Éditeur(s) : HAL CCSD E Schweizerbart Science Publishers
Résumé : Mafic microgranular enclaves produced by co-mingling between minette and syenite magmas are found in the Piquiri Syenite, southern Brazil. These enclaves were crystallized under upper mantle conditions. K-clinopyroxene and pyrope are among the early-crystallized phases, suggesting an initial pressure around 5GPa. The mineralogy of minettes comprises phenocrysts of magnesium biotite and diopside, occasionally apatite, in a groundmass formed by these minerals plus alkali feldspar. Two types of apatites are observed: (i) euhedral grains, as inclusions or groundmass constituents, and (ii) aciculate crystals formed during undercooling of mafic magma. Substitutional schemes suggested for these apatites are Si ⇆ P in the tetrahedral site, and Sr and LREE replacing Ca. La, Ce, Nd, and Sr concentrations reveal that these elements are extremely enriched in apatite. Partition coefficients between early-crystallized apatites and estimated melt compositions are DLa (11.8 - 30.6), DCe (16.1-33), DNd (12-31) and DSr (5.1-8.2). Apatite concentrates the LREE up to 200 times compared to clinopyroxene, even higher values were determined for ap/mica partitioning. The ap/cpx and ap/mica partition coefficients for undercooled minerals are close to the values determined for the near-liquidus phases, which indicates constant behavior of LREE and Sr between apatite-clinopyroxene-mica parageneses and minette liquids. Furthermore, these partitioning data preclude any chemical diffusion of these elements between minette and syenite magmas during co-mingling.
ISSN: 0935-1221

hal-00407602
https://hal.archives-ouvertes.fr/hal-00407602
DOI : 10.1127/0935-1221/2007/0019-0039

Éditeur(s) : HAL CCSD IOP Publishing
Résumé : The 8th International Comparison of Absolute Gravimeters (ICAG2009) took place at the headquarters of the International Bureau of Weights and Measures (BIPM) from September to October 2009. It was the first ICAG organized as a key comparison in the framework of the CIPM Mutual Recognition Arrangement of the International Committee for Weights and Measures (CIPM MRA) (CIPM 1999). ICAG2009 was composed of a Key Comparison (KC) as defined by the CIPM MRA, organized by the Consultative Committee for Mass and Related Quantities (CCM) and designated as CCM.G-K1. Participating gravimeters and their operators came from national metrology institutes (NMIs) or their designated institutes (DIs) as defined by the CIPM MRA. A Pilot Study (PS) was run in parallel in order to include gravimeters and their operators from other institutes which, while not signatories of the CIPM MRA, nevertheless play important roles in international gravimetry measurements. The aim of the CIPM MRA is to have international acceptance of the measurement capabilities of the participating institutes in various fields of metrology. The results of CCM.G-K1 thus constitute an accurate and consistent gravity reference traceable to the SI (International System of Units), which can be used as the global basis for geodetic, geophysical and metrological observations of gravity. The measurements performed afterwards by the KC participants can be referred to the international metrological reference, i.e. they are SI-traceable. The ICAG2009 was complemented by a number of associated measurements: the Relative Gravity Campaign (RGC2009), high-precision levelling and an accurate gravity survey in support of the BIPM watt balance project. The major measurements took place at the BIPM between July and October 2009. Altogether 24 institutes with 22 absolute gravimeters (one of the 22 AGs was ultimately withdrawn) and nine relative gravimeters participated in the ICAG/RGC campaign. This paper is focused on the absolute gravity campaign. We review the history of the ICAGs and present the organization, data processing and the final results of the ICAG2009. After almost thirty years of hosting eight successive ICAGs, the CIPM decided to transfer the responsibility for piloting the future ICAGs to NMIs, although maintaining a supervisory role through its Consultative Committee for Mass and Related Quantities.
ISSN: 0026-1394

hal-00795520
https://hal.archives-ouvertes.fr/hal-00795520
DOI : 10.1088/0026-1394/49/6/666

Éditeur(s) : HAL CCSD Cambridge University Press (CUP)
Résumé : International audience
ISSN: 1431-9276

hal-00411439
https://hal.archives-ouvertes.fr/hal-00411439

Éditeur(s) : HAL CCSD IOP Publishing
Résumé : We present the results of an inter-laboratory comparison of EPMA analysis at low voltage (5-6 kV) of three monophasic alloy steel samples. The aim of the work was to obtain an estimate of the present situation of low-voltage analysis of steel and identify needs for improvement. EPMA analyses of the samples were conducted by seven participant groups using electron microprobes and scanning electron microscopes of different kind, equipped with wavelength- and/or energy-dispersive X-ray spectrometers, and employing their own methodology of analysis. The results using WDS showed essentially an underestimation of the Cr contents, with relative deviations from the reference values ranging from -0.7 % to -17 %, and an overestimation of Fe and Ni, with relative deviations from the reference composition ranging from -4 % to +30 %, and from +14 % to +42 %, respectively. The relative deviations obtained by using EDS showed larger scatter, ranging from -16 % to +54 % for Cr, -0.4 % to +66 % for Fe and from +13 % to +90 % for Ni. Reasons for the differences observed and the scatter of results are discussed.
ISSN: 1757-8981

hal-00813999
https://hal.archives-ouvertes.fr/hal-00813999
DOI : 10.1088/1757-899X/32/1/012014

Éditeur(s) : HAL CCSD Springer Verlag
Résumé : International audience
A calibration method aimed at converting X-ray intensities into absolute units has been tested in different electron microprobes. The calibration requires measurement of the X-ray peak profile and measurement and calculation of the bremsstrahlung intensity emitted from a reference sample, at the energy of the X-ray line of interest. Specifically, measurements of the U M alpha and M beta lines emitted from UO2 and bremsstrahlung intensities emitted from an Al reference sample have been performed on five different instruments. The aim of the work is to determine to what accuracy X-ray intensities emitted from reference samples of actinide elements are transferable among different electron microprobes (virtual standard). The influence of the focussing geometry and different crystals and proportional counters used is analysed. Strategies to reduce the uncertainties affecting the absolute calibration of the studied lines are discussed.
ISSN: 0026-3672

hal-00411437
https://hal.archives-ouvertes.fr/hal-00411437
DOI : 10.1007/s00604-007-0856-2