Éditeur(s) : HAL CCSD AGU and the Geochemical Society
Résumé : International audience
The transition between the small melt lens observed on top of fast spreading ridge magma chambers and the overlying sheeted dike complex marks the interface between magma and the hydrothermal convective system. It is therefore critical to our understanding of fast spreading ridge accretion processes. We present maps of two areas of the Oman ophiolite where this transition zone is observed as continuous outcrops. Our observations, which include the base of the sheeted dike being crosscut by gabbros, are consistent with episodic dike injections in a steady state model but also suggest that the root of these dikes is commonly erased by vertical movements of the top of the melt lens. Dike assimilation is a possible mechanism for incorporating hydrated phases, which result from hydrothermal alteration, to the melt lens during upward migrations of its upper boundary. Upward migrations are also responsible for a granoblastic overprint of the root of the dikes that is also observed in the stoped diabase xenoliths. This granoblastic overprint attests to reheating of previously hydrothermally altered lithologies which can even trigger hydrous partial melting due to the lowering of the solidus of mafic lithologies by the presence of a water activity. Clinopyroxenes present in these granoblastic lithologies are typically low in Ti and Al content, thus strongly contrasting with corresponding magmatic clinopyroxene. This may attest to the recrystallization of clinopyroxenes after amphiboles under the peculiar conditions present at the root zone of the sheeted dike complex. Downward migrations of the top of the melt lens result in the crystallization of the isotropic gabbros at its roof, which represent the partly fossilized melt lens. Melt lens fossilization eventually occurs when magma supply is stopped or at the melt lens margins where the thermal conditions become cooler. Melt lens migration, recrystallization of hydrothermally altered sheeted dikes during reheating stages, and assimilation processes observed in the Oman ophiolite are consistent with the observations made in IODP Hole 1256D. We propose a general dynamic model in which the melt lens at fast spreading ridges undergoes upward and downward movements as a result of either eruption/replenishment stages or variations in the hydrothermal/magmatic fluxes.
ISSN: 1525-2027

hal-00445249
https://hal.archives-ouvertes.fr/hal-00445249
DOI : 10.1029/2009GC002652

Éditeur(s) : HAL CCSD Elsevier Masson
Résumé : International audience
The seismological study of recent seismic crises near Oleron Island confirms the coexistence of an extensional deformation and a transtensive regime in the Atlantic margin of France, which is different from the general western European stress field corresponding to a strike-slip regime. We argue that the switch of the principal stress axes σ1/σ2 in a NW-SE vertical plane is linked with the existence of crustal heterogeneities. Events of magnitude larger than 5 sometimes occur along the Atlantic margin of France, such as the 7 September 1972 (ML = 5.2) earthquake near Oleron island and the 30 September 2002 (ML = 5.7) Hennebont event in Brittany. To test the mechanism of local strain localization, we model the deformation of the hypocentral area of the Hennebont earthquake using a 3D thermo-mechanical finite element code. We conclude that the occurrence of moderate earthquakes located in limited parts of the Hercynian shear zones (as the often reactivated swarms near Oleron) could be due to local reactivation of pre-existing faults. These sporadic seismic ruptures are favoured by stress concentration due to rheological heterogeneities.
ISSN: 1631-0713

hal-00936220
https://hal.archives-ouvertes.fr/hal-00936220
DOI : 10.1016/j.crte.2013.07.004

Éditeur(s) : HAL CCSD
Résumé : International audience
Understanding subduction rheology in both space and time has been a challenge since the advent of plate tectonics. We herein focus on "subduction infancy", that is the first ~1-5 My immediately following subduction nucleation, when a newly born slab penetrates into the upper plate mantle and heats up. The only remnants of this critical yet elusive geodynamic step are thin metamorphic soles, commonly found beneath pristine, 100-1000 km long portions of oceanic lithosphere emplaced on continents (i.e., ophiolites).Through the (i) worldwide compilation of pressure-temperature conditions of metamorphic sole formation augmented by pseudosection thermodynamic modeling, (ii) calculations of the viscosity of materials along the plate interface and (iii) generic numerical thermal models, we provide a conceptual model of dynamic plate interface processes during subduction infancy (and initiation s.l.).We show in particular how major rheological switches across the subduction interface control slab penetration, and the formation of metamorphic soles. Due to the downward progression of hydration and weakening of the mantle wedge with cooling, the lower plate (basalt, sediment) and the upper plate (mantle wedge) rheologies equalize and switch over a restricted temperature-time-depth interval (e.g., at ~800°C and ~1 GPa, during 0.1-2 My, for high-temperature metamorphic sole formation). These switches result in episodes of maximum interplate mechanical coupling, thereby slicing the top of the slab and welding pieces (basalt, sediment) to the base of the mantle wedge. Similar mechanical processes likely apply for the later, deeper accretion and exhumation of high-temperature oceanic eclogites in serpentinite mélanges, or for the accretion of larger tectonic slices.This model provides constraints on the effective rheologies of the crust and mantle and general understanding, at both rock and plate scale, for accretion processes and early slab dynamics.
AGU Fall Meeting 2015
San Francisco, United States

insu-01242103
https://hal-insu.archives-ouvertes.fr/insu-01242103

Éditeur(s) : HAL CCSD Oxford University Press (OUP)
Résumé : International audience
Anisotropy of low-field magnetic susceptibility (AMS) of basaltic lava flows can give some clues about post-emplacement tilting occurring in volcanic sequences. Such a study has been carried out on a sequence of 19 successive lava flows from Kerguelen Archipelago. Surprisingly, two different patterns were observed. The first one - herein called normal fabric - is consistent with the lava-flow direction inferred from geological observations, whereas the second one observed for about 70 per cent of the analysed samples - herein called abnormal fabric - appears to be unrelated to the shear history of the lava flows during their emplacements. These abnormal fabrics are not strictly inverse fabric but seem to have a more complex origin. The unusual nature of these abnormal fabrics has been confirmed by lattice preferred orientation of plagioclases obtained from high-resolution electron backscattered diffraction measurements. The aim of this study is to propose a physical interpretation of these fabrics. A first step in our understanding was to clearly identify the nature and the magnetic properties of the Fe-Ti oxides assemblage. Thus, we present a comprehensive rock magnetic analysis relying on low- and high-temperature thermomagnetic curves (K-T), crossover diagrams, first-order reversal curves, ore-microscopy, Mössbauer measurements and electron backscattered images. We found that in the present case the abnormal fabrics are probably linked to a mixture of prevailing single domain (SD) strongly interacting grains population and a subsidiary multidomain grains population. SD grains are identified as small magnetite crystallized within the interstitial glass in globular aggregates along the silicate framework. Then a question arises: to what extent such SD interacting grains in globular aggregates can affect the magnetic susceptibility and its anisotropy? To answer this question, we developed a physical model in which the total energy density of an SD grain with an uniaxial anisotropy is minimized. In this model, the distribution function of the direction of the magnetic interaction field is comprised between two boundary states. It is either isotropic, which formally corresponds to the thermal demagnetized state, or it is ordered, which formally corresponds to the Alternative Field demagnetized state. We show that in both cases the degree of anisotropy decreases as the interaction field increases. Thus, we conclude that the abnormal fabric encountered in this study can be simply explained by strong magnetostatic interactions that would explain the large scattering of AMS often observed in basaltic lava flows.
ISSN: 0956-540X

hal-00716449
https://hal.archives-ouvertes.fr/hal-00716449
https://hal.archives-ouvertes.fr/hal-00716449/document
https://hal.archives-ouvertes.fr/hal-00716449/file/gji-S-12-HAL.pdf
DOI : 10.1111/J.1365-246X.2012.05421.X

Éditeur(s) : HAL CCSD Nature Publishing Group
Résumé : International audience
Temperature and fluid pressure conditions control rock deformation and mineralization on geological faults, and hence the distribution of earthquakes1. Typical intraplate continental crust has hydrostatic fluid pressure and a near-surface thermal gradient of 31 ± 15 degrees Celsius per kilometre2, 3. At temperatures above 300–450 degrees Celsius, usually found at depths greater than 10–15 kilometres, the intra-crystalline plasticity of quartz and feldspar relieves stress by aseismic creep and earthquakes are infrequent. Hydrothermal conditions control the stability of mineral phases and hence frictional–mechanical processes associated with earthquake rupture cycles, but there are few temperature and fluid pressure data from active plate-bounding faults. Here we report results from a borehole drilled into the upper part of the Alpine Fault, which is late in its cycle of stress accumulation and expected to rupture in a magnitude 8 earthquake in the coming decades4, 5. The borehole (depth 893 metres) revealed a pore fluid pressure gradient exceeding 9 ± 1 per cent above hydrostatic levels and an average geothermal gradient of 125 ± 55 degrees Celsius per kilometre within the hanging wall of the fault. These extreme hydrothermal conditions result from rapid fault movement, which transports rock and heat from depth, and topographically driven fluid movement that concentrates heat into valleys. Shear heating may occur within the fault but is not required to explain our observations. Our data and models show that highly anomalous fluid pressure and temperature gradients in the upper part of the seismogenic zone can be created by positive feedbacks between processes of fault slip, rock fracturing and alteration, and landscape development at plate-bounding faults.
ISSN: 0028-0836

hal-01685757
https://hal.archives-ouvertes.fr/hal-01685757
DOI : 10.1038/nature22355

Éditeur(s) : HAL CCSD American Geophysical Union (AGU)
Résumé : International audience
The Ronda peridotite supplies one of the best objects to document subcontinental mantle deformation, but its internal deformation and exhumation mechanisms remain controversial. Here we provide new structural data and numerical results that constrain the Oligocene-Miocene deformation history of the Ronda massif. We first describe a mantle shear zone in the northern massif that developed subcrustal strain localization during decompression and related partial melting. The deformation regime of this mantle shear zone evolved from penetrative NE-SW stretching to sinistral shear highlighted by discrete shear bands. We then show structural observations that document a viscous deformation in the southern massif occurring prior to the thrust-assisted emplacement of the peridotite during large decompression. Finally, we performed numerical investigations that quantify a high temperature of 980°C for the basal peridotite lens at the time of its crustal emplacement. Our numerical results constrain the timing of ductile deformation of the peridotite just before 22 Ma, probably between 30 and 22 Ma. Altogether, these features led us to conclude that the deformation and exhumation of the Ronda peridotite results from lithosphere thinning subsequently inverted in the course of the Oligocene-Miocene. Among available models, our findings support the hypothesis of peridotite exhumation by the inversion of a thinned back-arc continental lithosphere during westward slab rollback through the Alboran region.
ISSN: 0278-7407

insu-00924180
https://hal-insu.archives-ouvertes.fr/insu-00924180
https://hal-insu.archives-ouvertes.fr/insu-00924180/document
https://hal-insu.archives-ouvertes.fr/insu-00924180/file/tect20062.pdf
DOI : 10.1002/tect.20062

Éditeur(s) : HAL CCSD
Résumé : EGU2012-6377- Geophysical Research Abstracts vol. 14
The hot geothermal fluid produced by the wells of the Bouillante power station, in Guadeloupe, contains various dissolved species such as silica or some metals (Zn, Pb, etc). During the exploitation, the geothermal fluid is flashing and cooling (from 260 to 160°C for the high-pressure steam-liquid separation and down to 110°C for the low-pressure phase separation of a part of the separated liquid at 160°C). Consequently, the dissolved species can form scale deposits such as amorphous silica or poly-metallic sulphides, according to the exploitation conditions, and cause serious scaling problems on the production and the surface installations. These minerals could also precipitate during the partial underground re-injection of the production fluids which is being set up in the Bouillante power station. In this study, in order to predict and prevent the possible silica precipitation at temperature lower than 160°C, during the partial underground reinjection of the production fluids of Bouillante or their thermal valorization down to 110°C temperatures, we propose to investigate on site the kinetics of silica precipitation as a function of temperature and pH. The experiments presented here were carried out on site on samples of separated waters collected after the steam-water separator at 160°C, containing about 600 ppm of SiO2, at four cooling temperatures: 22, 50, 75 and 90°C, and for pH ranging from 4 to 9. These experiments showed that the silica deposition was always initiated by a polymerization mechanism characterized by an order 2 kinetic law and the formation of a white colloidal gel, which slowed down the silica precipitation under solid form. This latter was observed much later, after the polymerization stage, and only in particular conditions (long time of atmospheric exposure, water stagnation,. . . ). The results also confirmed that the silica precipitation kinetics is strongly dependent on pH. In acidic solution, a transition period is observed before the beginning to the silica polymerization. At neutral-basic pH, there is no transition period and the rate of polymerization is maximal for pH close to 8. The undergoing modeling of these experimental data and specific surface area measurements on the colloidal gel will allow us to determinate the kinetics parameters useful for the prediction and prevention of silica precipitation under the specific exploitation conditions of Bouillante power station. This work is financially supported by ADEME (French Agency for Energy and Environment), BRGM and UAG.
EGU General Assembly 2012
Vienne, Austria

hal-00697627
https://hal-brgm.archives-ouvertes.fr/hal-00697627