Éditeur(s) : HAL CCSD
Résumé : National audience
Mass balances are often used to calculate sediment fluxes in sedimentary basins and denudationrates in adjacent topographies on intermediate to long timescales (from a few tens ofthousand to a million years). In this study, we focus on simple Quaternary catchment–alluvial fansystems in the northern Tian Shan Range and its foreland basin to discuss some ideas about sedimentproduction, storage, release, and bypass in relatively short (100 km long) sediment routing systems.Based on a geometrical reconstruction of the fans, we estimated the volumes of sediments exportedout of the range and deposited in its alluvial piedmont during the Middle- Late Pleistocene andthe Holocene. This work shows that the two areas clearly present evidence of a temporary butsignificant storage of sediments during the Pleistocene. These sediments were then excavated anddelivered farther into the foreland basin during the Holocene. The difference between the volumesof materials released from the range and piedmont areas and the volume stored in thecontemporaneous fans downstream indicates that the latter did not trap the whole sediment loadtransported by the rivers. The alluvial fans were bypassed by 27 to 78% of this load toward thedownstream alluvial plain. It implies a major volumetric partitioning of the deposits between thefans and the alluvial plain, with a sedimentation rate about twenty times higher in the fans thanin the plain. However, this volumetric partitioning might only occur during periods with a veryspecific hydrological regime such as the Holocene deglaciation. Eventually, the peculiar sedimentstorage and release pattern within the range and piedmont areas during the Pleistocene and Holocenecomplicates the calculation of mean paleodenudation rates using either sediment budgets or in situproduced cosmogenic nuclides.
Association des Sédimentologistes Français. 15ème congrès français de sédimentologie
Chambéry, France

hal-01252100
https://hal.archives-ouvertes.fr/hal-01252100

Éditeur(s) : HAL CCSD Elsevier
Résumé : International audience
A suite of eclogite xenoliths from the Roberts Victor kimberlite (South Africa) is remarkable for its high abundances of base metal sulfides (BMS; up to 2 modal %). However, while sulfides are nearly ubiquitous in Type I eclogites (garnet > 0.07% Na2O), Type II eclogites (garnet < 0.07% Na2O) systematically lack sulfides. Two different sulfide assemblages are recognised within the Type I xenolith suite. Both populations are polyphase Cu-Ni-Fe sulfides, one characterised by the pyrrhotite (Po) + pentlandite (Pn) + chalcopyrite (Cp) assemblage and the other by the smythite/violarite (Smy/Vi) + (Ni)pyrite (Py) + Cp assemblage. The latter is the most abundant assemblage and reflects the supergene alteration of the "primary" Po + Pn + Cp assemblage. This process overprints the original composition of the sulfides by remobilising elements such as S, Fe, Ni, Se and Te. In the Type I eclogites, BMS occur as inclusions within silicates (garnet and clinopyroxene) and as interstitial grains. No chemical differences were observed between enclosed and interstitial sulfides. However, their relative abundances are correlated, indicating a similar origin. The Po + Pn + Cp assemblage is identical to eclogitic sulfides previously described in some Roberts Victor diamonds. Silicate-enclosed sulfides could appear to be early phases, but they are restricted to the outer parts of the silicate grains, suggesting a late incorporation during partial recrystallisation of silicate phases, induced by fluid-rock percolation-reaction during a metasomatic event. Positive whole-rock correlations between Se and (La/Sm)N⁎ and between Cu and ΣLREEN⁎ indicate a direct link between sulfide content and the enrichment of Mg + incompatible elements in the Type I eclogites, further supporting a metasomatic origin of the sulfide component. Similarly, a negative correlation between ΣLREEN⁎ and Cucpx implies that the metasomatic agent was at least partially composed of S-rich fluid (e.g. H2S, SO2) that reacted with the rock and leached Cu out of the silicates. The coupling between sulfides and LREE in the Type I eclogites, as well as the absence of sulfides and metasomatic features (e.g. unequilibrated grain boundaries, melt pockets, fluid inclusions, phlogopite) in the Type II eclogites, demonstrate that Type II eclogites did not undergo such a metasomatic event and therefore may represent the less-modified protoliths of Type I eclogites.
ISSN: 0009-2541

hal-00903856
https://hal.archives-ouvertes.fr/hal-00903856
DOI : 10.1016/j.chemgeo.2013.06.015

Éditeur(s) : HAL CCSD
Résumé : International audience
Mass balances are often used to calculate sediment fluxes in sedimentary basins and denudationrates in adjacent topographies on intermediate to long timescales (from a few tens ofthousand to a million years). In this study, we focus on simple Quaternary catchment–alluvialfan systems in the northern Tian Shan Range and its foreland basin to discuss some ideasabout sediment production, storage, release, and bypass in relatively short (100 km long) sedimentrouting systems. Based on a geometrical reconstruction of the fans, we estimated thevolumes of sediments exported out of the range and deposited in its alluvial piedmont duringthe Middle-Late Pleistocene and the Holocene. This work shows that the two areas clearlypresent evidence of a temporary but significant storage of sediments during the Pleistocene.These sediments were then excavated and delivered farther into the foreland basin during theHolocene. The difference between the volumes of materials released from the range and piedmontareas and the volume stored in the contemporaneous fans downstream indicates thatthe latter did not trap the whole sediment load transported by the rivers. The alluvial fans werebypassed by 27 to 78% of this load toward the downstream alluvial plain. It implies a majorvolumetric partitioning of the deposits between the fans and the alluvial plain, with a sedimentationrate about twenty times higher in the fans than in the plain. However, this volumetricpartitioning might only occur during periods with a very specific hydrological regime suchas the Holocene deglaciation. Eventually, the peculiar sediment storage and release patternwithin the range and piedmont areas during the Pleistocene and Holocene complicates thecalculation of mean paleodenudation rates using either sediment budgets or in situ producedcosmogenic nuclides.
Source to Sink: a long term perspective of sediment budgets and sources characterization, Abstracts
Rennes, France

insu-01406440
https://hal-insu.archives-ouvertes.fr/insu-01406440

Éditeur(s) : HAL CCSD Elsevier
Résumé : International audience
The Tarim and Junggar basins in central Asia are capped by a thick pile of conglomerates, called the Xiyu Formation, that are commonly linked to a change in climate and/or accelerated uplift near the Plio-Pleistocene boundary. In order to better understand their origin and significance, we carried out a combined structural and magnetostratigraphic study in the Quilitage syncline (southern Tianshan), where the base of the Xiyu conglomerates is observed at both sides of the syncline. A balanced cross-section shows that, even at a local-scale, the base of the Xiyu conglomerates cannot be regarded as a single continuous stratigraphic layer. On the southern flank of the Quilitage syncline, we collected 172 samples collected for magnetostratigraphic dating identify 17 polarity chrons that date the new section from 5.2 to ~ 1.7 Ma and constrain the base of the Xiyu conglomerate here at ~ 1.7 Ma. This is 4.2 Ma younger than the age of the Xiyu previously found on the northern limb of the same syncline. Together with other magnetostratigraphic studies carried out around the Tianshan, our study unambiguously demonstrates that the onset of deposition of the Xiyu conglomerates is diachronous, and that the conglomerates are systematically younger toward the basin. Consequently, the Xiyu Formation should not be considered as a chronostratigraphic marker related to any particular tectonic or climatic event, but is instead a prograding gravel wedge that has prograded over the underthrusting forelands. A synthesis of chronologic and structural results yields progradation rates over the last 10 Ma on the order of ~ 2.0 mm/yr and ~ 3.9 mm/yr south and north of the Tianshan Mountains respectively. These rates are comparable to the shortening rate across the Tianshan range, suggesting that underthrusting is the main factor governing the progradation rate of the Xiyu Formation.
ISSN: 0012-821X

insu-00414151
https://hal-insu.archives-ouvertes.fr/insu-00414151
https://hal-insu.archives-ouvertes.fr/insu-00414151/document
https://hal-insu.archives-ouvertes.fr/insu-00414151/file/Charreau-EPSL-2009.pdf
DOI : 10.1016/j.epsl.2009.07.035

Éditeur(s) : HAL CCSD Elsevier
Résumé : International audience
Secondary migration is defined as the movement of hydrocarbons through relatively permeable rocks from source to trap: a two-phase flow within a porous medium. Depending on the geometry and capillary pressure distributions of carrier beds, secondary migration has both vertical and lateral components. The present paper focuses on that part of the migration where the movement is mainly vertical. Its objective is to propose a description of the dynamics governing the vertical part of secondary migration based on the main physical aspects of two-phase flow in a homogeneous porous medium. The study is illustrated by laboratory observations performed in a vertical, 2-D Hele-Shaw cell filled with a transparent porous medium where the flow of dyed oil invading a wetting fluid is visually observed. These observations help us to understand the effect of buoyant, capillary and viscous forces on the resulting flow, the relative importance of which is characterized by non-dimensional numbers. Extrapolating these observations to natural media, it is proposed that vertical secondary migration can be described as a percolation of disconnected and vertically-elongated stringers. These stringers do not move continuously but as a succession of snap-off and re-feeding events which result in a jerky upward movement. Using parameters characterizing the physical properties of the fluid and of the porous medium, the geometry and the dynamic behavior of the stringers are estimated. The width of stringers occurring during secondary migration in geological media is centimetric and their vertical size ranges from several centimeters to a few meters. An upper limit of the mean upward velocity of stringers is proposed, as well as an estimate of their spatial density and of the minimum, average horizontal distance (decametric) between two stringers. The stringers are sparsely distributed, resulting in a low average oil loss and a high efficiency of the vertical migration process.
ISSN: 0264-8172

hal-00831370
https://hal.archives-ouvertes.fr/hal-00831370
https://hal.archives-ouvertes.fr/hal-00831370/document
https://hal.archives-ouvertes.fr/hal-00831370/file/pekins-V-edited.pdf
DOI : 10.1016/j.marpetgeo.2013.04.020

Éditeur(s) : HAL CCSD AGU and the Geochemical Society
Résumé : International audience
How reliable are shear wave splitting measurements as a means of determining mantle flow direction? This remains a topic of debate, especially in the context of subduction. The answer hinges on whether our current understanding of mineral physics provides enough to accurately translate between seismic observations and mantle deformation. Here, we present an integrated model to simulate strain-history-dependent texture development and estimate resulting shear wave splitting in subduction environments. We do this for a mantle flow model that, in its geometry, approximates the double-sided Molucca Sea subduction system in Eastern Indonesia. We test a single-sided and a double-sided subduction case. Results are compared to recent splitting measurements of this region by Di Leo et al. (2012a). The setting lends itself as a case study, because it is fairly young and, therefore, early textures from the slab's descent from the near surface to the bottom of the mantle transition zone--which we simulate in our models--have not yet been overprinted by subsequent continuous steady state flow. Second, it allows us to test the significance of the double-sided geometry, i.e., the need for a rear barrier to achieve trench-parallel subslab mantle flow. We demonstrate that although a barrier amplifies trench-parallel subslab anisotropy due to mantle flow, it is not necessary to produce trench-parallel fast directions per se. In a simple model of A-type olivine lattice-preferred orientation and one-sided subduction, trench-parallel fast directions are produced by a combination of simple shear and extension through compression and pure shear in the subslab mantle.
ISSN: 1525-2027

hal-01053506
https://hal.archives-ouvertes.fr/hal-01053506
DOI : 10.1002/2013GC005032