Éditeur(s) : HAL CCSD Elsevier
Résumé : International audience
Diffusion parameters for HTO, 36Cl−, and 125I− were determined on Upper Toarcian argillite samples from the Tournemire Underground Research Laboratory (Aveyron, France) using the through diffusion technique. The direction of diffusion was parallel to the bedding plane. The purpose of the present study was 3-fold; it was intended (i) to confirm the I− interaction with Upper Toarcian argillite and to verify the effects of initial I− concentration on this affinity, as previously observed by means of radial diffusion experiments, (ii) to highlight any discrepancy between Cl− and I− diffusivity, and (iii) to investigate the effect of an increase of the ionic strength of the solution on the anionic tracers' diffusive behaviour. The results show that the effective diffusion coefficient (De) and diffusion accessible porosity (εa) values obtained with an ionic strength (I.S.) synthetic pore water of 0.01 eq L−1 are: De = 2.35-2.50 × 10−11 m2 s−1 and εa = 12.0-15.0% for HTO, and De = 14.5-15.5 × 10−13 m2 s−1 and εa = 2.5-2.9% for 36Cl−. Because of anionic exclusion effects, anions diffuse slower and exhibit smaller diffusion accessible porosities than HTO, taken as a water tracer. The associated effective diffusion coefficient (De) and rock capacity factor (α) obtained for 125I are: De = 7.00-8.60 × 10−13 m2 s−1 and α = 4.3-7.2%. Such values make it possible to calculate low 125I distribution ratios (0.0057 < RD < 0.0192 mL g−1) which confirm the trend indicating that the 125I rock capacity factor increases with the decrease of the initial I− concentration. Additional through-diffusion experiments were carried out with a higher ionic strength synthetic pore water (I.S. = 0.11 eq L−1). No evolution of HTO diffusion parameters was observed. The anionic tracers' effective diffusion coefficient increased by a factor of two but no clear evolution of their accessible porosity was observed. Such a paradox could be related to the particularly small mean pore size of the Upper Toarcian argillite of Tournemire. The most significant finding of this study is the large discrepancy (factor of two) between the values of the effective diffusion coefficient for 125I and 36Cl. Whatever the ionic strength of the synthetic solution used, 125I exhibited De values two times lower than those of 36Cl. A detailed explanation for this difference cannot be given at present even if a hypothesis based on ion-pairing or on steric-exclusion cannot be excluded. This makes questionable the assumption usually made for quantifying 125I sorption and postulating that 36Cl and 125I would diffuse in the same porosity. In other terms, at Tournemire, 125I sorption could be more pronounced than previously indicated.
ISSN: 0883-2927

hal-00757749
https://hal.archives-ouvertes.fr/hal-00757749
DOI : 10.1016/j.apgeochem.2011.12.017

Éditeur(s) : HAL CCSD Elsevier
Résumé : Among the radionuclides that can migrate from radioactive wastes buried within consolidated argillaceous rocks, I-129 poses a particular problem due to its high mobility in geomedia and its very long half-life of 1.6 10(7) years. Previous studies carried out on such rocks showed the existence of a low iodide retardation regarding the other anion species. The purpose of the present study was two-fold. It was hoped (1) to confirm this retardation by means of radial diffusion experiments and (2) to estimate the influence of the initial iodide concentrations towards the iodide uptake. The results obtained from in-diffusion stage show that (1) no iodide uptake occurs at high initial concentrations and (2) an uptake at low initial concentrations cannot be clearly evidenced. Finally. the most singular behaviour of iodide was highlighted for all the initial iodide concentrations, from the out-diffusion stage. during which some amount of iodide, available for out-diffusion, were not involved in the diffusion process. Although the origin of such phenomenon remains unclear, a kinetic effect for the iodide uptake was proposed, assuming that the period of 55days (corresponding to the in-diffusion stage duration) would be necessary for inducing the iodide uptake. This kinetic effect, already shown elsewhere by (Descostes. M., Blin, V., Bazer-Bachi, F., Meier, P., Grenut, B., Radwan. J., Schlegel, M.L., Buschaert, S.. Coelho, D, Tevissen, E. Diffusion of anionic species in Callovo-Oxfordian argillites and Oxfordian limestones. In press for Appl. Geochem.) on similar materials, needs to be deepened.
ISSN: 0079-1946

hal-00412393
https://hal.archives-ouvertes.fr/hal-00412393
DOI : 10.1016/j.pce.2008.05.020

Éditeur(s) : HAL CCSD
Résumé : In order to minimize CO2 atmospheric concentration, a solution consists in sequestrating CO2 in geological reservoirs. To estimate long term risks, it is necessary to quantify the couplings between reaction processes as well as structural and hydrodynamical modifications. We realised two experimental benches enabling injecting CO2-enriched-brine in conditions corresponding to in situ storage (T < 200 oC and P < 200 bar) and developed
an experimental protocol using X-Ray microtomography and fluid and rock analyses in order to measure the variations of physical and chemical parameters.
The study of carbonated reservoirs near the injection well, allows quantifying different k-phi relationships depending on the dissolution processes and triggered by the local fluid chemical composition and initials conditions. Away from the injection well, we observe carbonate precipitation decreasing the permeability. The study of fracturated caprock samples shows that alternative percolation of CO2-enriched-brine and CO2 gas increases the fracture permeability.
The study of silicated rocks indicates carbonate precipitation in zeolite sandstone and sintered dunite grains. Nevertheless, in zeolite sandstone we also observe the precipitation of clay particles located in the uid pathways which decrease strongly the permeability.
Afin de minimiser la concentration en CO2 dans l'atmosphère une solution consiste à le séquestrer dans les réservoirs géologiques. Pour évaluer les risques à long terme, il est nécessaire de quantifier les couplages entre les processus réactionnels et les modifications structurales et hydrodynamiques. Dans cette optique, nous avons construit deux dispositifs expérimentaux permettant d'injecter des saumures chargées en CO2 dans les conditions de stockage (T < 200 °C et P < 200 bar) et mis en oeuvre un protocole expérimental utilisant la microtomographie RX et l'analyse des roches et des fuides pour quantifier les variations des paramètres physiques et chimiques. Dans le cas des réservoirs carbonatés, on observe, près du puits d'injection, une forte variabilité des relations k-phi en fonction du régime de dissolution contrôlé par la chimie locale du fluide, ainsi que par les conditions initiales. A plus grande distance, on observe des processus de précipitation diminuant fortement la perméabilité. L'étude des roches de couverture fracturées (argilite) a montré qu'une percolation alternée d'une saumure chargée en CO2 et de CO2 gaz augmentait la perméabilité de fracture. Dans le cas des roches silicatées, la précipitation de carbonates est mise en évidence aussi bien dans les grès à zéolites que dans les frittés de dunite de San Carlos. Cependant, dans les grès à zéolites, la précipitation d'une phase argileuse est observée dans les chemins d'écoulement et engendre une forte diminution de la perméabilité.
https://tel.archives-ouvertes.fr/tel-00416408

tel-00416408
https://tel.archives-ouvertes.fr/tel-00416408
https://tel.archives-ouvertes.fr/tel-00416408/document
https://tel.archives-ouvertes.fr/tel-00416408/file/These_Luquot.pdf

Éditeur(s) : HAL CCSD American Geophysical Union
Résumé : Results are reported for an acidic water flow-through experiment conducted in a fractured argillaceous limestone sample (73% carbonates). The change in fracture geometry and related parameters is reported for six data sets obtained from synchrotron X-ray microtomography experiments. High-resolution three-dimensional images of the sample allowed quantification of the changes in fracture morphology at a spatial resolution of 6 ;μm. Mineral mass loss and permeability changes in the sample were also determined. Several physico-chemical phenomena were identified during the experiment. Initial smooth fracture surfaces evolved rapidly toward rough surfaces with uneven clay coverage due to the preferential dissolution of carbonate minerals compared to clay minerals whose dissolution rate is about 106 slower. A microporous clay coating progressively developed at the fluid-rock interface during heterogeneous dissolution of the fracture, while the global dissolution rate of the fracture walls exponentially decreased. The increase in surface roughness and the presumed reorganization of clays caused a progressive reduction in permeability. During the last flow-through stage, a large decrease in sample permeability was attributed to the large removal of clay particles; this process was responsible for a dramatic collapse of the fracture walls near the sample inlet and led to the development of preferential flow pathways. The development of the clay coating also acted as a barrier to flow and mass transfer between calcite grains and bulk solution and affected transport processes within the fracture
ISSN: 0043-1397

hal-00405333
https://hal.archives-ouvertes.fr/hal-00405333
DOI : 10.1029/2006WR005379

Éditeur(s) : HAL CCSD Elsevier
Résumé : International audience
The Roussillon sedimentary Basin (South France) is a complex multi-layered aquifer, close to the Mediterranean Sea facing seasonally increases of water abstraction and salinization issues. We report geochemical and isotopic vertical variability in this aquifer using groundwater sampled with a Westbay System® at two coastal monitoring sites: Barcarès and Canet. The Westbay sampling allows pointing out and explaining the variation of water quality along vertical profiles, both in productive layers and in the less permeable ones where most of the chemical processes are susceptible to take place.The aquifer layers are not equally impacted by salinization, with electrical conductivity ranging from 460 to 43,000 μS·cm− 1. The δ2H–δ18O signatures show mixing between seawater and freshwater components with long water residence time as evidenced by the lack of contribution from modern water using 3H, 14C and CFCs/SF6. S(SO4) isotopes also evidence seawater contribution but some signatures can be related to oxidation of pyrite and/or organically bounded S. In the upper layers 87Sr/86Sr ratios are close to that of seawater and then increase with depth, reflecting water–rock interaction with argillaceous formations while punctual low values reflect interaction with carbonate. Boron isotopes highlight secondary processes such as adsorption/desorption onto clays in addition to mixings. At the Barcarès site (120 m deep), the high salinity in some layers appear to be related neither to present day seawater intrusion, nor to Salses-Leucate lagoonwater intrusion. Groundwater chemical composition thus highlights binary mixing between fresh groundwater and inherited salty water together with cation exchange processes, water–rock interactions and, locally, sedimentary organic matter mineralisation probably enhanced by pyrite oxidation.Finally, combining the results of this study and those of Caballero and Ladouche (2015), we discuss the possible future evolution of this aquifer system under global change, as well as the potential management strategies needed to preserve quantitatively and qualitatively this water resource.
ISSN: 0048-9697

hal-01685219
https://hal-brgm.archives-ouvertes.fr/hal-01685219
DOI : 10.1016/j.scitotenv.2016.05.016

Éditeur(s) : HAL CCSD American Geophysical Union
Résumé : International audience
Claystone caprocks are often the ultimate seal for CO2 underground storage when residual CO2 gas reaches the reservoir top due to buoyancy. Permeability changes of a fractured claystone due to seepage of CO2-enriched brine and water vapor-saturated CO2 gas are investigated. Results show that brine flow induces a large porosity increase (up to 50%) in the vicinity of the fracture due to dissolution of calcite and quartz, while permeability remains unchanged. Conversely, cyclic flows of CO2-brine and CO2-gas increase the fracture aperture abruptly after each gas flow period, producing a progressive decrease of the caprock seal capacity. Aperture increase is controlled by decohesion of the clay framework within a micrometer-scale-thick layer induced by CO2-gas acidification. Results show that hydraulic aperture increases linearly with duration of the preceding CO2-brine flow period, emphasizing the kinetic control of the quartz grains dissolution during the brine flow periods.
ISSN: 0094-8276

hal-00412332
https://hal.archives-ouvertes.fr/hal-00412332
DOI : 10.1029/2008GL034467