Éditeur(s) : HAL CCSD Elsevier
Résumé : International audience
A set of four reactive flow-through experiments at temperature T = 100 degrees C and total pressure P=12 MPa was performed in limestone reservoir samples. By using various ranging from 0.7 to 10 MPa, these experiments mimic mass transfers occurring (1) near the injection well, where the brine is almost saturated with CO2 (i.e. P-CO2 approximate to P), and (2) at increasing distances from the injection well, where the fluid displays lower values and higher divalent cation concentrations due rock dissolution along the fluid pathway. Results for P-CO2 = 10 MPa show non-uniform dissolution features associated with transport-controlled mass transfer, while reaction-controlled uniform dissolution is observed for P-CO2 = 2.5 MPa. The experiment with P-CO2 = 6 MPa allows investigating in detail the transition from transport-to reaction-controlled dissolution. Conversely, the experiment reproducing conditions far from the injection well (P-CO2 = 0.7 MPa), shows a decrease of porosity triggered by the precipitation of Mg-rich calcite. For all the dissolution experiments, the time-resolved porosity phi(t) can be modeled by a simple non-linear equation including parameters that characterise the dissolution regime triggered by the reactivity of the inlet fluid (measured by the Damkohler number, Da). Furthermore, all dissolution experiments display power scaling between permeability (k) and porosity (phi) with distinctly different scaling exponents characterising the reactivity of the fluid percolating the sample, independently from the decrease with time of the reactive surface area. It is shown also that dissolution at moderate positive values of Da seems the most efficient to increase permeability and promote a rapid spreading of the reaction front, while inducing minimal modification of the porosity in the vicinity of the CO2 injection well. These results can be used to parameterize the k-phi function for modeling the earliest dissolution processes occurring in the vicinity of the reaction front.
ISSN: 0009-2541

hal-00445277
https://hal.archives-ouvertes.fr/hal-00445277
DOI : 10.1016/j.chemgeo.2009.03.028

Éditeur(s) : HAL CCSD
Résumé : In order to minimize CO2 atmospheric concentration, a solution consists in sequestrating CO2 in geological reservoirs. To estimate long term risks, it is necessary to quantify the couplings between reaction processes as well as structural and hydrodynamical modifications. We realised two experimental benches enabling injecting CO2-enriched-brine in conditions corresponding to in situ storage (T < 200 oC and P < 200 bar) and developed
an experimental protocol using X-Ray microtomography and fluid and rock analyses in order to measure the variations of physical and chemical parameters.
The study of carbonated reservoirs near the injection well, allows quantifying different k-phi relationships depending on the dissolution processes and triggered by the local fluid chemical composition and initials conditions. Away from the injection well, we observe carbonate precipitation decreasing the permeability. The study of fracturated caprock samples shows that alternative percolation of CO2-enriched-brine and CO2 gas increases the fracture permeability.
The study of silicated rocks indicates carbonate precipitation in zeolite sandstone and sintered dunite grains. Nevertheless, in zeolite sandstone we also observe the precipitation of clay particles located in the uid pathways which decrease strongly the permeability.
Afin de minimiser la concentration en CO2 dans l'atmosphère une solution consiste à le séquestrer dans les réservoirs géologiques. Pour évaluer les risques à long terme, il est nécessaire de quantifier les couplages entre les processus réactionnels et les modifications structurales et hydrodynamiques. Dans cette optique, nous avons construit deux dispositifs expérimentaux permettant d'injecter des saumures chargées en CO2 dans les conditions de stockage (T < 200 °C et P < 200 bar) et mis en oeuvre un protocole expérimental utilisant la microtomographie RX et l'analyse des roches et des fuides pour quantifier les variations des paramètres physiques et chimiques. Dans le cas des réservoirs carbonatés, on observe, près du puits d'injection, une forte variabilité des relations k-phi en fonction du régime de dissolution contrôlé par la chimie locale du fluide, ainsi que par les conditions initiales. A plus grande distance, on observe des processus de précipitation diminuant fortement la perméabilité. L'étude des roches de couverture fracturées (argilite) a montré qu'une percolation alternée d'une saumure chargée en CO2 et de CO2 gaz augmentait la perméabilité de fracture. Dans le cas des roches silicatées, la précipitation de carbonates est mise en évidence aussi bien dans les grès à zéolites que dans les frittés de dunite de San Carlos. Cependant, dans les grès à zéolites, la précipitation d'une phase argileuse est observée dans les chemins d'écoulement et engendre une forte diminution de la perméabilité.
https://tel.archives-ouvertes.fr/tel-00416408

tel-00416408
https://tel.archives-ouvertes.fr/tel-00416408
https://tel.archives-ouvertes.fr/tel-00416408/document
https://tel.archives-ouvertes.fr/tel-00416408/file/These_Luquot.pdf

Éditeur(s) : HAL CCSD Elsevier
Résumé : International audience
We describe an experimental system including monitoring of temperature, pressure, pH, oxidation reduction potential and optical density at 600 nm, designed for studying the role of microorganisms on the geological sequestration Of CO2 and its transformation into solid carbonate phases. Measurements were performed in an artificial ground water (AGW) supplemented with urea (2 g.l(-1)) and equilibrated at controlled temperatures with a gaseous phase before bacterial inoculation. We used the ureolytic strain Bacillus pasteurii as a model carbonate precipitating bacteria and showed that it can successfully promote strong pH increases by ureolysis in the AGW equilibrated with CO2 pressures of up to I bar. Increasing salinities (5.8,13.5 and 35.0 g.l(-1)) have a positive effect on the rate of pH increase, whereas the effect of increasing temperatures (30,35 and 38 degrees C) is less important. Calcium is also shown to have a specific positive influence on the rate of ureolysis. The number of viable cells present in solution decreases greatly during the carbonate precipitation event but the population partially recovers once precipitation is over.
ISSN: 0009-2541

hal-00445282
https://hal.archives-ouvertes.fr/hal-00445282
DOI : 10.1016/j.chemgeo.2008.12.012

Éditeur(s) : HAL CCSD American Chemical Society
Résumé : International audience
Carbonation of ultramafic rocks in geological reservoirs is, in theory, the most efficient way to trap CO2 irreversibly; however, possible feedback effects between carbonation reactions and changes in the reservoir permeability must be considered to realistically assess the efficiency and sustainability of this process. We investigated changes in the hydrodynamic properties of sintered dunite samples by means of percolation experiments, under conditions analogous to that of in situ carbonation. Our results show that carbonation efficiency is controlled by the local renewal of the reactants and the heterogeneity of the pore structure. Preferential flow zones are characterized by the formation of magnetite and of a silica-rich layer at the olivine surfaces, which eventually inhibits olivine dissolution. Conversely, sustainable olivine dissolution together with coprecipitation of magnesite, siderite, and minor Mg-TOT-phyllosilicates, occur in reduced-flow zones. Thus carbonate precipitation only decreases porosity in zones where diffusion-controlled transport is dominant. Consequently, while high flow rates will decrease the carbonation efficiency of the reservoir and low flow rates may reduce the permeability irreversibly close to the injection point, moderate injection rates will ensure a partial carbonation of the rock and maintain the reservoir permeability.
ISSN: 0013-936X

hal-00424540
https://hal.archives-ouvertes.fr/hal-00424540
DOI : 10.1021/es8018429

Éditeur(s) : HAL CCSD
Résumé : International audience
The injection of reactive mineral suspensions is a possible process to either reinforce or seal wells in geologic carbon sequestration sites. Among others, olivine slurries could be used as CO2-triggered cements, as they carbonate under the thermodynamic conditions of deep storage. However, injection of such slurries requires to control their initial fluidity and its evolution during the displacement. For this purpose, we have characterized the rheological evolution of olivine suspensions, of particle sizes 1−10 μm, sheared at 100 s−1, in the ranges of 10−40% for the volume fractions, 20−50 bars for the CO2 pressure, and 60-110°C for the temperature. The apparent viscosity, measured at 100 s−1, increases exponentially, with a characteristic time ranging from less than 1 h to more than 10 h, and decreasing with olivine concentration, CO2 pressure, and temperature. Moreover, a careful characterization of the slurry rheology carried out in the initial stages of slow evolution, shows that the slurry obeys a Bingham plastic law, with a yield stress ΣB, and a Bingham viscosity µB increasing from 1 to 20 Pa and from 4 to 110 mPa s, respectively, when the olivine volume fraction φ is increased from 10 to 30%. Such variations can be accounted by classical models (Wildemuth and Williams [1984]: Rheologica Acta, 23,627-635, Krieger [1972]: Advances in Colloid and Interface Science, 3, 111-136).
Environmental Progress & Sustainable Energy

hal-01054131
https://hal.archives-ouvertes.fr/hal-01054131
DOI : 10.1002/ep.11826

Éditeur(s) : HAL CCSD American Chemical Society
Résumé : Experiments were conducted to assess the potential impact of fractured well-cement degradation on leakage rate. Permeability was monitored while CO2-enriched reservoir-equilibrated brine was flowed at constant rate through a single fracture in a class G cement core under conditions mimicking geologic sequestration environments (temperature 60 °C, pressure 10 MPa). The results demonstrate that, at least for the conditions used in the experiment, an initial leakage in a 42 μm aperture fracture (permeability = 1.5 × 10-10 m2) can be self-mitigated due to the decrease of the fracture hydraulic aperture after about 15 h. This decrease results from the development of continuous highly hydrated amorphous Si-rich alteration products at the edge of the fracture and the dense carbonation of the bulk cement that mitigate the penetration of the alteration front.
ISSN: 0013-936X

hal-00950088
https://hal.archives-ouvertes.fr/hal-00950088
DOI : 10.1021/es401317c

Éditeur(s) : HAL CCSD
Résumé : International audience
The carbon capture and storage is considered as one of the solutions of reducing the effects of global warming. It consists in injecting large quantities of CO 2 in supercritical form directly into deeply located geological formations. One of the methods involves sequestration in the carbonate sedimentary rocks (sandstones and limestones) which are considered as a promising solution. The morphology of the pore network and solid skeleton defines important macroscopic prop-erties of the rock (permeability, stiffness). Modelling at micro scale of random heterogeneous materials (porous media) should be based on morphological and statistical characterisation 1,2 of the investigated microstructure. The work is focused on a reconstruction method by grains deposit 3 , for various range of pa-rameters, to obtain equivalent model of natural rock samples (oolitic limestone and fontainebleau sandstone). Generated samples satisfy morphological and statistical informations 4 which were obtained by 3D image analysis of X-ray tomography of the natural rock samples. For validation of the modelling numerical computations of mechanical and transfer properties are also provided.
14th European Mechanics of Materials Conference - EMMC14
Gothembourg, Sweden

hal-01103163
https://hal.archives-ouvertes.fr/hal-01103163