Éditeur(s) : Elsevier Science Bv
Résumé : We developed a growth model for Crassostrea gigas oyster shells based on the use of in situ temporal manganese markings to calibrate natural cathodoluminescence (CL) changes in the shell hinge sections. A 30 min to 4-h exposure period with Mn2+ (90-120 mg l(-1)) was sufficient to create a detectable mark in the shells. This makes the Mn2+ markings the fastest mollusc shells marking technique to date. The natural CL from juvenile and adult shells cultured in four standard shellfish-farming locations along the English Channel and French Atlantic coasts, exhibited a seasonal pattern (maximum CL intensity occurring during summer periods, minimum CL intensity occurring during winter). Hydrobiological data recorded at Baie des Veys site allows us to attribute the seawater temperature as the main parameter controlling CL of shells. Chlorophyll a and seawater manganese concentration were not decisive in the luminescence intensity of the shells. A relationship between oyster hinge growth and the length of shells makes the umbo investigations a promising tool for oyster-farming and/or wild stock assessments. Shell growth varied at spatial and temporal scales (higher growth rates were observed during summer-autumn and lower during the winter period), depending on seawater temperature changes. Sub-monthly Mn2+ markings support the fact that shell deposition can occur under temperatures below 6 degrees C, which has to be taken into account for both shellfish production and environmental monitoring derived from chemical compositions of the shells. Finally, our results point out the efficiency of age and shell growth rate determination by CL analysis in further shellfish ecosystem researches.
Aquaculture (0044-8486) (Elsevier Science Bv), 2010-02 , Vol. 300 , N. 1-4 , P. 206-217

Droits : 2010 Elsevier B.V. All rights reserved.
http://archimer.ifremer.fr/doc/00002/11300/7912.pdf
DOI:10.1016/j.aquaculture.2009.12.018
http://archimer.ifremer.fr/doc/00002/11300/

Éditeur(s) : HAL CCSD Elsevier
Résumé : International audience
The interplay between fault zone cataclasis and cementation is important since both processes can drastically reduce the permeability of faults in porous sandstones. Yet the prediction of fault cementation in high-porosity sandstone reservoirs remains elusive. Nevertheless, this process has rarely been investigated in shallowly buried faults (<2 km; T°<80 °C) where its sealing capacity could be acquired early in the geological history of a reservoir. In this paper, the macro- and microscopic analysis of a fault zone in the porous Cenomanian quartz arenite sands of Provence (France) shows that silica diagenesis occurs in the most intensely-deformed cataclastic parts of the fault zone. This fault zone shows 19–48% of its total thickness occupied by low-porosity quartz-cemented cataclastic shear bands whose porosities range from 0 – ca. 5%. The analysis of the weathering profile around the fault zone reveals the presence of groundwater silcretes in the form of tabular, tightly silicified concretions cross-cut by the fault. Detailed transmitted light, cold-cathodoluminescence and scanning electron microscopy analyses of the silica cements (from the fault and the silcrete) reveal that all the silica cements originate from groundwater diagenetic processes. This study therefore shows that silica cementation can occur specifically in fault zones and as groundwater silcrete in the shallow context of a groundwater system, generated at the vicinity of an erosional unconformity.
ISSN: 0191-8141

hal-01278286
https://hal.archives-ouvertes.fr/hal-01278286
DOI : 10.1016/j.jsg.2015.10.001