carbonate growth has to be the slowest one). This process is interpreted as an interface coupled dissolution-precipitation mechanism of olivine carbonation. Proto-serpentine is only formed in highly reduced flow areas, such as small olivine etch-pits (10 to 500 nm wide), which are more isolated from CO2 input. SEM-FIB analyses show the 3D preferential orientation of the dissolution-precipitation planes within a given olivine grain. It suggests the formation of lateral connections between the etch-pits (infra-micrometric “channels”) providing access to reactants and removing reaction products at the reaction sites. The experimental results show that olivine dissolution and magnesite precipitation converge to a quasi-steady state resulting in a constant carbonation rate controlled by reaction kinetics and not by mass transfer for this flow regime. The system self-regulates, independently of the porosity change at least during this incipient stage of olivine carbonation. Similar textures are observed in natural samples collected at 170 m-depth in the vicinity of veinlets driving late fluids down into the cooling oceanic lithosphere. This suggests that similar mechanisms are active in nature and can play an important role in the late, low temperature alteration stages of fractured peridotite. These results also highlight the critical role of nm-scale spatial arrangement of dissolution and precipitation features on mass transfers and on the sustainability of olivine carbonation through coupled dissolution-precipitation processes.
ISSN: 0009-2541

hal-01684733
https://hal.archives-ouvertes.fr/hal-01684733
DOI : 10.1016/j.chemgeo.2017.11.013

Éditeur(s) : HAL CCSD Oxford University Press (OUP)
Résumé : International audience
The mantle above a subducting slab is the site of complex interactions between deformation, partial melting, fluid migration and magma transport. To constrain these interactions and their effects on olivine deformation, we analyze microstructures, crystal preferred orientations, and water contents of peridotite xenoliths entrained by andesites of the Avacha volcano, southern Kamchatka arc. These xenoliths are refractory spinel harzburgites that have coarse-grained microstructures with widely spaced subgrain boundaries and sinuous grain boundaries in olivine, consistent with deformation by dislocation creep under low deviatoric stress (< 13 MPa) and with a significant contribution from diffusional processes. Analysis of crystal preferred orientations (CPO) indicates dominant activation of high-temperature, low-stress {0kl}[100] slip systems in olivine and of(100)[001] in orthopyroxene. In most samples, coarse opx crystals, elongated parallel to the lineation, enclose small olivine grains in crystallographic continuity with neighbouring crystals, indicating crystallization of orthopyroxene at the expense of olivine as a result of reactive percolation of Si-rich fluids coeval with the high-temperature deformation. Secondary crystallization of interstitial orthopyroxene led locally to development of opx-rich lenses parallel to the foliation, characterized by a decrease in olivine grain size and dispersion of the olivine CPO without changing the dominant slip systems. Half of the samples also show acicular orthopyroxene aggregates with which is associated a fine-grained matrix composed of rounded strain-free olivine, orthopyroxene, spinel, and rare amphibole crystals. This matrix occurs pervasively along grain boundaries or forms millimeter-scale irregular lenses and anastomosing veinlets that crosscut the coarse crystals and their ductile deformation structures. Both acicular orthopyroxene and the fine-grained matrix are interpreted as resulting from reactive transport of H2O-rich fluids under static conditions, probably in the lithospheric mantle. Infrared analyses show that olivine contains 1-8 center dot 6 ppm by weight of water. These low water contents are similar to those observed in spinel peridotites from other subduction zones and probably record both the low solubility of water in olivine at low pressure and dehydration during exhumation of the xenoliths. Water contents in orthopyroxene are highly variable (25-506 ppm H2O), probably recording spatially heterogeneous interaction with fluids or melts and compositional disequilibrium in the studied samples. Change in the dominant percolation mechanism from porous flow to fracturing suggests cooling, consistent with the low temperatures estimated from pyroxene thermometry (< 800-900 degrees C). The Avacha xenoliths therefore record pervasive deformation of a region of the mantle under asthenospheric conditions, followed by its accretion to the base of the lithosphere, probably as a result of cooling of the mantle wedge. Percolation of Si-rich fluids or hydrous melts is recorded at all stages; this probably enhanced diffusion and lowered deviatoric stresses during ductile deformation, but did not change the dominant slip direction in olivine from [100] to [001].
ISSN: 0022-3530

hal-00456053
https://hal.archives-ouvertes.fr/hal-00456053
DOI : 10.1093/petrology/egp085

Éditeur(s) : Paris : Société de Géographie
Siècle(s) traité(s) : 19
Droits : Domaine public
Provenance : Collectivité territoriale de Guyane. Bibliothèque Alexandre-Franconie
Permalien : http://www.manioc.org/patrimon/FRA11078
FRA11078

Éditeur(s) : HAL CCSD Royal Society of Chemistry
Résumé : International audience
LA-ICP-MS analysis of the chemical composition of biogenic carbonate has many applications in the environmental sciences but the characteristics of the material produced by the ablation process are largely unknown. To fill this gap, we have undertaken a study of the chemical and physical nature of particles produced by laser ablation of biogenic carbonates. SEM imaging suggests that laser ablation produces two distinct particle populations, one consisting of microsize particles and the other of nanosize particles. A 213 nm laser gives rise to a higher proportion of microsize particles than a 193 nm laser, probably because the 213 nm laser couples less completely with carbonate material. The microsize particles appear to form by photomechanical fracturing along lines of cleavage or weakness, rather than by hydrodynamic sputtering (as is generally observed for silicates). Chemical analysis of the carbonate particles suggests that little chemical fractionation of biogenic carbonates occurs during the ablation process or during transport to the plasma. This is supported by the constancy of the fractionation factor ([X/Ca](measured)/[X/Ca] true) during the course of an ablation of a carbonate standard. In contrast, changes in the fractionation factor during the first few seconds of ablation of the NIST 612 are observed for some elements. This difference in fractionation is likely to result from the different formation mechanisms of the microsize particles.
ISSN: 0267-9477

hal-00411933
https://hal.archives-ouvertes.fr/hal-00411933
DOI : 10.1039/b706727e

Date de création : 1869-01-01

Éditeur(s) : London : Bell & Daldy
Siècle(s) traité(s) : 19
Droits : Domaine public
Provenance : Collectivité territoriale de Guyane. Bibliothèque Alexandre-Franconie
Permalien : http://www.manioc.org/patrimon/FRA11001
FRA11001

Éditeur(s) : Paris : imprimerie Moreau
Résumé : Périodiques reliés ensemble
Siècle(s) traité(s) : 19
Provenance : Archives départementales de Guadeloupe
Permalien : http://www.manioc.org/patrimon/ADG18222
ADG18222

Éditeur(s) : HAL CCSD Elsevier
Résumé : International audience
The initiation and subsequent evolution of intra-plate orogens, resulting from continental plate interior deformation due to transmission of stresses over large distances from the active plate boundaries, is controlled by lateral and vertical strength contrasts in the lithosphere. We present lithospheric-scale analogue models combining 1) lateral strength variations in the continental lithosphere, and 2) different vertical rheological stratifications. The experimental continental lithosphere has a four-layer brittle–ductile rheological stratification. Lateral heterogeneity is implemented in all models by increased crustal strength in a central narrow block. The main investigated parameters are strain rate and strength of the lithospheric mantle, both playing an important role in crust–mantle coupling. The experiments show that the presence of a strong crustal domain is effective in localizing deformation along its boundaries. After deformation is localized, the evolution of the orogenic system is governed by the mechanical properties of the lithosphere such that the final geometry of the intra-plate mountain depends on the interplay between crust–mantle coupling and folding versus fracturing of the lithospheric mantle. Underthrusting is the main deformation mode in case of high convergence velocity and/or thick brittle mantle with a final asymmetric architecture of the deep lithosphere. In contrast, lithospheric folding is dominant in case of low convergence velocity and low strength brittle mantle, leading to the development of a symmetric lithospheric root. The presented analogue modelling results provide novel insights for 1) strain localization and 2) the development of the asymmetric architecture of the Pyrenees.
ISSN: 0012-821X

hal-01243577
https://hal.archives-ouvertes.fr/hal-01243577
DOI : 10.1016/j.epsl.2015.05.022

Éditeur(s) : Paris : Dufart père
Siècle(s) traité(s) : 19
Droits : Domaine public
Provenance : Collectivité territoriale de Martinique. Bibliothèque Schoelcher
Permalien : http://www.manioc.org/patrimon/SCH13038
SCH13038

Éditeur(s) : Lyon : Reymann
Siècle(s) traité(s) : 19
Droits : Domaine public
Provenance : Collectivité territoriale de Martinique. Bibliothèque Schoelcher
Permalien : http://www.manioc.org/patrimon/SCH13273
SCH13273