Éditeur(s) : Amer Geophysical Union
Résumé : After the January 12, 2010, Haiti earthquake, we deployed a mainly offshore temporary network of seismologic stations around the damaged area. The distribution of the recorded aftershocks, together with morphotectonic observations and mainshock analysis, allow us to constrain a complex fault pattern in the area. Almost all of the aftershocks have a N-S compressive mechanism, and not the expected left-lateral strike-slip mechanism. A first-order slip model of the mainshock shows a N264 degrees E north-dipping plane, with a major left-lateral component and a strong reverse component. As the aftershock distribution is sub-parallel and close to the Enriquillo fault, we assume that although the cause of the catastrophe was not a rupture along the Enriquillo fault, this fault had an important role as a mechanical boundary. The azimuth of the focal planes of the aftershocks are parallel to the north-dipping faults of the Transhaitian Belt, which suggests a triggering of failure on these discontinuities. In the western part, the aftershock distribution reflects the triggering of slip on similar faults, and/or, alternatively, of the south-dipping faults, such the Trois-Baies submarine fault. These observations are in agreement with a model of an oblique collision of an indenter of the oceanic crust of the Southern Peninsula and the sedimentary wedge of the Transhaitian Belt: the rupture occurred on a wrench fault at the rheologic boundary on top of the under-thrusting rigid oceanic block, whereas the aftershocks were the result of the relaxation on the hanging wall along pre-existing discontinuities in the frontal part of the Transhaitian Belt. Citation: Mercier de Lepinay, B., et al. (2011), The 2010 Haiti earthquake: A complex fault pattern constrained by seismologic and tectonic observations, Geophys. Res. Lett., 38, L22305, doi:10.1029/2011GL049799.
Geophysical Research Letters (0094-8276) (Amer Geophysical Union), 2011-11 , Vol. 38 , N. L22305 , P. 7 p.

Droits : 2011 by the American Geophysical Union
http://archimer.ifremer.fr/doc/00054/16557/14071.pdf
DOI:10.1029/2011GL049799
http://archimer.ifremer.fr/doc/00054/16557/

Éditeur(s) : HAL CCSD Elsevier
Résumé : International audience
Mongolia represents the northernmost area affected by the India–Asia collision, and it is actively deformed along transpressive belts closely associated with large-scale strike-slip faults. The active and past mantle flow beneath this region is, however, poorly known. In order to investigate deep mantle deformation beneath central Mongolia and its relation with the surrounding major structures such as the Siberian craton, the Gobi–Altay belt and the Baikal rift, a NS-trending profile of broadband seismic stations has been deployed in the summer 2003 from the southern Siberian craton to the Gobi–Altay range, crossing the entire Hangay dome. Mantle flow is deduced from the splitting of teleseismic shear waves such as SKS phases. In eastern Mongolia, the permanent station ULN in Ulaanbaatar reveals the presence of two anisotropic layers, the upper one being oriented NE–SW, close to the trend of lithospheric structures and the lower one NW–SE, close to the trend of Eurasia absolute plate motion. Along the NS profile in central Mongolia, seismic anisotropy deduced from SKS splitting reveals a homogeneous NW–SE trending structure, fully consistent with the observations made in the Altay–Sayan in western Mongolia. The observed delay times of 1.5 to more than 2.0 s favor consistent mantle flow over large mantle thicknesses. Since the lithosphere is less than 100 km thick beneath central Mongolia and since the observed fast directions are parallel to the trend of the lithospheric structures but also close to the trend of the absolute plate motion, we propose that both the lithosphere and the asthenosphere may join their anisotropic effects beneath central Mongolia to explain the large delay times. Although GPS vectors represent the instantaneous displacement of the Earth's surface and SKS splitting the time and vertical integration of finite strain at depth, we use the opportunity of the dense geodetic measurements available in this region to discuss the anisotropy pattern in term of present-day deformation. In the Eurasia-fixed reference frame, GPS and SKS both depict a similar trend beneath central Mongolia, suggesting a lithospheric block “escaping” toward the east that could orient olivine a-axes in the upper mantle, within a transpressive tectonic regime. A different behaviour is observed in western Mongolia: the GPS vectors trend NS, close to the regional compression direction, whereas the fast SKS directions trend EW, suggesting a tectonic regime close to a mode of axial shortening, generating the development of an EW-trending foliation at depth. We therefore propose that Mongolia is a place where active and frozen lithospheric deformation may add their effects, together with the sublithospheric flow. In the three sources of anisotropy inferred, a fundamental role is played by the Siberian craton that acted as an undeformable core of the continent through time: the frozen Paleozoic and Mesozoic structures wrap around the craton, building up the fast anisotropic direction pattern; the present-day sublithospheric flow induced by the plate motion is likely deflecting around its deep roots; finally, the present-day tectonic regime appears to be controlled by the presence of the craton to the north.
ISSN: 0012-821X

hal-00407853
https://hal.archives-ouvertes.fr/hal-00407853
https://hal.archives-ouvertes.fr/hal-00407853/document
https://hal.archives-ouvertes.fr/hal-00407853/file/Barruol_SKS_Mongolia_EPSL2008_hal.pdf
DOI : 10.1016/j.epsl.2008.07.027

Éditeur(s) : HAL CCSD
Résumé : Poster
We deployed a temporary local seismic network in the North Tanzanian Divergence (NTD) for 6 months in 2007 (35 stations, SEISMOTANZ'07 experiment). The region is characterized by major changes in the magmatic/tectonic nature of the rift, at the place where the eastern branch of the East African Rift enters the Tanzanian craton. More than 200 earthquakes were accurately located south of Lake Manyara.
Iceland in the Central Northern Atlantic : hotspot, sea currents and climate change
Plouzané, France

hal-00482059
http://hal.univ-brest.fr/hal-00482059
http://hal.univ-brest.fr/hal-00482059/document
http://hal.univ-brest.fr/hal-00482059/file/poster_albaric.pdf

Éditeur(s) : HAL CCSD American Geophysical Union
Résumé : International audience
After the January 12, 2010, Haiti earthquake, we deployed a mainly offshore temporary network of seismologic stations around the damaged area. The distribution of the recorded aftershocks, together with morphotectonic observations and mainshock analysis, allow us to constrain a complex fault pattern in the area. Almost all of the aftershocks have a N‐S compressive mechanism, and not the expected left‐lateral strike‐slip mechanism. A first‐order slip model of the mainshock shows a N264°E north‐dipping plane, with a major left‐lateral component and a strong reverse component. As the aftershock distribution is sub‐parallel and close to the Enriquillo fault, we assume that although the cause of the catastrophe was not a rupture along the Enriquillo fault, this fault had an important role as a mechanical boundary. The azimuth of the focal planes of the aftershocks are parallel to the north‐dipping faults of the Transhaitian Belt, which suggests a triggering of failure on these discontinuities. In the western part, the aftershock distribution reflects the triggering of slip on similar faults, and/or, alternatively, of the south‐dipping faults, such the Trois‐Baies submarine fault. These observations are in agreement with a model of an oblique collision of an indenter of the oceanic crust of the Southern Peninsula and the sedimentary wedge of the Transhaitian Belt: the rupture occurred on a wrench fault at the rheologic boundary on top of the under‐thrusting rigid oceanic block, whereas the aftershocks were the result of the relaxation on the hanging wall along pre‐existing discontinuities in the frontal part of the Transhaitian Belt.
ISSN: 0094-8276

insu-00643489
https://hal-insu.archives-ouvertes.fr/insu-00643489
https://hal-insu.archives-ouvertes.fr/insu-00643489/document
https://hal-insu.archives-ouvertes.fr/insu-00643489/file/GRL-haiti.2011.pdf
DOI : 10.1029/2011GL049799

Éditeur(s) : HAL CCSD Elsevier
Résumé : International audience
We report preliminary results of a seismological experiment, SEISMOTANZ'07, which consisted in the deployment of a local network (35 stations) in the East African Rift System (EARS), North Tanzania, during 6 months in 2007. We compare two earthquake sequences (Gelai and Manyara) occurring respectively in the southern end of the Kenya rift and in the North Tanzanian Divergence (NTD). Only distant of 150 km, their triggering mechanisms are different. None of the sequences depicts typical swarm or mainshock-aftershock patterns. They highlight the change in the magmatic/tectonic nature of the rift where the eastern branch of the EARS enters the Tanzanian craton. The similar shape and long-axis of the elongate sequences emphasize the preferred locus of active strain release along NE-SW discontinuities which probably root at depth into steep Proterozoic shear zones. At Gelai, the deformation is dominated by aseismic process involving slow slip on normal fault and dyke intrusion within the upper crust Calais_et_al_2008. The spatial and temporal earthquake distribution indicates a possible correlation between the Gelai crisis and the eruption of the nearby Oldoinyo Lengai volcano. At Manyara, the sequence is more uncommon, revealing a long-lasting seismic activity deepely rooted (20-35 km depth) possibly related to stress loading transmitted laterally. The yield stress envelope modelled from the depth frequency distribution of earthquakes in the NTD is consistent with the presence of a mafic lower crust and further supports the strength increase of the rifted crust from south Kenya to the NTD.
ISSN: 0899-5362

hal-00420599
https://hal.archives-ouvertes.fr/hal-00420599
DOI : 10.1016/j.jafrearsci.2009.09.005

Éditeur(s) : HAL CCSD Landes Bioscience
Résumé : International audience
In 2008 we published the first set of guidelines for standardizing research in autophagy. Since then, research on this topic has continued to accelerate, and many new scientists have entered the field. Our knowledge base and relevant new technologies have also been expanding. Accordingly, it is important to update these guidelines for monitoring autophagy in different organisms. Various reviews have described the range of assays that have been used for this purpose. Nevertheless, there continues to be confusion regarding acceptable methods to measure autophagy, especially in multicellular eukaryotes. A key point that needs to be emphasized is that there is a difference between measurements that monitor the numbers or volume of autophagic elements (e.g., autophagosomes or autolysosomes) at any stage of the autophagic process vs. those that measure flux through the autophagy pathway (i.e., the complete process); thus, a block in macroautophagy that results in autophagosome accumulation needs to be differentiated from stimuli that result in increased autophagic activity, defined as increased autophagy induction coupled with increased delivery to, and degradation within, lysosomes (in most higher eukaryotes and some protists such as Dictyostelium) or the vacuole (in plants and fungi). In other words, it is especially important that investigators new to the field understand that the appearance of more autophagosomes does not necessarily equate with more autophagy. In fact, in many cases, autophagosomes accumulate because of a block in trafficking to lysosomes without a concomitant change in autophagosome biogenesis, whereas an increase in autolysosomes may reflect a reduction in degradative activity. Here, we present a set of guidelines for the selection and interpretation of methods for use by investigators who aim to examine macroautophagy and related processes, as well as for reviewers who need to provide realistic and reasonable critiques of papers that are focused on these processes. These guidelines are not meant to be a formulaic set of rules, because the appropriate assays depend in part on the question being asked and the system being used. In addition, we emphasize that no individual assay is guaranteed to be the most appropriate one in every situation, and we strongly recommend the use of multiple assays to monitor autophagy. In these guidelines, we consider these various methods of assessing autophagy and what information can, or cannot, be obtained from them. Finally, by discussing the merits and limits of particular autophagy assays, we hope to encourage technical innovation in the field.
Autophagy

hal-00735751
https://hal.archives-ouvertes.fr/hal-00735751
PUBMED : 22966490

Éditeur(s) : HAL CCSD AGU and the Geochemical Society
Résumé : International audience
Continental rifts and passive continental margins show fundamental along-axis segmentation patterns that have been attributed to one or a number of different processes: extensional fault geometry, variable stretching along strike, preexisting lithospheric compositional and structural heterogeneities, oblique rifting, and the presence or absence of eruptive volcanic centers. The length and width scales of the rift stage fault-bounded basin systems change during the late evolution of the new plate boundary, and the role of magmatism may increase as rifting progresses to continental rupture. Along obliquely spreading ridges, first-order mid-ocean ridge geometries originate during the synrift stage, indicating an intimate relationship between magma production and transform fault spacing and location. The Gulf of Aden rift is a young ocean basin in which the earliest synrift to breakup structures are well exposed onshore and covered by thin sediment layers offshore. This obliquely spreading rift is considered magma-poor and has several large-offset transforms that originated during late stage rifting and control the first-order axial segmentation of the spreading ridge. Widely spaced geophysical transects of passive margins that produce only isolated 2-D images of crust and uppermost mantle structure are inadequate for evaluation of competing rift evolution models. Using closely spaced new geophysical and geological observations from the Gulf of Aden we show that rift sectors between transforms have a large internal variability over short distances (∼10 km): the ocean-continent transition (OCT) evolves from a narrow magmatic transition to wider zones where continental mantle is probably exhumed. We suggest that this small-scale variability may be explained (1) by the distribution of volcanism and (2) by the along-strike differences in time-averaged extension rate of the oblique rift system. The volcanism may be associated with (1) the long-offset Alula-Fartak Fracture Zone, which may enhance magma production on its younger side, or (2) channeled flow from the Afar plume material along the newly formed OCT and the spreading ridge. Oblique extension and/or hot spot interactions may thereby have a significant control on the styles of rifting and continental breakup and on the evolution of many magma-poor margins.
ISSN: 1525-2027

hal-00504866
https://hal.archives-ouvertes.fr/hal-00504866
https://hal.archives-ouvertes.fr/hal-00504866/document
https://hal.archives-ouvertes.fr/hal-00504866/file/G3-Leroy_al-2010.pdf
DOI : 10.1029/2009GC002963