Éditeur(s) : HAL CCSD American Geophysical Union
Résumé : International audience
The anisotropic single crystal seismic properties are reviewed in the light of recent experimental and theoretical determinations. Although considerable progress has been made on the determination of single crystal properties, data are still lacking, particularly for the temperature derivatives of transition zone and lower mantle phases. The common types of LPO of olivine, opx and cpx are presented together with their associated seismic properties. It is emphasized that simple seismic symmetry pattern of upper mantle rocks are a direct result of the interaction of olivine, opx and cpx. Using the standard structural frame (X lineation, Z pole to foliation) for typical LPOs of olivine, opx and cpx have the maximum Vp parallel to X, in the XZ plane and parallel to Y respectively. Destructive interference occurs between these minerals and hence P-wave anisotropy should be sensitive to the aggregate composition. For shear wave splitting (dVs) typical olivine and opx LPOs result in similar patterns with the maximum dVs in the YZ plane and the fast split shear wave (Vs1) polarized parallel to the foliation. A typical cpx LPO on the other hand produces destructive interference as the max dVs is close to X. By comparison with experiments and numerical simulations, it is estimated that upper mantle samples have an olivine LPO strength which recorded shear strain gamma of between 0.25 and 2.0. Pyrolite and piclogite models are compared with global transverse isotropic models. The slowly reducing P-wave anisotropy in the first 200 km can be explained by a model with constant composition and LPO strength. The sharp decrease in the observed anisotropy in the global models cannot be explained by the transformation of opx to cpx at 300 km, it is proposed that this decrease is due to a reduction in LPO strength from 200 to 350 km at the base of the lithosphere.
Earth's Deep Interior: Mineral Physics and Tomography From the Atomic Scale to the Global Scale

ISBN : 9780875909752
hal-01391524
http://hal.univ-reunion.fr/hal-01391524
http://hal.univ-reunion.fr/hal-01391524/document
http://hal.univ-reunion.fr/hal-01391524/file/Mainprice_AGUmonog_DM_GB_WBI_2000.pdf

Éditeur(s) : HAL CCSD Elsevier
Résumé : International audience
Geodetic data support a short-term continental deformation localized in faults bounding lithospheric blocks. Whether major "faults" observed at the surface affect the lithospheric mantle and, if so, how strain is distributed are major issues for understanding the mechanical behavior of lithospheric plates. A variety of evidence, from direct observations of deformed peridotites in orogenic massifs, ophiolites, and mantle xenoliths to seismic reflectors and seismic anisotropy beneath major fault zones, consistently supports prolongation of major faults into the lithospheric mantle. This review highlights that many aspects of the lithospheric mantle deformation remain however poorly understood. Coupling between deformation in frictional faults in the uppermost crust and localized shearing in the ductile crust and mantle is required to explain the post-seismic deformation, but mantle viscosities deduced from geodetic data and extrapolated from laboratory experiments are only reconciled if temperatures in the shallow lithospheric mantle are high (> 800 °C at the Moho). Seismic anisotropy, especially shear wave splitting, provides strong evidence for coherent deformation over domains several tens of km wide in the lithospheric mantle beneath major transcurrent faults. Yet it cannot detect narrow strain localization zones or shallowly dipping faults. Seismic profiling images shallow-dipping seismic reflectors in the lithospheric mantle interpreted as the continuation of normal or, less frequently, inverse faults in the mantle. However the nature of these reflectors is poorly understood. There is a large discrepancy between the scale at which deformation processes are studied (a few kilometers, at most, due to the limited size of continuous mantle exposures at the Earth's surface) and the scale inferred for strain localization in the mantle from geophysical observations (tens of kilometers). Combining data on deformation microstructures and crystal preferred orientations in naturally deformed peridotites and seismologic observations allows nevertheless discussing strain localization processes that may play a role on the development of mantle shear zones.
ISSN: 0040-1951

hal-00750314
https://hal.archives-ouvertes.fr/hal-00750314
DOI : 10.1016/j.tecto.2012.06.006

Éditeur(s) : HAL CCSD AGU and the Geochemical Society
Résumé : International audience
How reliable are shear wave splitting measurements as a means of determining mantle flow direction? This remains a topic of debate, especially in the context of subduction. The answer hinges on whether our current understanding of mineral physics provides enough to accurately translate between seismic observations and mantle deformation. Here, we present an integrated model to simulate strain-history-dependent texture development and estimate resulting shear wave splitting in subduction environments. We do this for a mantle flow model that, in its geometry, approximates the double-sided Molucca Sea subduction system in Eastern Indonesia. We test a single-sided and a double-sided subduction case. Results are compared to recent splitting measurements of this region by Di Leo et al. (2012a). The setting lends itself as a case study, because it is fairly young and, therefore, early textures from the slab's descent from the near surface to the bottom of the mantle transition zone--which we simulate in our models--have not yet been overprinted by subsequent continuous steady state flow. Second, it allows us to test the significance of the double-sided geometry, i.e., the need for a rear barrier to achieve trench-parallel subslab mantle flow. We demonstrate that although a barrier amplifies trench-parallel subslab anisotropy due to mantle flow, it is not necessary to produce trench-parallel fast directions per se. In a simple model of A-type olivine lattice-preferred orientation and one-sided subduction, trench-parallel fast directions are produced by a combination of simple shear and extension through compression and pure shear in the subslab mantle.
ISSN: 1525-2027

hal-01053506
https://hal.archives-ouvertes.fr/hal-01053506
DOI : 10.1002/2013GC005032

Éditeur(s) : HAL CCSD
Résumé : International audience
Seismic anisotropy is a ubiquitous feature of the subcontinental mantle. This can be inferred both from direct seismic observations of shear wave splitting from teleseismic shear waves, as well as the petrofabric analyses of mantle nodules from kimberlite pipes. The anisotropy is principally due to the strain-induced lattice preferred orientation (LPO) of olivine. The combined use of these mantle samples, deformation experiments on olivine, and numerical modeling of LPO, provides a critical framework for making inferences about mantle deformation from observed seismic anisotropy. In most cases there is a close correspondence between mantle deformation derived from seismic observations of anisotropy, and crustal deformation, from the Archean to the present. This implies that the mantle plays a major, if not dominant role in continental deformation. No clear evidence is found for a continental asthenospheric decoupling zone, suggesting that continents are probably coupled to general mantle circulation.
Mantle Petrology: Field Observations and high Pressure experimentations: a Tribute to Francis R. (Joe) Boyd

hal-01391514
http://hal.univ-reunion.fr/hal-01391514
http://hal.univ-reunion.fr/hal-01391514/document
http://hal.univ-reunion.fr/hal-01391514/file/Silver_et_al_BoydVolume 1999_hal.pdf

Éditeur(s) : HAL CCSD Seismological Society of America
Résumé : Shear-wave splitting measurements are widely used to analyze orientations of anisotropy. We compare two different shear-wave splitting techniques, which are generally assumed to give similar results. Using a synthetic test, which covers the whole backazimuthal range, we find characteristic differences, however, in fast-axis and delay-time estimates near Null directions between the rotation correlation and the minimum energy method. We show how this difference can be used to identify Null measurements and to determine the quality of the result. This technique is then applied to teleseismic events recorded at station LVZ in northern Scandinavia, for which our method constrains the fast-axis azimuth to be 15° and the delay time 1.1 sec.
ISSN: 0037-1106

hal-00404493
https://hal.archives-ouvertes.fr/hal-00404493
DOI : 10.1785/0120060190

Éditeur(s) : HAL CCSD Springer-Verlag
Résumé : We provide evidence for a plume-like upwelling beneath the Eifel hotspot, Western Germany, by using teleseismic shear-wave splitting to resolve the anisotropy associated with upwelling flow that is spreading laterally into the asthenosphere. The variation in fast-polarization azimuth we find across the Eifel hotspot is explained by a model of slowly upwelling material that is horizontally being deflected or sheared in a parabolic asthenospheric flow (PAF) pattern toward west-southwest, a direction that correlates with Eurasian absolute plate motion. We suggest that the lack of an age progression for Eifel volcanism, which is expected for a fixed-upwelling model, is a result of (1) sporadic volcanism due to a low excess plume temperature and/or varying crustal stresses that periodically relax and facilitate eruption, and (2) complex upwelling flow pathways and/or Late Tertiary changes in the slow Eurasian plate motion. The success of the PAF model in fitting the data is remarkable given the small number of parameters (four) and the consistency with the plate motion direction determined from geology and/or geodesy. This suggests that a predictable mantle-anisotropy pattern may exist also for other hotspots driven by plume-like upwellings, and that splitting can be a useful diagnostic to differentiate between plume-like and alternative sources for mantle hotspots.
Mantle plumes - a multidisciplinary approach

hal-00407986
https://hal.archives-ouvertes.fr/hal-00407986
DOI : 10.1007/978-3-540-68046-8

Éditeur(s) : HAL CCSD Elsevier
Résumé : International audience
Splitting of teleseismic shear waves has been measured in the Appalachians (eastern USA) and the Pyrenees (western Europe) using data recorded by permanent and portable stations. From a comparison of the results, it appears that an interpretation of the recorded seismic anisotropy in terms of geodynamics is not straightforward. Successive geodynamic events have generated structures that may have resulted in a similar pattern of mantle flow and that therefore may have contributed in the development of the recorded anisotropy. Combining geological and geophysical arguments, it appears that the mantle anisotropy measured across the Appalachians and the Pyrenees may not be systematically Appalachian or Pyrenean in age but may be mainly due to a lithospheric structure formed during earlier major tectonic events, i.e. the Grenvillian and the Hercynian orogenies, respectively. We suggest that during major episodes of continent assembly, a pervasive tectonic fabric is developed in the lithospheric mantle. In the subsequent evolution of the continent, this fabric may induce a significant mechanical anisotropy that will drastically influence the mechanical behaviour of the Iithosphere when submitted to new tectonic events.
ISSN: 0031-9201

hal-01389717
http://hal.univ-reunion.fr/hal-01389717
http://hal.univ-reunion.fr/hal-01389717/document
http://hal.univ-reunion.fr/hal-01389717/file/Vauchez_Barruol-PEPI96_hal.pdf
DOI : 10.1016/0031-9201(95)03125-1