Éditeur(s) : HAL CCSD American Geophysical Union (AGU)
Résumé : International audience
Sandbox modeling is used to study the deformation of accretionary wedges caused by the subduction of oceanic ridges. The first experiment incorporates a massive ridge within a sand wedge. The wedge thickens and shortens when the forward propagation of the basal decollement ceases. The wedge thickening results in taper change, reactivation of preexisting thrusts, and retreat of the frontal part of the sand wedge. Similar mechanisms may have affected some margins that have undergone ridge subduction such as the Tonga margin after the subduction of the oblique Louisville oceanic ridge. The second experiment shows the effects of an active basement thrust slice as it enters a subduction zone. This process may have happened in the eastern Nankai accretionary wedge. Initially, the wedge in this experiment behaved similarly to that of the first experiment. Rapidly the topographic slope changed, the wedge thickened above the basement slice generating a slope break in the topography; a deeper propagating accretionary wedge again characterized by a small taper developed. These results, when compared with observations made in the Eastern Nankai Trench, are in agreement with the past subduction of a basement thrust slice in this area.
ISSN: 0278-7407

hal-01261549
https://hal.archives-ouvertes.fr/hal-01261549
https://hal.archives-ouvertes.fr/hal-01261549/document
https://hal.archives-ouvertes.fr/hal-01261549/file/Lallemand_et_al-1992-Tectonics.pdf
DOI : 10.1029/92TC00637

Éditeur(s) : HAL CCSD Wiley-Blackwell
Résumé : International audience
We surveyed the junction between the central and southern Philippine Trench and the Sangihe Trench near 6øN using swath bathymetry, gravity, and magnetics. These data, along with seismicity, allow us to discuss the genetic relations between these trenches and the forces acting on converging plates. Our final model favors the northern extension of the Halmahera Arc up to 8øN, with three segments offset left-laterally along NW-SE transform faults. Accretion of the northern segment to Mindanao Island 4 to 5 m.y. ago resulted in the failure within the Philippine Sea Plate east of the arc. Initiation of the Philippine Trench between 7øN and 10øN agrees with the maximum recorded depth of the Philippine Trench floor (10,000 m below sea-level) and Philippine Sea slab (200 km). South of 6øN (trench junction), another segment of the arc is being subducted beneath the Sangihe margin, while south of 3øN, the southern segment of the Halmahera Arc is still active. The rapid southward shallowing of the trench floor along the southern Philippine Trench, the type of faulting affecting both sides of the trench, the lack of significant interplate seismicity, and the concentration of the seismicity beneath the Miangas-Talaud Ridge are interpreted as a slowing down of the subduction along this branch of the Philippine Trench compared with the rest of the subduction zone. The Sangihe deformation front has been recognized up to 7øN but seems active only south of 6øN.
ISSN: 2169-9275

hal-01261614
https://hal.archives-ouvertes.fr/hal-01261614
https://hal.archives-ouvertes.fr/hal-01261614/document
https://hal.archives-ouvertes.fr/hal-01261614/file/lallemandJGR1998.pdf

Éditeur(s) : HAL CCSD
Résumé : Le second et présent volume rappelle tout d'abord les indices à notre disposition d'une érosion tectonique potentielle et examine ensuite les conséquences de l'érosion tectonique. Il s'agit principalement d'un travail bibliographique tendant à répondre aux différentes questions que je me suis posé au cours de ces 5 dernières années. Il servira de rame à mes futures recherches.
https://tel.archives-ouvertes.fr/tel-01261323

tel-01261323
https://tel.archives-ouvertes.fr/tel-01261323
https://tel.archives-ouvertes.fr/tel-01261323/document
https://tel.archives-ouvertes.fr/tel-01261323/file/Lallemand_HDR_1992.pdf

Éditeur(s) : HAL CCSD American Geophysical Union
Résumé : International audience
Based on observations from both modem convergent margins and sandbox modeling, we examine the possible conditions favoring frontal accretion and/or frontal and basal tectonic erosion. Mean characteristic parameters (!.t, !.t* • and [) are used to discuss the mechanical stability of 28 transects across the frontal part of convergent margins where the Coulomb theory is applicable. Natural observations reveal that "typical accretionary wedges" are characterized by low tapers with smooth surface slope and subducting plate, low convergence rates and thick trench sediment, while "nonaccretionary wedges" display large tapers with irregular surface slopes and rough subducting plate, high convergence rates and almost no trench fill. Sandbox experiments were performed to illustrate the effects of seamounts/ridges in the subduction zone on the deformation of an accretionary wedge. These experiments show that a wedge of sand is first trapped and pushed in front of the seamount which acts as a moving bulldozer. This is followed by a tunnelling effect of the subducting seamount through the frontal wedge material, which results in considerable sand reworking. At an advanced subduction stage, the d6collement jumps back from a high level in the wedge to its former basal position. We conclude that a high trench sedimentation rate relative to the convergence rate leads to frontal accretion. In contrast, several conditions may favor tectonic erosion of the upper plate. First, oceanic features, such as grabens, seamounts or ridges, may trap upper plate material during their subduction process. Second, destabilization of the upper plate material by internal fluid overpressuring causing hydrofracturing is probably another important mechanism.
ISSN: 0148-0227

hal-01261600
https://hal.archives-ouvertes.fr/hal-01261600
https://hal.archives-ouvertes.fr/hal-01261600/document
https://hal.archives-ouvertes.fr/hal-01261600/file/lallemandJGR1994.pdf

Éditeur(s) : HAL CCSD American Geophysical Union
Résumé : International audience
Giant earthquake (moment magnitude M-w >= 8.5) forecasts for subduction zones have been empirically related to both tectonic stresses and geometrical irregularities along the subduction interface. Both of these controls have been suggested as able to tune the ability of rupture to propagate laterally and, in turn, exert an important control on giant earthquake generation. Here we test these hypotheses, and their combined influence, by compiling a dataset of trench fill thickness (a proxy for smoothing of subducting plate relief by sediment input into the subduction channel) and upper plate strain (a proxy for the tectonic stresses applied to the subduction interface) for 44 segments of the global subduction network. We statistically compare relationships between upper plate strain, trench sediment thickness and maximal earthquake magnitude. We find that the combination of both large trench fill (>= 1 km) and neutral upper plate strain explains spatial patterns of giant earthquake occurrence to a statistically significant degree. In fact, the concert of these two factors is more highly correlated with giant earthquake occurrence than either factor on its own. Less frequent giant earthquakes of lower magnitude are also possible at subduction zones with thinner trench fill and compressive upper plate strain. Extensional upper plate strain and trench fill < 0.5 km appear to be unfavorable conditions, as giant earthquakes have not been observed in these geodynamical environments during the last 111 years. Citation: Heuret, A., C. P. Conrad, F. Funiciello, S. Lallemand, and L. Sandri (2012), Relation between subduction megathrust earthquakes, trench sediment thickness and upper plate strain, Geophys. Res. Lett., 39, L05304, doi: 10.1029/2011GL050712.
ISSN: 0094-8276

hal-00745636
https://hal.archives-ouvertes.fr/hal-00745636
https://hal.archives-ouvertes.fr/hal-00745636/document
https://hal.archives-ouvertes.fr/hal-00745636/file/heuretGRL2012.pdf
DOI : 10.1029/2011GL050712

Éditeur(s) : HAL CCSD American Geophysical Union
Résumé : International audience
We propose in this paper an original method for quantifying the material losses at subduction zones mainly based on vertical movements of the active margins. We first test the method, using isostatic and elastic models, applying it to 15 different well-constrained convergent margins. The main conclusion is that most of them are presently close to the isostatic equilibrium. Consequently, we consider as a first hypothesis that such was also the case in the past and that erosion or accretion are natural mechanisms restoring the equilibrium in response to a perturbation. Then, we apply this model to compute the geometry of the palcoslab knowing the palcotopography of the margin. The comparison between present and past ocean margin lithospheric wedge geometries provides estimates of the removed material that constituted the initial wedge. Two cases were studied for palcoreconstructions: Japan and Peru. The results show that a considerable amount of material was removed during the Neogene along both margins. A detailed interpretation of the Neogene history of the Japan margin is proposed on the basis of our results.
ISSN: 0148-0227

hal-01261647
https://hal.archives-ouvertes.fr/hal-01261647
https://hal.archives-ouvertes.fr/hal-01261647/document
https://hal.archives-ouvertes.fr/hal-01261647/file/lallemanJGR1992.pdf
DOI : 10.1029/91JB02342

Éditeur(s) : HAL CCSD American Geophysical Union (AGU)
Résumé : International audience
Sandbox experiments, using a two-dimensional and a three-dimensional approach, are used to study the deformation of margins in response to seamount subduction. Successive mechanisms of deformation are activated during the subduction of conical seamounts. First, reactivation of the frontal thrusts and compaction of the accretionary wedge is observed. Then, back thrusting and, conjugate strike-slip faulting develops above the leading slope of the subducted seamount. The basal d6collement is deflected upward in the wake of the subducting high, and a large shadow zone develops behind the seamount trailing slope. Consequently, frontal accretion is inhibited and part of the frontal margin is dragged into the subduction zone. When the main d6collement returns to its basal level in the wake of the seamount, the margin records a rapid subsidence and a new accretionary wedge develops, closing the margin reentrant. The sediments underthrusted in the wake of the seamount into the shadow zone, are underplated beneath the rear part of the accretionary wedge. Substantial shortening and thickening of the deformable seaward termination of the upper plate basement, associated with basal erosion is observed. Seamount subduction induces significant material transfer within the accretionary wedge, favors large tectonic erosion of the frontal margin and thickening of the rear part of the margin. The subduction and underplating of relatively undeformed, water-ladden sediments, associated with fluid expulsion along the fractures affecting the margin could modify the fluid pressure along the basal ddcollement. Consequently, significant variations of the effective basal friction and local mechanical coupling between the two plates could be expected around the subducting seamount.
ISSN: 0278-7407

hal-01261523
https://hal.archives-ouvertes.fr/hal-01261523
https://hal.archives-ouvertes.fr/hal-01261523/document
https://hal.archives-ouvertes.fr/hal-01261523/file/Dominguez2000-Tectonics.pdf
DOI : 10.1029/1999TC900055

Éditeur(s) : HAL CCSD Wiley-Blackwell
Résumé : International audience
We explore the tectono-magmatic processes in the western West Philippine Basin, Philippine Sea Plate, using bathymetric data acquired in 2003 and 2004. The northwestern part of the basin formed through a series of northwestward propagating rifts. We identify at least five sequences of propagating rifts, probably triggered by mantle flow away from the mantle thermal anomaly that is responsible for the origin of the Benham and Urdenata plateaus. Gravitational forces caused by along-axis topographic gradient and a ∼30° ridge reorientation appear to also be driving the rift propagations. The along-axis mantle flow appears to be reduced and deflected along the Luzon-Okinawa fracture zone, because the spreading system remained stable west of this major fault zone. North-east of the Benham plateau, a left-lateral fracture zone has turned into a NE–SW-trending spreading axis. As a result, a microplate developed at the triple junction.
ISSN: 0954-4879

insu-00304360
https://hal-insu.archives-ouvertes.fr/insu-00304360
DOI : 10.1111/j.1365-3121.2008.00824.x