Éditeur(s) : HAL CCSD Springer Verlag/EDP Sciences
Résumé : International audience
Context and aim : This study aimed to examine the effect of the tension wood G‐layer on the viscoelastic properties of wood. Methods : Tension wood and opposite wood samples were obtained from six French Guianese tropical rainforest species (Sextonia rubra, Ocotea guyanensis, Inga alba, Tachigali melinoni, Iyranthera sagotiana and Virola michelii); the tension wood of the former three of these species had a Glayer, whilst the tension wood from the latter three had no Glayer. Tensile dynamic mechanical analysis (DMA) was performed on green never dried wood samples in the longitudinal direction with samples submerged in a water bath at a temperature (30°C) and frequency (1 Hz) representative of the conditions experienced by wood within a living tree. Then, DMA was repeated with samples conditioned to an air-dried state. Finally, samples were oven-dried to measure longitudinal shrinkage. Results : Tension wood did not always have a higher longitudinal storage (elastic) modulus than opposite wood from the same tree regardless of the presence or absence of a G‐layer. For the species containing a G‐layer, tension wood had a higher damping coefficient and experienced a greater longitudinal shrinkage upon drying than opposite wood from the same species. No difference was found in damping coefficients between tension wood and opposite wood for the species that had no G‐layer. Conclusion : It is proposed that the different molecular composition of the G-layer matrix has an influence on the viscoelasticity of wood, even if a biomechanical gain is not yet clear. This study shows that rheological properties and longitudinal shrinkage can be used to detect the presence of a G‐layer in tension wood.
ISSN: 1286-4560

hal-00677460
https://hal.archives-ouvertes.fr/hal-00677460
https://hal.archives-ouvertes.fr/hal-00677460/document
https://hal.archives-ouvertes.fr/hal-00677460/file/Clair2.pdf
DOI : 10.1007/s13595-011-0164-1

Éditeur(s) : HAL CCSD De Gruyter
Résumé : International audience
Wallaba (Eperua falcata) is a tropical wood which is known to have naturally low swelling characteristics. Samples of wallaba heartwood were subjected to differential solvent extraction. Wood pieces that were extracted with methanol experienced significantly higher swelling after rehydration from oven dry to 96% relative humidity in comparison to non-extracted samples and samples extracted with other solvents. Methanol soluble wallaba heartwood extract was purified by high pressure liquid chromatography and the compounds present were characterised by nuclear magnetic resonance spectroscopy. Methanol extract was found to contain a very high relative proportion of polar compounds which are proposed to bind to the polymeric cell wall by multiple hydrogen bonds restricting the association of water and therefore acting as natural anti-swelling agents.
ISSN: 0018-3830

hal-00856942
https://hal.archives-ouvertes.fr/hal-00856942
https://hal.archives-ouvertes.fr/hal-00856942/document
https://hal.archives-ouvertes.fr/hal-00856942/file/Chemical_extractives_tropical_wood_Royer_al.pdf

Éditeur(s) : HAL CCSD Springer Verlag/EDP Sciences
Résumé : International audience
Background : This study examines the radial trend in wood stiffness of tropical rainforest trees. The objective was to determine if the type of growing environment (exposed plantation or dense primary forest) would have an effect on this radial trend. Methods : The axial elastic modulus of wood samples, representing a pith to bark cross-section, of six trees from several French Guianese species (two of Eperua falcata, one of Eperua grandiflora, two of Carapa procera and one of Symphonia gloubulifera) was measured using a dynamic "forced vibration" method. Results : Primary forest trees were observed to have a decrease in wood stiffness from pith to bark, whereas plantation trees, from the same genus or species, displayed a corresponding increase in wood stiffness. Juvenile wood stiffness appears to vary depending on the environment in which the tree had grown. Conclusion : We suggest that the growth strategy of primary forest trees is to produce wood resistant to selfbuckling so that the height of the canopy may be obtained with the maximum of efficiency. In contrast, the growth strategy of the trees growing in an exposed plantation is to produce low-stiffness wood, important to provide flexibility in wind. Further experiments to study the behaviour of more species, with more individuals per species, growing across a range of physical environments, are required.
ISSN: 1286-4560

hal-00644335
https://hal.archives-ouvertes.fr/hal-00644335
https://hal.archives-ouvertes.fr/hal-00644335/document
https://hal.archives-ouvertes.fr/hal-00644335/file/McLean_al.pdf
DOI : 10.1007/s13595-011-0085-z