Éditeur(s) : HAL CCSD Elsevier
Résumé : International audience
We review the evolution of concepts on and methods of estimating the state of stress from fault movements. Theories of failure in isotropic materials suggested a simple geometrical construction of optimal principal stress directions from a fault plane and its associated slip. These optimal directions align shear stress and slip directions and maximize the difference between shear stress and frictional resistance on the fault plane. Optimal stress directions for calcite twinning are obtained by a similar construction, with the difference that they maximize shear stress. Force representation of seismic sources independently introduced pressure, P, and tension, T, axes at positions that also maximize shear stress on both nodal planes. Frictional slip theory and the constraint that slip and shear stress directions be parallel allowed to address reactivation of pre-existing faults. This suggested that stress could also be inverted from reactivated fault and slip data or earthquake focal mechanisms. Early methods relied on geometrical constructions as a substitute for calculations, whereas later methods relied on software as these calculations became tractable with the help of computers. Similar methods were developed for the inversion of stress from crystal twin gliding with non-optimal geometry, with a different criterion that relies on a threshold of the component of shear stress along the gliding line. Even though these methods seek a common stress tensor compatible with fault and slip data, their main use is to separate polyphase data into homogeneous subsets and help deciphering complex tectonic histories. Fault and slip data can also be analyzed to constrain the strain rather than the stress tensor. In most cases this involves a summation and yields an average strain for the considered rock volume. Stress inversion thus appears better suited for differentiating heterogeneous data whereas strain analysis appears better suited for homogenizing them.
ISSN: 0040-1951

hal-00759043
https://hal.archives-ouvertes.fr/hal-00759043
DOI : 10.1016/j.tecto.2012.02.009

Éditeur(s) : HAL CCSD Oxford University Press (OUP): Policy P - Oxford Open Option A Oxford University Press (OUP)
Résumé : International audience
The Pyrenean mountain range is a slowly deforming belt with continuous and moderate seismic activity. To quantify its deformation field, we present the velocity field estimated from a GPS survey of the Pyrenees spanning 18 yr. The PotSis and ResPyr networks, including a total of 85 GPS sites, were installed and first measured in 1992 and 1995–1997, respectively, and remeasured in 2008 and 2010. We obtain a deformation field with velocities less than 1 mm yr−1 across the range. The estimated velocities for individual stations do not differ significantly from zero with 95 per cent confidence. Even so, we estimate a maximum extensional horizontal strain rate of 2.0 ± 1.7 nanostrain per year in a N–S direction in the western part of the range. We do not interpret the vertical displacements due to their large uncertainties. In order to compare the horizontal strain rates with the seismic activity, we analyse a set of 194 focal mechanisms using three methods: (i) the ‘r’ factor relating their P and T axes, (ii) the stress tensors obtained by fault slip inversion and (iii) the strain-rate tensors. Stress and strain-rate tensors are estimated for: (i) the whole data set, (ii) the eastern and western parts of the range separately, and (iii) eight zones, which are defined based on the seismicity and the tectonic patterns of the Pyrenees. Each of these analyses reveals a lateral variation of the deformation style from compression and extension in the east to extension and strike-slip in the west of the range. Although the horizontal components of the strain-rate tensors estimated from the seismic data are slightly smaller in magnitude than those computed from the GPS velocity field, they are consistent within the 2σ uncertainties. Furthermore, the orientations of their principal axes agree with the mapped active faults.
ISSN: 0956-540X

hal-01171752
https://hal.archives-ouvertes.fr/hal-01171752
DOI : 10.1093/gji/ggv052

Éditeur(s) : HAL CCSD Elsevier
Résumé : International audience
In petroleum industry, the difference between pore pressure (Pp) and minimum horizontal stress Sh (termed the seal or retention capacity) is of major consideration because it is often assumed to represent how close a system is to hydraulic failure and thus the maximum hydrocarbon column height that can be maintained. While Sh and Pp are often considered to be independent parameters, several studies in the last decade have demonstrated that Sh and Pp are in fact coupled. However, the nature of this coupling relationship remains poorly understood. In this paper, we explore the influences of the spatial pore pressure distribution on Sh/Pp coupling and then on failure pressure predictions and trap integrity evaluation. With analytical models, we predict the fluid pressure sustainable within a reservoir before failure of its overpressured shale cover. We verify our analytical predictions with experiments involving analogue materials and fluids. We show that hydraulic fracturing and seal breach occur for fluid pressure greater than it would be expected from conventional retention capacity. This can be explained by the impact of the fluid overpressure field in the overburden and the pressure diffusion around the reservoir on the principal stresses. We calculate that supralithostatic pressure could locally be reached in overpressured covers. We also define the retention capacity of a cover (RC) surrounding a fluid source or reservoir as the difference between the failure pressure and the fluid overpressure prevailing in shale at the same depth. In response to a localized fluid pressure rise, we show that the retention capacity does not only depend on the pore fluid overpressure of the overburden but also on the tensile strength of the cover, its Poisson's ratio, and the depth and width of the fluid source.
ISSN: 0264-8172

hal-00590497
https://hal.archives-ouvertes.fr/hal-00590497
DOI : 10.1016/j.marpetgeo.2010.08.007

Éditeur(s) : HAL CCSD Springer
Résumé : International audience
Thermoelastic behavior of different marble types was analyzed using computational modeling and experimental measurements. Eight marble samples with different composition, grain size, grain boundary geometry, and texture were investigated. Calcitic and dolomitic marbles were considered. The average grain size varies from 75 μm to 1.75 mm; grain boundary geometry differs from nearly equigranular straight grain boundaries to inequigranular-interlobate grain boundaries. Four typical marble texture types were observed by EBSD measurements: weak texture; strong texture; girdle texture and high-temperature texture. These crystallographic orientations were used in conjunction with microstructure-based finite element analysis to compute the thermoelastic responses of marble upon heating. Microstructural response maps highlight regions and conditions in the marble fabric that are susceptible to degradation phenomena. This behavior was compared to the measured thermal expansion behavior, which shows increasing residual strains upon repetitive heating-cooling cycles. The thermal expansion behavior as a function of temperature changes can be classified into four categories: (a) isotropic thermal expansion with small or no residual strain; (b) anisotropic thermal expansion with small or no residual strain; (c) isotropic thermal expansion with a residual strain; and (d) anisotropic thermal expansion with residual strain. Thermal expansion coefficients were calculated for both simulated and experimental data and also modeled from the texture using the MTEX software. Fabric parameters control the amount and directional dependence of the thermal expansion. Marbles with strong texture show higher directional dependence of the thermal expansion coefficients and have smaller microstructural values of the maximum principal stress and strain energy density, the main precursors of microcracking throughout the marble fabric. In contrast, marbles with weak texture show isotropic thermal expansion behavior, have a higher propensity to microcracking, and exhibit higher values of maximum principal stress and strain energy density. Good agreement between the experimental and computational results is observed, demonstrating that microstructure-based finite-element simulations are an excellent tool for elucidating influences of rock fabric on thermoelastic behavior.
ISSN: 1866-6280

hal-00858095
https://hal.archives-ouvertes.fr/hal-00858095
DOI : 10.1007/s12665-013-2406-z

Éditeur(s) : HAL CCSD American Geophysical Union
Résumé : International audience
This paper investigates the orientation and sources of stress in the forearc of the Cascadia subduction zone in southwest British Columbia, using Bayesian inversion results from focal mechanism data and comparing results with GPS derived short-term strain rates. The subduction margin in this region includes a change in orientation from N-S in Washington State to NW-SE in British Columbia. Over 1000 focal mechanisms from North American crustal earthquakes have been calculated to identify the dominant style of faulting, and ∼600 were inverted to estimate the principal stress orientations and the stress ratio. Our results indicate the maximum horizontal compressive stress orientation changes with distance to the trench, from approximately margin-normal along the coast to approximately margin-parallel 100-150 km inland from the coast. Comparing stress orientations with GPS data, we relate the margin-normal stress direction to subduction-related strain rates due to the locked interface between the North American and Juan de Fuca plates just west of Vancouver Island. Further from the margin the plates are coupled less strongly, and the margin-parallel maximum horizontal compressive stress in the North American Plate relates to the northward push of the Oregon Block, which is also observed in the horizontal shortening direction of the residual strain rates, after the subduction component is removed.
ISSN: 0148-0227

hal-00853734
https://hal.archives-ouvertes.fr/hal-00853734
DOI : 10.1029/2010JB008003

Éditeur(s) : HAL CCSD
Résumé : Several major earthquakes have struck the 2500 km long Himalayan range during the past century. However, both the maximum size of such earthquakes and the probability of occurrence of a magnitude 9 megaquake are still a mater of debate. In this framework it is of key importance to investigate the lateral segmentation of the Himalayan arc in order to deepen our understanding of the mechanisms that control such events as well as their extents. Besides the remarkably uniform tectonic set-up and the fact that most studies on the Himalayas have focused on Central Nepal, several indications of along strike changes can be gathered.This thesis brings new constraints on lateral variations of crustal structure and of deformation between western Nepal (~80°E) and eastern Bhutan (~92°E).The first part of this thesis focuses on the lateral variations of crustal structure. In the past three years we have carried out four land gravity campaigns. We have established 366 new gravity measurement points to fill the data gaps in central and western Nepal as well as in Bhutan. This new dataset, together with available seismological data, is used to constrain thermo-mechanical models of the bending of the India plate underneath the Himalayas. While the inferred crustal geometry does not exhibit major along-strike variations over central and eastern Nepal, the shorter wavelength flexure of the lithosphere in Bhutan is associated with a weaker upper mantle rheology.The second part focuses on the lateral variations of recent deformation in the Himalayas. Fifteen years of paleoseismological investigations have extended the catalogue of major Himalayan events over the last millennium. Combining these information with secular loading, we assess the spatial and temporal stress changes on the Main Himalayan Thrust along the orogen over the last nine centuries. Our calculations indicate that inter-seismic loading has now nearly overcome the Coulomb stress decrease caused by the great ~1100 medieval earthquake. Our results also point out that the 1897 Shillong plateau earthquake does not have a major influence on the stress accumulated on the Main Himalayan Thrust since then. In order to better characterize active tectonics in the Bhutan Himalayas where no studies were done so far, we carried out a morphotectonic analysis in the south-central part of the kingdom. We show that the same amount of Holocene deformation is accommodated on the frontal thrust in Bhutan as on the neighbouring portions of the Himalayan arc. We also find evidences for two major (M>8) earthquakes on this thrust in the Bhutan Himalayas during the last millennium. Our results therefore show that Bhutan cannot be considered as a seismic gap. They also challenge the interpretation of one single ~1100 medieval mega-event that would have ruptured the Main Frontal Thrust from central Nepal to eastern Bhutan.
Au cours du dernier siècle, plusieurs séismes majeurs ont affecté l'Himalaya. Cependant, la taille maximale de ces événements et la probabilité d'occurrence de méga-séismes avec des magnitudes proches de 9 sont toujours matière à débat. L'étude de la segmentation de l'arc Himalayen est donc primordiale afin de comprendre les mécanismes qui contrôlent ces séismes ainsi que leur extension spatiale. La compréhension du cycle sismique en Himalaya est aujourd'hui essentiellement basée sur des études menées au Népal central, ce qui limite notre connaissance de son fonctionnement tri-dimensionnel. Ce travail de thèse permet d'apporter de nouvelles contraintes sur les variations latérales de la déformation crustale dans la zone comprise entre l'ouest Népal (~80°E) et l'est Bhoutan (~92°E). La première partie de cette thèse est consacrée à l'étude des variations latérales de la structure lithosphérique. Quatre campagnes gravimétriques ont été réalisées entre 2010 et 2012. Elles ont permis d'étendre le réseau gravimétrique Népalais jusqu'à l'ouest Népal et d'établir le premier réseau gravimétrique Bhoutanais. Ce nouveau jeu de données, combiné avec les données sismologiques disponibles, permet de contraindre des modèles thermo-mécaniques de la flexure de la plaque Indienne sous l'Himalaya. Les résultats suggèrent qu'il n'existe pas de variations latérales majeures du comportement mécanique de la lithosphère Indienne entre le centre et l'est Népal contrairement au Bhoutan où une rigidité flexurale plus faible est nécessaire pour expliquer les données.La deuxième partie de cette thèse est consacrée à l'étude des variations latérales des déformations récentes dans le prisme Himalayen. Les études paléosismologiques menées depuis 15 ans en Himalaya ont permis d'étendre le catalogue des événements majeurs sur le dernier millénaire. En intégrant à la fois les contraintes disponibles sur ces séismes majeurs et le chargement séculaire, nous étudions les variations spatiales et temporelles de l'état de contrainte du chevauchemlent Himalayen principal le long de l'arc. Nos calculs montrent que même dans la cas où un méga-séisme se serait produit en ~1100 en Himalaya, le chargement séculaire a quasiment compensé la chute de contrainte associée. Les modèles montrent aussi que le séisme du Shillong ne joue pas un rôle majeur sur les contraintes accumulées sur le chevauchement Himalayen depuis 1897 au niveau du Bhoutan. Enfin, nous présentons les premières contraintes sur la tectonique active au Bhoutan. L'étude morphotectonique réalisée au centre du Sud-Bhoutan a permis de montrer que la majeure partie de la déformation Holocène est accommodée au niveau du front Himalayen, comme au Népal. Nous montrons aussi des évidences de ruptures de surface avec des décalages verticaux de plusieurs mètres associés à deux séismes majeurs sur le dernier millénaire. Ces évidences remettent en cause l'interprétation d'un méga-séisme en ~1100.
https://tel.archives-ouvertes.fr/tel-01002381

NNT : 2013MON20074
tel-01002381
https://tel.archives-ouvertes.fr/tel-01002381
https://tel.archives-ouvertes.fr/tel-01002381/document
https://tel.archives-ouvertes.fr/tel-01002381/file/35970_BERTHET_2013_archivage_cor.pdf