Éditeur(s) : HAL CCSD Elsevier
Résumé : International audience
Seismic tomography and high surface heat flow models indicate an anomalously thin and hot lithospheric mantle beneath the Canadian Cordillera. To understand the thermal and deformational history of the lithospheric mantle under these conditions, we performed a study of the microstructures, crystal preferred orientations (CPO), and seismic anisotropy of mantle xenoliths collected in the Summit Lake volcano in the southern Canadian Cordillera. The xenoliths vary in composition between spinel lherzolites, cpx-rich lherzolites, and wehrlites. All samples are coarse-grained and show clear evidence for annealing, but deformation microstructures are well-preserved in the spinel lherzolites. Olivine CPO is characterized by a strong point-maximum of [100] and by a girdle distribution of [010[ and [001] axes normal to it; CPO strength is variable, spinel-lherzolites have the strongest CPO. Some samples show a weak orthopyroxene CPO consistent with the olivine one. However most pyroxenes have random CPO, interstitial shapes and undeformed appearance, which suggest a secondary origin by reactive melt percolation under static conditions, leading to crystallization of cpx + sp +/- opx at the expenses of olivine, followed by crystallization of cpx + sp +/- ol at the expenses of opx to produce the wehrlites. The studied xenoliths have typical upper mantle seismic properties patterns with fastest propagation of P-waves and polarization of S-waves parallel to the olivine [100] maxima. Maximum P- and S-waves anisotropy for lherzolites are 8 and 5% respectively. Dispersion of the olivine CPO due to neocrystallization of olivine results in weaker anisotropies (6.5 and 3.5%) in wehrlites. Seismic velocities calculated using a geotherm consistent with the equilibrium temperatures of the Summit Lake xenoliths are 3-4% lower than those expected in a normal, 100 km-thick lithosphere, consistent with seismic tomography models for the region. This high geothermal gradient may be partially explained by considering the anisotropy of thermal conductivity of olivine and subhorizontal foliations in the lithospheric mantle, which result in a decrease by up to 15% of the thermal conductivity in the vertical direction.
ISSN: 0040-1951

hal-00618332
https://hal.archives-ouvertes.fr/hal-00618332
DOI : 10.1016/j.tecto.2011.04.014

Éditeur(s) : HAL CCSD Elsevier
Résumé : International audience
To better understand the microstructural evolution of a "serpentinized" mantle rock and the influence of various hydrous phases on the seismic properties of the mantle wedge, we have conducted the detailed microstructural analyses of a sample of tremolite-chlorite-antigorite schist collected from the Moses Rock dike (central part of the Colorado Plateau). We performed differential effective media (DEM) modelling to study the effect of three hydrous phases forming two-phase aggregates with olivine, considering the crystallographic preferred orientation (CPO) of each phase and the shape ratio of the hydrous phases. We have demonstrated that in a partially serpentinized peridotite, the olivine CPO characteristic of [100](010) dislocation glide is still preserved, and the high-temperature asthenospheric flow is preserved with a foliation normal to that of antigorite schist. The transformation of olivine into antigorite occurs predominantly (~ 75%) by the relationship (100)ol || (001)atg with [001]ol || [010]atg, with the (010)ol || (001)atg and [001]ol || [010]atg relationship observed in areas of weak antigorite CPO. Chlorite results from the phase transformation of olivine in a relatively static environment, as shown by the correlation between the olivine-chlorite CPOs with (100)ol || (100)ch, (010)ol || (001)ch and (001)ol || (010)ch. The fluid percolation that caused the localized metasomatism and partial hydration of the mantle occurred possibly along trans-lithospheric shear zones. The presence of chlorite induces the most important drop on the P-wave velocities and may help to explain some local low velocities in the fore-arc mantle wedges, but is unlikely to be of global importance due to its very high Vp/Vs ratio ~ 1.9. On the other hand, antigorite is the only phase that causes important modification on the propagation directions of P and S-waves, and the only phase to explain the polarization of the fastest shear waves parallel to the subduction trench.
ISSN: 0040-1951

hal-00858061
https://hal.archives-ouvertes.fr/hal-00858061
DOI : 10.1016/j.tecto.2013.03.022

Éditeur(s) : HAL CCSD Elsevier
Résumé : Folds with hinge lines subparallel to stretching lineation are common features in shear zones and represent extreme cases of fold modification. However, their microstructures and in particular their kinematic significance remain poorly understood. Here we describe the meso- and micro-scale structures and crystallographic preferred orientation (CPO) of quartz and muscovite from a metric-scale shear-modified fold from Plattjen, Saas Fee, Western Internal Alps. The studied fold is of class-2 and the samples collected around the fold have essentially the same microstructures. Quartz [c]-axes plotted in the tectonic coordinate system exhibit an apparent reverse obliquity on opposing limbs. Muscovite fabrics are controlled essentially by the orientation of {001} planes. If the CPO data are plotted in a common reference frame (e.g. either fold or geographical), all samples exhibit essentially the same patterns for both minerals. In particular, relative to the fold axis and axial surface, the reversal of quartz CPO obliquity on opposing limbs is no longer evident. The small obliquity (~ 15°) between the intersection lineation of the two planes of {001} of muscovite and the fold axis results in the apparent reversal of shear sense on opposite limbs when viewing the CPO related to the macroscopic fabric. The homogeneity of the microstructures and CPOs of quartz and muscovite across the fold support the interpretation that the fold developed during simultaneous activation of heterogeneous and homogeneous simple shear, with the former responsible for fold development and the latter responsible for fold rotation and the overwhelming of the heterogeneous deformation. These processes led to the observed parallelism between fold hinge line and local stretching lineation.
ISSN: 0040-1951

hal-00824537
https://hal.archives-ouvertes.fr/hal-00824537
DOI : 10.1016/j.tecto.2011.03.003

Éditeur(s) : HAL CCSD European Geosciences Union
Résumé : No abstract available
ISSN: 1869-9510

hal-01115507
https://hal.archives-ouvertes.fr/hal-01115507
DOI : 10.5194/se-5-509-2014

Éditeur(s) : HAL CCSD American Geophysical Union (AGU)
Résumé : International audience
Microstructures and crystallographic preferred orientation (CPO) of anorthosite samples interlayered in the upper and lower gabbro sections in the Oman ophiolite were analyzed in this paper. In the anorthosites registering the dynamics of the melt lenses, foliation is flat lying and starts to develop a few meters below the root zone of the sheeted dike complex (RZSDC). Microstructures and CPO of these rocks were developed in response to four different mechanisms: (1) density-controlled settling of plagioclase on the lens floor, (2) deposition of anorthosites related to convection currents, (3) melt compaction, and (4) uncompacted melt accumulation. In these anorthosites, the poles to (010) of plagioclase are parallel to the flow plane of convection, whereas the [100] axes and poles to (001) express the convection flow direction and the axis of convection rolls, respectively. The effect of subsidence of melt lens floor is recorded immediately below the RZSDC and is characterized by the rapid (but progressive) development of dipping foliation and lineation, reflecting the increase of deformation downsection. The degree of foliation and CPO development in the anorthosites is directly related to the distance of the center of the melt lenses before the subsidence starts. Despite the uncertain origin of the anorthosites from the lower gabbro section, all the samples lost the magmatic microstructural characteristics and presently are reequilibrated aggregates. However, they still preserve plagioclase CPO, where some of these patterns present similarities with the anorthosites from the upper gabbro section, but no evidence of intracrystalline deformation under high temperatures.
ISSN: 0278-7407

hal-00617446
https://hal.archives-ouvertes.fr/hal-00617446
DOI : 10.1029/2010TC002697

Éditeur(s) : HAL CCSD European Geosciences Union
Résumé : This study presents a unique database of 172 plagioclase Crystallographic Preferred Orientations (CPO) of variously deformed gabbroic rocks. The CPO characteristics as a function of the deformation regime (magmatic or crystal-plastic) are outlined and discussed. The studied samples are dominantly from slow- and fast-spread present-day ocean crust, as well as from the Oman ophiolite. Plagioclase is the dominant mineral phase in the studied samples. Plagioclase CPOs are grouped into three main categories: Axial-B, a strong point alignment of (010) with a girdle distribution of [100]; Axial-A, a strong point maximum concentration of [100] with parallel girdle distributions of (010) and (001); and P-type, point maxima of [100], (010), and (001). A majority of CPO patterns are Axial-B and P-type, in samples showing either magmatic or crystal-plastic deformation textures. Axial-A CPOs are less common; they represent 21% of the samples deformed by crystal-plastic flow. Although fabric strength (ODF J index) does not show any consistent variation as a function of the CPO patterns, there is a significant difference in the relationship between the ODF and pole figures J indices; the magmatic type microstructures have high (010) pole figures J indices, which increase linearly with ODF J index, whereas the high [100] pole figures J indices of plastically deformed samples vary in a more scattered manner with ODF J index. The multistage nature of plastic deformation superposed on a magmatic structure compared with magmatic flow, and the large number of possible slip-systems in plagioclase probably account for these differences. Calculated seismic properties (P wave and S wave velocities and anisotropies) of plagioclase aggregates show that anisotropy (up to 12% for P wave and 14% for S wave) tends to increase as a function of ODF J index. In comparison with the olivine 1998 CPO database, the magnitude of P wave anisotropy for a given J index is much less than olivine, whereas it is similar for S wave anisotropy. Despite a large variation of fabric patterns and geodynamic setting, seismic properties of plagioclase-rich rocks have similar magnitudes of anisotropy. There is a small difference in the aggregate elastic symmetry, with magmatic microstructures having higher orthorhombic and hexagonal components, whereas plastic deformation microstructures have a slightly higher monoclinic component, possibly correlated with predominant monoclinic simple shear flow in plastically deformed samples. Overall, plots for CPO strength (ODF J index), pole figure strength, CPO symmetry and seismic anisotropy show significant scattering. This could be related to sampling statistics, although our database is a factor of ten higher than the olivine database of 1998, or it could be related to the low symmetry (triclinic) structure of plagioclase resulting in the addition of degrees of freedom in the processes creating the CPOs.
ISSN: 1869-9510

hal-00963439
https://hal.archives-ouvertes.fr/hal-00963439
DOI : 10.5194/se-4-511-2013

Éditeur(s) : HAL CCSD Elsevier
Résumé : International audience
Quartz is a common crustal mineral that deforms plastically in a wide range of temperatures and pressures, leading to the development of different types of crystallographic preferred orientation (CPO) patterns. In this contribution we present the results of an extensive modeling of quartz fabric transitions via a viscoplastic self-consistent (VPSC) approach. For that, we have performed systematic simulations using different sets of relative critical resolved shear stress of the main quartz slip systems. We have performed these simulations in axial compression and simple shear regimes under constant Von Mises equivalent strain of 100% (γ = 1.73), assuming that the aggregates deformed exclusively by dislocation glide. Some of the predicted CPOs patterns are similar to those observed in naturally and experimentally deformed quartz. Nevertheless, some classical CPO patterns usually interpreted as result from dislocation glide (e.g. Y-maxima due to prism < a > slip) are clearly not developed in the simulated conditions. In addition we reported new potential preferred orientation patterns that might happen in high temperature conditions, both in axial compression and simple shear. We have demonstrated that CPOs generated under axial compression are usually stronger that those predicted under simple shear, due to the continuous rotation observed in the later simulations. The fabric strength depends essentially on the dominant active slip system, and normally the stronger CPOs result from dominant basal slip in < a >, followed by rhomb < a > and prism [c] slip, whereas prism < a > slip does not produce strong fabrics. The opening angle of quartz [0001] fabric used as a proxy of temperature seems to be reliable for deformation temperatures of ~ 400 °C, when the main slip systems have similar behaviors.
ISSN: 0040-1951

hal-01115674
https://hal.archives-ouvertes.fr/hal-01115674
DOI : 10.1016/j.tecto.2014.08.011