Éditeur(s) : HAL CCSD Elsevier
Résumé : International audience
This study presents microstructural evidence for deformation-controlled melt organization and for changes in olivine deformation associated with the presence of melt in an 80 m vertical section of the crust-mantle transition zone in the Oman ophiolite. This zone represents an 'end member' case for analyzing feedbacks between deformation and melt distribution in the upper mantle, since it experienced strong shear strains in presence of large melt fractions. It is characterized by a subhorizontal compositional layering at the mm to meter scale, from weakly impregnated dunites to olivine-rich gabbros, which parallels a pervasive foliation containing a strong stretching lineation. The parallelism between the compositional layering and the foliation, the diffuse limits of the layers, the alignment of elongated plagioclase-rich aggregates devoid of internal deformation structures with the elongation of olivine crystals in the dunitic layers, and the sharp compositional changes across some, but not all layer limits suggest deformation plays an essential role on the development of the layering. The variation on a mm-scale of the olivine crystal preferred orientation (CPO) symmetry as a function of the modal content: from axial-[100] symmetry in layers with <70% modal olivine to axial-[010] in more gabbroic levels (<40% olivine), which is repeated over the entire section, implies deformation in presence of variable melt fractions. Axial-[100] olivine CPO in olivine-rich layers is consistent with deformation by dislocation creep under high temperature, low pressure, dry conditions. Axial-[010] olivine CPO patterns imply additional sliding along preferentially wetted (010) grain boundaries, increase in the activity of [001] glide, or transpression localized in the melt-rich layers. Since the change in CPO symmetry is not accompanied by dispersion, instantaneous melt fractions must have remained <30-40% in all layers. The continuous variation in olivine CPO symmetry with decreasing olivine content implies therefore that the former depends on the cumulated strain in presence of melt rather than on the instantaneous melt fraction.
ISSN: 0012-821X

hal-00795508
https://hal.archives-ouvertes.fr/hal-00795508
DOI : 10.1016/j.epsl.2012.10.003

Éditeur(s) : HAL CCSD Elsevier
Résumé : International audience
We studied the deformation in a partially molten mantle through detailed petrostructural analysis of plagioclase lherzolites from the northwestern part of the central Lanzo massif. These peridotites display a pervasive anastomosed network of millimetre to centimetre-scale plagioclase-rich bands, which grades locally into a planar layering marked by an intercalation of plagioclase-rich and olivine-rich layers up to tens of centimetres wide. Both the anastomosed and the planar layering are subparallel to the deformation fabric, characterized by a foliation defined by the shape-preferred orientation of olivine and by crystal preferred orientation (CPO) of olivine, orthopyroxene, and clinopyroxene. This parallelism, the coexistence of microstructural evidence for melt-rock reactions and for deformation by dislocation creep, and the predominance of axial-[010] olivine CPO patterns, characterized by [010] axes clustered normal to the layering, indicate that deformation and the reactive melt percolation that formed the layering were coeval. Strong heterogeneity in mineral composition in the planar layering domains, with Fe-enrichment in olivine and spinel and highly variable Ti content in spinel in cm-scale plagioclase-rich bands, implies that the latter interacted with higher melt volumes. High Ti contents in pyroxenes and spinel in the anastomosed layering domains point to changes in melt composition, hinting to less effective melt transport. We propose therefore that the planar layering records melt segregation in layers parallel to the shear plane, whereas the anastomosed layering results from melt alignment along grain boundaries subparallel to the shear plane, without segregation. Finite strain in the different layers cannot be quantified, but comparison of the present observations with data from experiments and from other mantle outcrops displaying shear-controlled melt organization suggests that the transition from the anastomosed to the planar layering might record an increase in finite strain, that is, strain localization associated with variations in the instantaneous melt fraction.
ISSN: 0040-1951

hal-01053509
https://hal.archives-ouvertes.fr/hal-01053509
DOI : 10.1016/j.tecto.2014.01.007

Éditeur(s) : HAL CCSD Elsevier
Résumé : International audience
The Espinho Branco anatexite, located within a transcurrent, high-temperature shear zone in NE Brazil, was the subject of a comprehensive petrostructural study (Anisotropy of Magnetic Susceptibility - AMS, Anisotropy of Anhysteretic Remanence - AAR, Electron Backscatter Diffraction - EBSD) to evaluate the compatibility of different fabrics with the kinematics of melt deformation. Magnetite dominates susceptibilities larger than 1 mSI and biotite displays [001] lattice directions consistent with AMS k3 axes. In contrast, migmatites with a susceptibility lower than 0.5 mSI and no visible mesoscopic foliation provide crystallographic fabrics distinct from AMS and AAR. However, AAR remains consistent with the regional strain field. These results suggest that the correlation of field, AMS and crystallographic fabrics is not always straightforward despite the relatively simple organisation of the magnetic fabric in the anatexite. We conclude that AMS recorded the final stages of the strain field in the migmatite irrespective of its complex mesoscale structures and contrasting crystallographic fabrics.
ISSN: 0191-8141

hal-00823056
https://hal.archives-ouvertes.fr/hal-00823056
DOI : 10.1016/j.jsg.2012.12.008

Éditeur(s) : HAL CCSD Wiley
Résumé : International audience
Pathogenic agents can be very hard to detect, and usually they do not cause illness for several hours or days. To improve the speed and the accuracy of detection tests and satisfy the needs of early diagnosis, molecular biology methods such as PCR are now used. However, selecting a proper target gene and designing good primers is often not easy. We present a dedicated website, http://patho-genes.org, where we provide every sequence, functional annotation, published primer and relevant article for every annotated gene of major pathogenic bacterial species listed as key agents to be used for a bioterrorism attack. Each published primer was analysed to determine its melting temperature, its specificity and its coverage (i.e. its sensitivity against every allele of its target gene). Data generated have been organized in the form of data sheet for each gene, which are available through multiple browser panels and query systems.
ISSN: 1751-7915

hal-01546181
https://hal.archives-ouvertes.fr/hal-01546181
DOI : 10.1111/j.1751-7915.2012.00353.x