Éditeur(s) : HAL CCSD Mineralogical Society of America
Résumé : International audience
To test if hydrogen incorporation by ionic diffusion can occur between a volatile-rich kimberlitic liquid and forsterite, results of high-pressure and high-temperature experiments using a piston-cylinder apparatus at 1200–1300 °C and 1 GPa for durations of 1 min, 5 h, and 23 h, are reported here. Kimberlitic liquid in the system CaO-MgO-Al2O3-SiO2-CO2-H2O and synthetic forsterite single crystals were chosen as a first simplification of the complex natural kimberlite composition. Unpolarized Fourier transform infrared spectroscopy was used to quantify the concentrations of OH in the crystallographically oriented forsterite. Scanning electron microscopy, electron backscattered diffraction, electron microprobe analyses, and transmission electron microscopy were performed to identify the run products. After 5 and 23 h, a forsterite overgrowth crystallized with the same orientation as the initial forsterite single crystal. The kimberlitic liquid has crystallized as micrometer-scale euhedral forsterite neocrystals with random crystallographic orientations, as well as a nanoscale aluminous phase and a calcic phase. Despite theoretical water-saturation of the system and long duration, none of the initial forsterite single crystals display signs of hydration such as hydrogen diffusion profile from the border toward the center of the crystal. Most likely, the presence of CO2 in the system has lowered the H2O fugacity to such an extent that there is no significant hydration of the starting forsterite single crystal or its overgrowth. Also, the presence of CO2 enhances rapid forsterite crystal growth. Forsterite growth rate is around 2 × 108 μm3/h at 1250 °C. These experimental results suggest a deep mantle origin of the high OH content found in natural mantle-derived xenoliths transported in kimberlites, as reported from the Kaapvaal craton. In agreement with previous studies, it also points out to the fact that significant hydration must take place in a CO2-poor environment.
ISSN: 0003-004X

hal-01217157
https://hal.archives-ouvertes.fr/hal-01217157
DOI : 10.2138/am-2015-5200

Éditeur(s) : HAL CCSD Elsevier
Résumé : International audience
The minerals constituting the Earth's upper mantle are nominally anhydrous silicates (NAMs). However they do contain hydrogen as a trace element, decorating point defects in their crystalline structure. Experimental petrology and mineralogy have quantified the maximum concentration under several compositional and thermodynamic conditions, but systematic studies on the hydrogen concentration in minerals from mantle-derived rocks have only recently been carried out. Here, we have compiled the distribution of hydrogen in upper mantle peridotite xenoliths, from which several conclusions can be drawn. NAMs from peridotite xenoliths contain a few ppm wt. H2O in their structure. From the current database, the hydrogen concentrations in olivine regularly increase with increasing depth. The amount of hydrogen in NAMs from peridotite xenoliths from subduction contexts is not higher than in other geological context for similar temperature and pressure conditions. The highest hydrogen concentrations is found in peridotitic olivines from cratonic mantle, and are likely due to the depth of origin. The increasing hydrogen concentration in olivine with increasing depth is likely controlled by the increase of H partitioning into olivine at the expense of orthopyroxene as imposed by a decrease in Al content in opx with depth. However, the sparse data could also indicate that the bulk hydrogen concentration slightly increases with depth > 150 km. In this case, it would suggest, locally (Udachnaya for example), a possible increase in water fugacity due to fluid saturation. Even if the most abundant mineral in mantle rocks is olivine, the bulk hydrogen concentration in peridotites is controlled by the amount of hydrogen stored in pyroxenes. However, hydrogen concentration in olivine remains crucial for consequences on physical properties such as rheology and electrical conductivity. Kinetics of hydrogen transport is reviewed and hydrous melt/fluid percolation appears necessary to homogenize the hydrogen distribution at km-scale. Sampling of natural rock specimens is currently biased (e.g., in favor of optically attractive samples) and needs improvement, which will be achieved by increasing sample diversity (all type of grain sizes, lithologies, geological settings) and size of rock samples, as well as advances in analytical techniques. Acquisition of high quality data will be achieved by studying the co-existing minerals in mantle specimens, exploring each sample by linear and mapping measurements, and using appropriate FTIR calibrations for polarized and unpolarized radiation.
ISSN: 0024-4937

hal-01306676
https://hal.archives-ouvertes.fr/hal-01306676
DOI : 10.1016/j.lithos.2015.11.012

Éditeur(s) : HAL CCSD Taylor & Francis: STM, Behavioural Science and Public Health Titles
Résumé : International audience
The dislocation microstructures in a single crystal of olivine deformed experimentally in uniaxial compression at 1090 °C and under a confining pressure of 300 MPa, have been investigated by transmission electron tomography in order to better understand deformation mechanisms at the microscale relevant for lithospheric mantle deformations. Investigation by electron tomography reveals microstructures, which are more complex than previously described, composed of and dislocations commonly exhibiting 3D configurations. Numerous mechanisms such as climb, cross-slip, double cross-slip as well as interactions like junction formations and collinear annihilations are the source of this complexity. The diversity observed advocates for microscale deformation of olivine significantly less simple than classic dislocation creep reported in metals or ice close to melting temperature. Deciphering mechanism of hardening in olivine at temperatures where ionic diffusion is slow and is then expected to play very little role is crucial to better understand and thus model deformation at larger scale and at temperatures (900–1100 °C) highly relevant for the lithospheric mantle.
ISSN: 1478-6443

hal-01667146
https://hal.archives-ouvertes.fr/hal-01667146
DOI : 10.1080/14786435.2017.1367858

Éditeur(s) : HAL CCSD Oxford University Press (OUP)
Résumé : International audience
The mantle above a subducting slab is the site of complex interactions between deformation, partial melting, fluid migration and magma transport. To constrain these interactions and their effects on olivine deformation, we analyze microstructures, crystal preferred orientations, and water contents of peridotite xenoliths entrained by andesites of the Avacha volcano, southern Kamchatka arc. These xenoliths are refractory spinel harzburgites that have coarse-grained microstructures with widely spaced subgrain boundaries and sinuous grain boundaries in olivine, consistent with deformation by dislocation creep under low deviatoric stress (< 13 MPa) and with a significant contribution from diffusional processes. Analysis of crystal preferred orientations (CPO) indicates dominant activation of high-temperature, low-stress {0kl}[100] slip systems in olivine and of(100)[001] in orthopyroxene. In most samples, coarse opx crystals, elongated parallel to the lineation, enclose small olivine grains in crystallographic continuity with neighbouring crystals, indicating crystallization of orthopyroxene at the expense of olivine as a result of reactive percolation of Si-rich fluids coeval with the high-temperature deformation. Secondary crystallization of interstitial orthopyroxene led locally to development of opx-rich lenses parallel to the foliation, characterized by a decrease in olivine grain size and dispersion of the olivine CPO without changing the dominant slip systems. Half of the samples also show acicular orthopyroxene aggregates with which is associated a fine-grained matrix composed of rounded strain-free olivine, orthopyroxene, spinel, and rare amphibole crystals. This matrix occurs pervasively along grain boundaries or forms millimeter-scale irregular lenses and anastomosing veinlets that crosscut the coarse crystals and their ductile deformation structures. Both acicular orthopyroxene and the fine-grained matrix are interpreted as resulting from reactive transport of H2O-rich fluids under static conditions, probably in the lithospheric mantle. Infrared analyses show that olivine contains 1-8 center dot 6 ppm by weight of water. These low water contents are similar to those observed in spinel peridotites from other subduction zones and probably record both the low solubility of water in olivine at low pressure and dehydration during exhumation of the xenoliths. Water contents in orthopyroxene are highly variable (25-506 ppm H2O), probably recording spatially heterogeneous interaction with fluids or melts and compositional disequilibrium in the studied samples. Change in the dominant percolation mechanism from porous flow to fracturing suggests cooling, consistent with the low temperatures estimated from pyroxene thermometry (< 800-900 degrees C). The Avacha xenoliths therefore record pervasive deformation of a region of the mantle under asthenospheric conditions, followed by its accretion to the base of the lithosphere, probably as a result of cooling of the mantle wedge. Percolation of Si-rich fluids or hydrous melts is recorded at all stages; this probably enhanced diffusion and lowered deviatoric stresses during ductile deformation, but did not change the dominant slip direction in olivine from [100] to [001].
ISSN: 0022-3530

hal-00456053
https://hal.archives-ouvertes.fr/hal-00456053
DOI : 10.1093/petrology/egp085

Éditeur(s) : HAL CCSD Nature Publishing Group
Résumé : International audience
Mantle flow involves large strains of polymineral aggregates. The strongly anisotropic plastic response of each individual grain in the aggregate results from the interactions between neighbouring grains and the continuity of material displacement across the grain boundaries. Orthorhombic olivine, which is the dominant mineral phase of the Earth's upper mantle, does not exhibit enough slip systems to accommodate a general deformation state by intracrystalline slip without inducing damage. Here we show that a more general description of the deformation process that includes the motion of rotational defects referred to as disclinations can solve the olivine deformation paradox. We use high-resolution electron backscattering diffraction (EBSD) maps of deformed olivine aggregates to resolve the disclinations. The disclinations are found to decorate grain boundaries in olivine samples deformed experimentally and in nature. We present a disclination-based model of a high-angle tilt boundary in olivine, which demonstrates that an applied shear induces grain-boundary migration through disclination motion. This new approach clarifies grain-boundary-mediated plasticity in polycrystalline aggregates. By providing the missing mechanism for describing plastic flow in olivine, this work will permit multiscale modelling of the rheology of the upper mantle, from the atomic scale to the scale of the flow.
ISSN: 0028-0836

hal-01054315
https://hal.archives-ouvertes.fr/hal-01054315
DOI : 10.1038/nature13043

Éditeur(s) : HAL CCSD Taylor & Francis: STM Behavioural Science and Public Health Titles Taylor & Francis: STM, Behavioural Science and Public Health Titles
Résumé : We have investigated by electron tomography, in a transmission electronic microscope, the interactions between dislocations in olivine single crystals and polycrystals deformed in axial compression at T < 1000 °C (T < 0.5Tm). Dislocations are mostly of the [0 0 1] type, except in the polycrystal where [1 0 0] and [0 0 1] dislocations have been activated. A few 〈1 0 1〉 junctions have been found and characterized. Many collinear interactions have been identified either involving direct interactions between crossing dislocations of opposite Burgers vectors or indirect interactions between dislocations gliding in parallel planes and sessile dislocation loops. We suggest that collinear interaction, already identified as the primary source of strain hardening in FCC metals, is the main dislocation interaction mechanism in olivine deformed at temperatures below 1000 °C.
ISSN: 1478-6443

hal-01174166
https://hal.archives-ouvertes.fr/hal-01174166
DOI : 10.1080/14786435.2014.1000996