Éditeur(s) : HAL CCSD AGU and the Geochemical Society
Résumé : International audience
Mélange rocks outcrop widely in the central and western frontal sectors of the Betic Cordillera, as in many other collisional orogens where they form part of the accretionary wedges. Extrusion of Triassic plastic clays and evaporites was favored by the progressive accretion of the Betic External Zones, mixing rocks of different provenance and forming a synorogenic frontal mélange unit. MT data coupled with gravity data are a valid combined methodology to characterize the geometry of these mélange units, since the characterization of plastic rocks geometry is usually uncertain using seismic techniques. The results correlate well with known geological features (sedimentary basins, calcareous ranges, evaporitic rocks) and reveal the deep geometry. A resistive body, slightly dipping toward the SE, points to the continuity of the Iberian Massif below the Guadalquivir basin (2°) and the External Zones (6-8°). To the south, gravity models show the Iberian continental crust subducting below the Internal Zones with a roughly 20-35° slope. The main conductive bodies are related to the location of evaporitic rocks involved in the frontal mélange. They overlie the Iberian Massif and, southwards, the frontal Jurassic and Cretaceous limestone sequences of the External and Median Subbetics. In this setting, thick plastic rock units placed above the foreland could act as a lubricant facilitating continental subduction, and being progressively accreted toward a frontal mélange.
ISSN: 1525-2027

hal-00750364
https://hal.archives-ouvertes.fr/hal-00750364
DOI : 10.1029/2012GC004153

Éditeur(s) : HAL CCSD AGU and the Geochemical Society
Résumé : International audience
New magnetotelluric and receiver transfer function studies provide insights from the upper to the lower crust of the eastern Betic Cordillera, which is deformed by large folds, normal faults, and a major transcurrent left-lateral fault, the Carboneras Fault Zone (CFZ). Receiver function analysis determines a NNW dipping Moho reaching 20 degrees that increases in depth, from 20 km south of the CFZ up to 34 km in the Sierra de Los Filabres. In addition, seismic discontinuities determined in the upper crust are interpreted as major contacts between metamorphic complexes that are detached and folded. The MT inversion model reveals a conductive zone, also representing a crustal seismic discontinuity, associated with the Alpujarride/Nevado-Filabride contact and fitting the N vergent geometry of the Sierra Alhamilla antiform. A small flexure at Moho coincides with the CFZ, as revealed by the Bouguer anomaly trend, in agreement with the receiver function results. Moreover, the Bahr strike and tipper angle at the stations placed closest to the CFZ clearly reveal the continuity of the CFZ at least down to approximately 15 km in depth, crossing all the detected crustal discontinuities up to the Moho. The lack of a clear Moho offset associated with the Carboneras Fault supports the idea that some large strike-slip faults tend to accommodate the deformation by a broadening fault zone at lower crustal levels. Its nucleation could occur at the base of a thin crust, where melting processes critically reduced the lithospheric strength during the late Miocene, to then propagate upward, reaching the topographic surface. Northward, the lithosphere comprised moderately larger strength, and the crustal discontinuities favored the development of larger folds with kilometric amplitude instead of strike-slip faults since the late Miocene.
ISSN: 1525-2027

hal-00671024
https://hal.archives-ouvertes.fr/hal-00671024
DOI : 10.1029/2010GC003274

Éditeur(s) : HAL CCSD Elsevier
Résumé : International audience
Active faults from the Campo de Dalías (SE Betic Cordillera) allow us to constrain the deformation styles involved in the development of segmented oblique-slip faults. This sector constitutes the widest outcrop of Plio-Quaternary sediments in the northern boundary of the Alboran Sea. It has emerged since the Late Pliocene, and therefore provides recent deformation markers that are not disturbed by erosive processes. The faults started to grow during the Pleistocene, reactivating previous hybrid joints, with a normal-dextral slip. We present a detailed map of the largest fault in the area, the Loma del Viento fault, comprising six onshore segments. Based on field work and aerial photography, the distributions of the contiguous joints have been mapped, and the joints reactivated as faults are identified. Some of these fault segments are hard-linked, and fault slip enhances toward the linkage sectors between them with associated sedimentary depocenters. An electrical tomography profile reveals the wedge geometry of a unit of Pleistocene conglomerates and red silts that were coevally deposited during the fault movement. Long-term slip rate in the central part of the fault is estimated at 0.07 ± 0.03 mm/y. In addition, a seismic crisis nucleated close to the Loma del Viento fault during November 2010 was recorded. Moment tensor analysis of the two mainshocks (Mw 3.5 and 4.2) provides a focal solution indicating a N120°E striking right-lateral strike-slip fault. The corrugated morphology of the Loma del Viento fault may have influenced its seismic behavior. Some of the fault segments are oblique to the general motion of the fault. These oblique segments would provide higher resistance against the general fault motion and could lock the fault, leading to accumulate elastic energy.
ISSN: 0040-1951

hal-00750357
https://hal.archives-ouvertes.fr/hal-00750357
DOI : 10.1016/j.tecto.2011.12.001

Éditeur(s) : HAL CCSD Universidad Complutense de Madrid
Résumé : Based on new seismological and recent faulting data, we analyze five main sectors in the western part of the Betic Cordillera from an active tectonic perspective: i. The northwestern frontal sector of the cordillera, including the Morón de la Frontera area, with shallow (< 15 km depth) seismogenic active NE-SW reverse and strike-slip faults that do not reach the surface. ii. The Teba area, in the External Zones, which is deformed by sparse N-S to NW-SE normal faults with associated wedges of Quaternary sediments and active strike-slip faults at intermediate crustal levels. iii. The Ronda Basin, representing the major Late Miocene intramontane basin of the western Betic Cordillera, is mainly deformed by NNE-SSW and WNW-ESE folds and locally by NW-SE normal faults. iv. The internal part of the orogen, which is characterized by shallow (<40 km) and intermediate (40 to 120 km depth) seismicity beneath Málaga and the Alborán Sea, ENE-WSW folding, relief uplift, river incision and scarce active faults with surface expression. v. The Spanish Atlantic coast, which coincides with the western end of the Betic orogen, where Pliocene to Quaternary shallowmarine sedimentary rocks are deformed by meso-scale NW-SE oriented normal faults and few ENE-WSW reverse faults. These data support the recent tectonic activity of the western Betic Cordillera determined by the NW-SE Eurasian-African convergence with variable features from the mountain front, characterized by shallow deformations, up to the Internal Zones that mainly undergo uplift and intermediate seismicity.
ISSN: 1698-6180

hal-00750359
https://hal.archives-ouvertes.fr/hal-00750359
DOI : 10.5209/rev_JIGE.2012.v38.n1.39211

Éditeur(s) : HAL CCSD Elsevier
Résumé : International audience
Seismic anisotropy of the south Iberian upper mantle is investigated using shear-wave splitting of SKS phases. We analyzed teleseismic events recorded by sixteen permanent broadband stations installed on the southern Iberian Peninsula and in northern Africa, and we determined fast polarization directions phi, and delay times delta t between fast and slow components. The area of investigation extends across two important geological structures in the Variscan Iberian Peninsula: the Variscan Iberian Massif in its center, and the Gibraltar arc in the Southeast, that represents the most westerly Alpine belt in the western Mediterranean. Shear-wave splitting measurements from stations in the Betic domain show homogeneous ENE-WSW fast directions nearly parallel to the trend of the mountain belt, and smooth spatial variations. Stations in the North, toward the southern part of the Variscan Iberian Massif show homogeneous fast directions however trending NS to NE-SW, different from those recorded in the Betic. These observations may reflect a post-Hercynian (Variscan) deformation of the Ossa-Morena zone, related to the main stages in the tectonic evolution of this part, namely transpressional stage, transtensional stage and shortening episode, or a deformation related to the posterior Alpine orogeny. Along the Gibraltar arc, we observe a smoothly varying phi trend changing from ENE-WSW in the Eastern Betics to NS in the area of Gibraltar and Ceuta, following more or less the general trend of the mountain belt around the Alboran Sea, and the coastline. Since a similar rotation is also visible in results from Pn anisotropy, this suggests that the anisotropy is vertically coherent starting from just below the Moho. Comparing the anisotropy pattern expected from various geodynamic models with the observed SKS splitting suggests that the anisotropy is best explained by a model of slab rollback, rather than by delamination models.
ISSN: 0012-821X

hal-00412175
https://hal.archives-ouvertes.fr/hal-00412175
https://hal.archives-ouvertes.fr/hal-00412175/document
https://hal.archives-ouvertes.fr/hal-00412175/file/Buontempo_SKS_gibraltar_EPSL2008_hal.pdf
DOI : 10.1016/j.epsl.2008.06.024